Geology ReportsSearch

USGS · 70263884

Implications of physics-based M9 ground motions on liquefaction-induced damage in the Cascadia Subduction Zone: Looking forward and backward

Abstract

Given the likelihood of future M9 Cascadia Subduction Zone (CSZ) earthquakes, various estimates of the resulting, regional ground motions have been made, including a suite of 30 physics-based simulations that reflect key modeling uncertainties. However, because the last CSZ interface rupture occurred in 1700 CE, the shaking expected in such an event is especially uncertain, as are the impacts to the built and living environments. Like other coseismic impacts, soil liquefaction poses a significant threat and must be considered by any scenario study used to inform planning and response, or to focus mitigation resources. Liquefaction is also notable for its potential to “ground truth” ground-motion estimates, given that its presence or absence in the geologic record can provide constraint on the intensities of shaking in past events. It is thus an important phenomenon looking both forward and backward. Accordingly, using recent physics-based simulations, this study (1) predicts liquefaction in M9 CSZ ruptures at 400 locations in Oregon, Washington, and British Columbia (BC) using an array of cone-penetration-test based models and (2) uses paleoliquefaction evidence at ten sites spanning from Southern Oregon to Vancouver, BC to constrain possible ground-motion intensities experienced in the 1700 CE earthquake. The forward predictions indicate that liquefaction in M9 events could be pervasive in the region and affect numerous population hubs, with the potential for damage across hundreds of square kilometers. The backward analyses suggest that 1700 CE ground-motion intensities may have been less than expected from M9 simulations in some northern portions of the CSZ (e.g. Seattle), given the paucity of 1700 CE liquefaction evidence in these areas. Ultimately, further discovery and analysis of CSZ paleoliquefaction, or lack thereof, will confirm or modify this possibility and the conclusions drawn herein.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 44.28740331066001° to 48.65345896049223° latitude; -125.26164781722542° to -122.25792048153377° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

BibTeXRIS

Ryan A. Rasanen, Alex R. Grant, Andrew James Makdisi, Brett W. Maurer, Erin A. Wirth. 2025-02-19. Implications of physics-based M9 ground motions on liquefaction-induced damage in the Cascadia Subduction Zone: Looking forward and backward. https://doi.org/10.1177/87552930251316819

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related discoveries

Earthquake stress drop, source spectra from laboratory experiments, and the apparent unsteadiness of frictional slip

Over a range of co-seismic total energy release, high sample rate slip, stress, and slip velocity measurements were made during frictional failure to determine seismic source properties. The near-field measurements were used to estimate stress drops using spectral approaches that are analogous to the standard seismological moment-corner determined Δσ and acceleration amplitude Δσ arms stress drops. Rapid frictional sliding produces slip velocity amplitude spectra that vary with frequency -1 so long as the energy dissipated by friction approaches the total energy release. Under these conditions Δσ and Δσ arms are similar in size. Since these are nearly direct measurements of fault slip velocity and because they produce flat acceleration spectra between the corner and an apparent fmax, friction in these experiments seems to produce dynamic acceleration and deceleration at all resolved frequencies. The physical origin of this unsteady motion is not known exactly but likely reflects rapid dynamic variations in fault strength or applied stress. On the other hand, when the total energy stored prior to failure is artificially made somewhat larger relative to that which can be dissipated by friction the velocity spectra vary with frequency -2 immediately below the corner. At these conditions Δσ and Δσ arms diverge. The excess stored energy is preferentially partitioned into radiated energy upon failure. Collectively the experiments imply that to produce unsteady, white noise accelerations that are observed for natural earthquakes, requires that at least 95% of the energy released does not escape the source region to be radiated to the far-field.

Bulletin of the Seismological Society of America

Broadband stochastic simulation of earthquake ground motions with multiple strong phases with an application to the 2023 Kahramanmaraş, Turkey (Türkiye), earthquake

Stochastic ground motion simulation models are often less accurate at lower frequencies than at higher frequencies when fitting recorded data unless supplemented by a deterministic forward directivity velocity pulse model. Moreover, time-modulated stochastic models, which adjust ground motion amplitudes over time, typically use functions that fail to capture multiple strong-motion phases. The February 2023 Turkey (Türkiye) earthquake exhibited diverse recordings, including near-fault and far-field motions with pulse-like and non-pulse-like characteristics, along with single and multiple strong-motion phases. To better represent such a diverse set of recordings, this study enhances a fully non-stationary site-based stochastic model without combining it with a deterministic model. Improvements include a new band-pass filter with upper- and lower-frequency limits, which refines the representation of the low-frequency content. Moreover, a time-modulating function that can represent energy arrival in multiple strong phases is introduced. The reference model’s parameters are identified by fitting to the energy content, zero-level crossings, and cumulative counts of positive-minima and negative-maxima of a target accelerogram. This fitting procedure is modified to address the increased number of parameters. These improvements broaden the reference model’s applicability while preserving its simplicity, a key aspect appealing to engineering practitioners. The improved model’s applicability is demonstrated by simulating a dataset from the February 2023 Türkiye earthquake, and the accuracy is tested using a pulse-like Next Generation Attenuation Relationships for Western United States dataset. Validations are performed based on total energy, zero-level crossings, Fourier amplitude spectrum, elastic response spectra, and peak ground motion parameters. Validations are performed schematically in the time and frequency domains and quantitatively using goodness-of-fit scores, various validation-metrics errors, and inter-period correlations. Overall, the improved stochastic model can effectively simulate a set of diverse ground motion recordings, including near-fault pulse-like records, records with multiple strong phases, and far-field motions across a broad frequency range.

Kahramanmaraş

A partially nonergodic ground-motion model for Fourier amplitude spectra for the San Francisco Bay area, California, USA

We develop a partially nonergodic ground-motion model (GMM) for Fourier amplitude spectra for the San Francisco Bay Area, California, USA, using the Bayless and Abrahamson (2019) GMM as a reference ergodic GMM and developing location-dependent adjustments to the predicted median and variance. We compile regional ground-motion data from moment magnitude (𝑀 w ) >3 earthquakes occurring during 2000–2022 for which magnitude information is available in the U.S. Geological Survey Comprehensive Catalog (Guy et al., 2015). The data set predominantly consists of records from 𝑀 w 3.5–4.5 earthquakes but includes three well-recorded 𝑀 w > 5 events. Ground-motion residuals are evaluated using the time-averaged shear-wave velocity in the top 30 m (𝑉 S30 ) from the California-specific map of Thompson et al. (2018) and basin-depth site parameters from the seismic velocity model of Aagaard and Hirakawa (2021). The 𝑉 S30 dependence and basin-depth scaling of the reference ergodic GMM of Bayless and Abrahamson (2019) are evaluated and modified with the updated data set. We compute maps of site adjustments using a varying-coefficient model that considers the spatial correlation structure and uncertainties at each observation location. The spatial covariance model is developed using ground-motion residuals that are standardized by the uncertainty model, which allows for consideration of the aleatory variability in developing the site adjustments. The covariance model is fit considering the means and standard deviations of the site terms at all locations. The use of partially nonergodic median adjustments results in modified variance components of the within-event variability. Due to the low number of large-magnitude earthquakes that control seismic hazard in the data set, we do not modify between-event variance; however, we present adjustments to site-to-site variability for use in partially nonergodic hazard assessments.

California