Geology ReportsSearch

USGS · 70260216

Spatial and temporal variations in SO2 and PM2.5 levels around Kīlauea volcano, Hawai'i during 2007–2018

Abstract

Among the hazards posed by volcanoes are the emissions of gases and particles that can affect air quality and damage agriculture and infrastructure. A recent intense episode of volcanic degassing associated with severe impacts on air quality accompanied the 2018 lower East Rift Zone (LERZ) eruption of Kīlauea volcano, Hawai'i. This resulted in a major increase in gas emission rates with respect to usual emission values for this volcano, along with a shift in the source of the dominant plume to a populated area on the lower flank of the volcano. This led to reduced air quality in downwind communities. We analyse open-access data from the permanent air quality monitoring networks operated by the Hawai'i Department of Health (HDOH) and National Park Service (NPS), and report on measurements of atmospheric sulfur dioxide (SO 2 ) between 2007 and 2018 and PM 2.5 (aerosol particulate matter with diameter <2.5 μm) between 2010 and 2018. Additional air quality data were collected through a community-operated network of low-cost PM 2.5 sensors during the 2018 LERZ eruption. From 2007 to 2018 the two most significant escalations in Kīlauea's volcanic emissions were: the summit eruption that began in 2008 (Kīlauea emissions averaged 5–6 kt/day SO 2 from 2008 until summit activity decreased in May 2018) and the LERZ eruption in 2018 when SO 2 emission rates reached a monthly average of 200 kt/day during June. In this paper we focus on characterizing the airborne pollutants arising from the 2018 LERZ eruption and the spatial distribution and severity of volcanic air pollution events across the Island of Hawai'i. The LERZ eruption caused the most frequent and severe exceedances of the Environmental Protection Agency (EPA) PM 2.5 air quality threshold (35 μg/m 3 as a daily average) in Hawai'i in the period 2010–2018. In Kona, for example, the maximum 24-h-mean mass concentration of PM 2.5 was recorded as 59 μg/m 3 on the twenty-ninth of May 2018, which was one of eight recorded exceedances of the EPA air quality threshold during the 2018 LERZ eruption, where there had been no exceedances in the previous 8 years as measured by the HDOH and NPS networks. SO 2 air pollution during the LERZ eruption was most severe in communities in the south and west of the island, as measured by selected HDOH and NPS stations in this study, with a maximum 24-h-mean mass concentration of 728 μg/m 3 recorded in Ocean View (100 km west of the LERZ emission source) in May 2018. Data from the low-cost sensor network correlated well with data from the HDOH PM 2.5 instruments, confirming that these low-cost sensors provide a robust means to augment reference-grade instrument networks.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 19.167002726002252° to 19.636187244535606° latitude; -155.5280575771671° to -154.9496591158342° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R.C.W. Whitty, E. Ilyinskaya, Kelly E. Mason, P.E. Wieser, E. J. Liu, A. Schmidt, T.J. Roberts, M.A. Pfeffer, Barbara Brooks, T.A. Mather, M. Edmonds, Tamar Elias, David J. Schneider, C. Oppenheimer, A. Dybwad, Patricia A. Nadeau, Christoph Kern. 2020-02-25. Spatial and temporal variations in SO2 and PM2.5 levels around Kīlauea volcano, Hawai'i during 2007–2018. https://doi.org/10.3389/feart.2020.00036

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Pliocene (Piacenzian) planktic foraminiferal biogeography: Insights into how planktic biogeography is linked to climate and socioeconomic impacts on marine ecosystems

The Piacenzian Age (3.60–2.58 Ma) of the Pliocene Epoch was characterized by globally warmer climates, higher sea levels, and atmospheric CO 2 similar to present. Utilizing a robust dataset of 2,101 samples and over 637,000 foraminifer specimens from 77 deep-sea core sites worldwide, we document planktic foraminifer biogeography and biodiversity during the mid-Piacenzian Warm Period (mPWP). Cluster analysis and multidimensional scaling reveal five major bioregions: tropical, warm subtropical, transitional, polar, and a distinct North Atlantic polar bioregion. Each bioregion was dominated by characteristic species with well-established temperature preferences. Analyses demonstrate higher species richness and evenness in low and mid-latitudes, with increased diversity associated with periods of climatic warming and poleward expansion of warm water assemblages. The long-term stability of biogeographic patterns underscores ecological conservatism but also highlights potential vulnerability to rapid anthropogenic climate change. Our findings emphasize the critical role of planktic foraminifers in reconstructing past ocean conditions and offer valuable insights into links between planktic biogeography, climate, and socioeconomic impacts on marine ecosystems. This work advances our understanding of marine ecosystem responses to climate extremes and provides a foundation for future regional and temporal analyses of planktic foraminifer biogeography under global change scenarios.

Frontiers in Earth Science

Estimation of dynamic geologic CO2 storage resources in the Illinois Basin, including effects of brine extraction, anisotropy, and hydrogeologic heterogeneity

Since the vast majority of carbon dioxide (CO 2 ) storage resources in the United States are in deep saline aquifers, optimizing the use of these saline storage resources could be crucial for efficient development of geologic CO 2 storage (GCS) resources and basin- or larger-scale deployment of GCS in the country. Maximum CO 2 injection rates can be enhanced by extracting brine from the CO 2 storage unit. However, disposal of the extracted brine is both a technological and economic challenge. The lowest-cost option would likely be reinjection of the extracted brine into another formation above or below the CO 2 storage unit. Therefore, it is important to estimate brine injectivity as it will constrain the potential to increase CO 2 injectivity at an injection site that has access to multiple geologic storage units where either CO 2 or brine can be injected. Using a simulation-optimization framework, coupled with a non-isothermal, multiphase CO 2 -water-salt equation-of-state module, we developed a computationally efficient method for evaluating optimization of simultaneous CO 2 injection, brine extraction, and brine (re)injection at hypothetical injection sites deployed across a geologic basin. The Illinois basin is ideal for testing our methodology because it contains multiple geologic storage units with seals in between them to isolate injection of CO 2 in one unit from interfering with the injection of either brine or CO 2 in another unit above or below it. In addition, we investigated the relative effects of variation in key geologic parameters as well as two reservoir structures (hydrogeologic heterogeneity/anisotropy and homogeneity/isotropy) on CO 2 injectivities and enhancement of CO 2 injectivity through extracting brine. Results suggest that permeability, depth, and especially thickness of the storage unit could be the most influential parameters determining CO 2 injectivity. They also suggest that only injecting CO 2 into the storage unit with the greatest injectivity, enhancing that unit’s injectivity by extracting brine, and disposing of the produced brine in other suitable units could maximize total CO 2 injectivity in limited regions of the basin. At the majority of simulated injection sites, however, we found that injecting CO 2 into all of the accessible and suitable storage units was more likely to maximize the CO 2 storage resource.

Illinois, Kentucky, Indiana

An exploration of the relative influence of physical models for Omori’s law

Omori’s law states that the rate of aftershocks decays as a function of inverse time. There are multiple physical explanations that we reduce into a nonlinear mixed effects relation of three terms: (1) a Rate/State expression that can account for static/dynamic and viscoelastic triggering caused directly by the mainshock, (2) a fluid diffusion triggering term, and (3) a randomized secondary triggering (cascade) term. We fit free physical-model parameters to an observed aftershock sequence through two nonlinear regression methods to find the relative contributions of physics-based models in an observed aftershock sequence. Results from both methods show that Rate/State models overpredict aftershock rates by ∼0–30%. Secondary aftershocks cause a net negative contribution (seismicity rate reduction that corrects overprediction by other terms) ranging between ∼0 and 30%. All regression solutions yield negative secondary triggering contributions without being guided to do so. A physical explanation for this is that aftershock occurrence relieves stress from the crust, ultimately causing the sequence to extinguish itself. Fluid diffusion triggering contributions range from ∼0 to 20%. Diffusion processes are observed to be shorter in time than the full duration of an aftershock sequence and they are also spatially limited, diminishing their influence. Our results apply to an aftershock decay curve from the 2016 Central Apennines earthquake sequence, meaning that our specific results may not be general. Our primary conclusion is that any one physical model cannot alone fit the observed sequence as well as the combination of three we investigated.

Frontiers in Earth Science