Geology Reports⌕ Search

USGS · ofr90294

Geology and mineralization at the Ishmas Kabir gold prospect, Ishmas gold district, Kingdom of Saudi Arabia

Abstract

Ishmas Kabir ancient gold mine is located approximately 60 km southeast of the city of Ranyah and 9 km northwest of Jabal Ishmas in the southwestern part of the Ishmas gold district. The mine workings are located near the eastern edge of a flat plain covered by eolian sand and drained by Wadi Bishah. Two elongate dumps, 75 m wide and 530 m long (combined length), comprise the workings. Rising 4 m above the plain, they are prominent features in this area of low relief. Core drilling (1,023 m total depth drilled) was conducted to define the extent of potential gold occurrences at the prospect. The two northeasternmost of the four holes drilled unequivocally intersected the gold-bearing main vein zone. Drill hole 1, the northeasternmost hole drilled, passed through significant lengths of altered wall rocks + quartz veins containing > 100 ppb Au (threshold value). The average gold concentration of all intercepts in drill holes 1 through 4 is 278 ppb; the total length of drill core that assayed above the gold threshold value is 13.46 m. The highest gold concentration (1,620 ppb) reported in geochemical assay results was obtained from a 0.33 m length of core in drill hole 1. Gold-intercept occurrences are not economic in the rocks drilled; no further deep drilling is recommended at this time. Gold concentrations in samples obtained from mine dumps are much higher than in drill-core samples. Samples collected by earlier workers assayed 3-7 g/t, and tonnage estimates of mine spoil have been estimated to be as high as 120,000 tons. A possible sampling bias in earlier studies may favor larger gold-enriched, samples relative to samples from quartz tailings. Further work at Ishmas Kabir should be limited to defining gold resource potential in the dumps and in the oxidized, near-surface quartz-vein system. Primary gold at the Ishmas Kabir gold prospect occurs with quartz veins and associated sericite + pyrite alteration hosted by quartz diorite and mafic dikes. The highest gold concentrations both in dumps (earlier studies) and drill core (this investigation) are found with limonite + hematite in breccia zones, in stringer veins, and in sericitic alteration envelopes surrounding quartz veins. Secondary gold is significant in this system and attests to the importance of oxidizing, acidic solutions. Quartz veins intersected by drill holes are surrounded by mylonite schist. Quartz and carbonate veins less than 5 mm thick are boudined, whereas thick quartz veins (£ 1.2 m) have disrupted and brecciated margins; mylonitized country rock envelops quartz-vein fragments. Sulfide mineralization associated with vein formation predates this rock-deformation event. Contemporaneous brittle and ductile deformation of quartz veins and country rocks occurred during the Nabitah orogeny. Supergene gold enrichment took place much later.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 20° to 30° latitude; 43° to 44° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

B.M. Walker, Majed Ben Talib, Mohamed El Komi, M.A. Hussain, R.P. Christian. 1990. Geology and mineralization at the Ishmas Kabir gold prospect, Ishmas gold district, Kingdom of Saudi Arabia. https://doi.org/10.3133/ofr90294

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

ECCOE Landsat quarterly calibration and validation report—Quarter 2, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 2 (April–June), 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov.

Open-File Report↗

ECCOE Landsat quarterly calibration and validation report—Quarter 1, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 1 (January–March) of 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov . One specific activity that the ECCOE Landsat Cal/Val Team closely monitored was a Landsat 8 Thermal Infrared Sensor encoder alerts anomaly. On March 18, 2026, the Thermal Infrared Sensor instrument’s mechanism control electronics board reset, driving several parameters to default power-on values. Subsequent telemetry and analysis determined that no persistent hardware misconfiguration was present and no radiometric or geometric degradation was observed.

Open-File Report↗

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗