Geology ReportsSearch

USGS · 70262605

Slow slip detectability in seafloor pressure records offshore Alaska

Abstract

In subduction zones worldwide, seafloor pressure data are used to observe tectonic deformation, particularly from megathrust earthquakes and slow slip events (SSEs). However, such measurements are also sensitive to oceanographic circulation-generated pressures over a range of frequencies that conflate with tectonic signals of interest. Using seafloor pressure and temperature data from the Alaska Amphibious Community Seismic Experiment, and sea surface height data from satellite altimetry, we evaluate the efficacy of various seasonal and oceanographic pressure signal proxy corrections and conduct synthetic tests to determine their impact on the timing and amplitude prediction of ramp-like signals typical of SSEs. We find that subtracting out the first mode of the complex empirical orthogonal functions of the pressure records on either the shelf or slope yields signal root-mean-square error (RMS) reductions up to 73% or 80%, respectively. Additional correction with proxies that exploit the depth-dependent spatial coherence of pressure records provides cumulative variance reductions up to 83% and 93%, respectively. Our detectability tests show that the timing and amplitude of synthetic SSE-like ramps can be well constrained for ramp amplitudes ≥4 cm on the shelf and ≥2 cm on the slope, using a fully automated detector. The principal limits on detectability are residual abrupt changes in pressure that occur as part of the transition to and from summer to winter conditions but are not adequately characterized by our seasonal corrections, as well as the inability to properly account for instrumental drift, which is not readily separated from the seasonal signal.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 53.57246789386025° to 59.98743881891275° latitude; -163.58127742066247° to -148.28571839994297° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

BibTeXRIS

Erik Fredrickson, Joan S. Gomberg, William Wilcock, Susan Hautala, Albert Hermann, H. Paul Johnson. 2023-02-19. Slow slip detectability in seafloor pressure records offshore Alaska. https://doi.org/10.1029/2022jb024767

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related USGS reports

3D viscoelastic models of slip-deficit rate along the Cascadia subduction zone

Interseismic deformation in the Pacific Northwest is constrained by the horizontal crustal velocity field derived from the Global Positioning System (GPS) in addition to vertical rates derived from GPS, leveling, and tide gauge measurements. Such measurements were folded in to deformation models of fault slip rates as part of the 2023 National Seismic Hazard Model (NSHM) update. Here I build upon one of the contributing models, the viscoelastic earthquake-cycle model of Pollitz [2022]. This model permits inclusion of effects of time-dependent viscoelastic relaxation within earthquake cycles (i.e., ‘ghost transients’) and laterally variable elastic and/or ductile material properties. I lever-age these capabilities to incorporate the Cascadia megathrust into Western U.S.-wide deformation models in which crustal fault slip rates are estimated simultaneously with slip deficit rates along the interplate boundary between the descending Juan de Fuca plate and North American plate. This effort includes construction of a margin-wide model of viscoelastic structure founded on the Slab 2.0 model and probes different models of the ductile properties of the surrounding oceanic asthenosphere, continental lower crust, and mantle asthenosphere. This results in new estimates of the distribution of slip deficit rate along the ∼ 1000 km long margin, highlights the importance of correcting for glacial-isostatic adjustment effects, and permits assessment of sensitivity of results to assumed ductile properties.

California, Oregon, Washington

RegionGrow3D: A deterministic analysis for characterizing discrete three-dimensional landslide source areas on a regional scale

Regional-scale characterization of shallow landslide hazards is important for reducing their destructive impact on society. These hazards are commonly characterized by (a) their location and likelihood using susceptibility maps, (b) landslide size and frequency using geomorphic scaling laws, and (c) the magnitude of disturbance required to cause landslides using initiation thresholds. Typically, this is accomplished through the use of inventories documenting the locations and triggering conditions of previous landslides. In the absence of comprehensive landslide inventories, physics-based slope stability models can be used to estimate landslide initiation potential and provide plausible distributions of landslide characteristics for a range of environmental and forcing conditions. However, these models are sometimes limited in their ability to capture key mechanisms tied to discrete three-dimensional (3D) landslide mechanics while possessing the computational efficiency required for broad-scale application. In this study, the RegionGrow3D (RG3D) model is developed to broadly simulate the area, volume, and location of landslides on a regional scale (≥1,000 km 2 ) using 3D, limit-equilibrium (LE)-based slope stability modeling. Furthermore, RG3D is incorporated into a susceptibility framework that quantifies landsliding uncertainty using a distribution of soil shear strengths and their associated probabilities, back-calculated from inventoried landslides using 3D LE-based landslide forensics. This framework is used to evaluate the influence of uncertainty tied to shear strength, rainfall scenarios, and antecedent soil moisture on potential landsliding and rainfall thresholds over a large region of the Oregon Coast Range, USA.

Journal of Geophysical Research: Earth Surface

Uncertainty reduction for subaerial landslide-tsunami hazards

Subaerial rock slopes may generate a tsunami by rapidly moving into the water. Large uncertainty in landslide characteristics propagates into large uncertainty in tsunami hazard, making hazard assessment more difficult for land and emergency managers. Once a potentially tsunamigenic landslide is identified, it may not be clear which landslide characteristics contribute most significantly to uncertainty in the tsunami hazard. Our aim is to document the relative worth of different landslide characteristics (e.g., size, material properties) for reducing uncertainty in landslide-tsunami hazard assessments. Isolating the relative importance of specific landslide characteristics may inform prioritization of data collection and improve efficiency in understanding hazard. To accomplish this, we generated a set of 288 landslide-tsunami simulations in which we systematically varied the size and material properties of possible failure extents at the Barry Arm landslide complex in northwestern Prince William Sound, Alaska, USA. We find that for landslides smaller than the receiving waterbody, the landslide volume has the strongest effect on resulting wave characteristics and thus the highest leverage on reducing uncertainty in tsunami hazard. In contrast, for landslides substantially larger than the waterbody, the duration of rapid movement of the landslide has the highest leverage. Based on our results, we propose a classification scheme for subaerial landslides based on the relative size of the landslide and waterbody. Additionally, our results support the generation of a tsunami height transfer function between existing tide gages and a nearby coastal city. These results have direct implications for the practice of operational early warning.

Alaska