Geology Reports⌕ Search

Geology topics

H. Paul Johnson

Publications and source records attributed to H. Paul Johnson.

9 recordsLinked to original sources

Spatial mapping of dissolved methane using an in situ sensor in Puget Sound

Release of methane, as gas bubbles or in the dissolved phase, from the seafloor has been observed in coastal waters (< 200 m) and deep ocean basins (> 1000 m). Methane dissolution within the water column affects the geochemistry of the surrounding water, leading to localized oxygen loss and potential escape to the atmosphere, particularly from shallower sites. Traditional methods for detecting and quantifying dissolved methane rely on collecting discrete water samples for ship- or land-based ex situ analysis and post processing. Here, we report on the use of a reduced response time, in situ methane sensor, the Sensor for Aqueous Gases in the Environment (SAGE), for detecting and quantifying dissolved methane concentrations in a wide range of seafloor environments. During a Fall 2022 research cruise on the R/V Thomas G. Thompson in Puget Sound, SAGE was integrated onto a towed conductivity/temperature/depth rosette and deep-sea camera system with live-stream 1 Hz telemetry and used to spatially map the concentration of methane approximately 1 m above the seafloor. The site had been previously identified as an active methane plume field characterized by gas bubbles, fluid venting, and a faulted seabed. The widespread background dissolved concentration of methane measured by SAGE was 83 nM, and a range of 78–670 nM was observed throughout the survey. The results highlight the capacity of SAGE to map the spatial and temporal variability of dissolved methane concentrations in situ and to identify and localize sites of variable methane emissions from the seafloor.

Washington↗

Slow slip detectability in seafloor pressure records offshore Alaska

In subduction zones worldwide, seafloor pressure data are used to observe tectonic deformation, particularly from megathrust earthquakes and slow slip events (SSEs). However, such measurements are also sensitive to oceanographic circulation-generated pressures over a range of frequencies that conflate with tectonic signals of interest. Using seafloor pressure and temperature data from the Alaska Amphibious Community Seismic Experiment, and sea surface height data from satellite altimetry, we evaluate the efficacy of various seasonal and oceanographic pressure signal proxy corrections and conduct synthetic tests to determine their impact on the timing and amplitude prediction of ramp-like signals typical of SSEs. We find that subtracting out the first mode of the complex empirical orthogonal functions of the pressure records on either the shelf or slope yields signal root-mean-square error (RMS) reductions up to 73% or 80%, respectively. Additional correction with proxies that exploit the depth-dependent spatial coherence of pressure records provides cumulative variance reductions up to 83% and 93%, respectively. Our detectability tests show that the timing and amplitude of synthetic SSE-like ramps can be well constrained for ramp amplitudes ≥4 cm on the shelf and ≥2 cm on the slope, using a fully automated detector. The principal limits on detectability are residual abrupt changes in pressure that occur as part of the transition to and from summer to winter conditions but are not adequately characterized by our seasonal corrections, as well as the inability to properly account for instrumental drift, which is not readily separated from the seasonal signal.

Alaska↗

Sediment gravity flows triggered by remotely generated earthquake waves

Recent great earthquakes and tsunamis around the world have heightened awareness of the inevitability of similar events occurring within the Cascadia Subduction Zone of the Pacific Northwest. We analyzed seafloor temperature, pressure, and seismic signals, and video stills of sediment-enveloped instruments recorded during the 2011–2015 Cascadia Initiative experiment, and seafloor morphology. Our results led us to suggest that thick accretionary prism sediments amplified and extended seismic wave durations from the 11 April 2012 M w 8.6 Indian Ocean earthquake, located more than 13,500 km away. These waves triggered a sequence of small slope failures on the Cascadia margin that led to sediment gravity flows culminating in turbidity currents. Previous studies have related the triggering of sediment-laden gravity flows and turbidite deposition to local earthquakes, but this is the first study in which the originating seismic event is extremely distant (> 10,000 km). The possibility of remotely triggered slope failures that generate sediment-laden gravity flows should be considered in inferences of recurrence intervals of past great Cascadia earthquakes from turbidite sequences. Future similar studies may provide new understanding of submarine slope failures and turbidity currents and the hazards they pose to seafloor infrastructure and tsunami generation in regions both with and without local earthquakes.

Cascadia subduction zone↗

Rethinking turbidite paleoseismology along the Cascadia subduction zone

A stratigraphic synthesis of dozens of deep-sea cores, most of them overlooked in recent decades, provides new insights into deep-sea turbidites as guides to earthquake and tsunami hazards along the Cascadia subduction zone, which extends 1100 km along the Pacific coast of North America. The synthesis shows greater variability in Holocene stratigraphy and facies off the Washington coast than was recognized a quarter century ago in a confluence test for seismic triggering of sediment gravity flows. That test compared counts of Holocene turbidites upstream and downstream of a deep-sea channel junction. Similarity in the turbidite counts among seven core sites provided evidence that turbidity currents from different submarine canyons usually reached the junction around the same time, as expected of widespread seismic triggering. The fuller synthesis, however, shows distinct differences between tributaries, and these differences suggest sediment routing for which the confluence test was not designed. The synthesis also bears on recent estimates of Cascadia earthquake magnitudes and recurrence intervals. The magnitude estimates hinge on stratigraphic correlations that discount variability in turbidite facies. The recurrence estimates require turbidites to represent megathrust earthquakes more dependably than they do along a flow path where turbidite frequency appears limited less by seismic shaking than by sediment supply. These concerns underscore the complexity of extracting earthquake history from deep-sea turbidites at Cascadia.

Cascadia subduction zone↗

Upper crustal densities derived from sea floor gravity measurements: Northern Juan De Fuca Ridge

A transect of sea floor gravity stations has been analyzed to determine upper crustal densities on the Endeavour segment of the northern Juan de Fuca Ridge. Data were obtained using ALVIN along a corridor perpendicular to the axis of spreading, over crustal ages from 0 to 800,000 years. Calculated elevation factors from the gravity data show an abrupt increase in density with age (distance) for the upper 200 m of crust. This density change is interpreted as a systematic reduction in bulk porosity of the upper crustal section, from 23% for the axial ridge to 10% for the off-axis flanking ridges. The porosity decrease is attributed to the collapse and filling of large-scale voids as the abyssal hills move out of the crustal formation zone. Forward modeling of a plausible density structure for the near-axis region agrees with the observed anomaly data only if the model includes narrow, along-strike, low-density regions adjacent to both inner and outer flanks of the abyssal hills. The required low density zones could be regions of systematic upper crustal fracturing and faulting that were mapped by submersible observers and side-scan sonar images, and whose presence was suggested by the distribution of heat flow data in the same area.

Geophysical Research Letters↗

Magnetic properties of the Bay of Islands ophiolite suite and implications for the magnetization of oceanic crust

Rock magnetic properties, opaque mineralogy, and degree of metamorphism were determined for 101 unoriented samples from the North Arm and Blow-Me-Down massifs of the Bay of Islands ophiolite complex, Newfoundland. The weathered and metamorphosed extrusive basalt samples have a weak, secondary magnetization arising from oxidation and exsolution of ilmenite of unknown origin. The initial magnetization of the underlying sheeted dike complex appears to have been destroyed by hydrothermal alteration soon after formation. The magnetic intensity of the gabbroic samples increases as the degree of alteration increases, with the highly altered upper metagabbros having an average intensity of 3&times;10 &minus;3 emu/c 3 . Because magnetization of the metagabbro samples is related to nonpervasive, variable alteration, these crustal units are unlikely to make a significant contribution to lineated magnetic anomalies. A compilation of our results and other studies suggests a model in which oceanic crust magnetization results from an upper extrusive basalt source layer, roughly 600 m thick, with no contribution from a deeper source layer recognizable from these Bay of Islands data.

Newfoundland↗

Overview of SAX99: Environmental considerations

A 1-km2 area located 2 km off the Florida Pan-handle (30??22.6???N; 86??38.7???W) was selected as the site to conduct high-frequency acoustic seafloor penetration, sediment propagation, and bottom scattering experiments [1]. Side scan, multibeam, and normal incidence chirp acoustic surveys as well as subsequent video surveys, diver observations, and vibra coring, indicate a uniform distribution of surficial and subbottom seafloor characteristics within the area. The site, in 18-19 m of water, is characterized by 1-2-m thick fine-to-medium clean sand and meets the logistic and scientific requirements specified for the acoustic experiments. This paper provides a preliminary summary of the meteorological, oceanographic, and seafloor conditions found during the experiments and describes the important physical and biological process that control the spatial distribution and temporal changes in these characteristics.

IEEE Journal of Oceanic Engineering↗

ALVIN investigation of an active propagating rift system, Galapagos 95.5° W

ALVIN investigations have defined the fine-scale structural and volcanic patterns produced by active rift and spreading center propagation and failure near 95.5&deg; W on the Galapagos spreading center. Behind the initial lithospheric rifting, which is propagating nearly due west at about 50 km m.y. &minus;1 , a triangular block of preexisting lithosphere is being stretched and fractured, with some recent volcanism along curving fissures. A well-organized seafloor spreading center, an extensively faulted and fissured volcanic ridge, develops ~ 10 km (~ 200,000 years) behind the tectonic rift tip. Regional variations in the chemical compositions of the youngest lavas collected during this program contrast with those encompassing the entire 3 m.y. of propagation history for this region. A maximum in degree of magmatic differentiation occurs about 9 km behind the propagating rift tip, in a region of diffuse rifting. The propagating spreading center shows a gentle gradient in magmatic differentiation culminating at the SW-curving spreading center tip. Except for the doomed rift, which is in a constructional phase, tectonic activity also dominates over volcanic activity along the failing spreading system. In contrast to the propagating rift, failing rift lavas show a highly restricted range of compositions consistent with derivation from a declining upwelling zone accompanying rift failure. The lithosphere transferred from the Cocos to the Nazca plate by this propagator is extensively faulted and characterized by ubiquitous talus in one of the most tectonically disrupted areas of seafloor known. The pseudofault scarps, where the preexisting lithosphere was rifted apart, appear to include both normal and propagator lavas and are thus more lithologically complex than previously thought. Biological communities, probably vestimentiferan tubeworms, occur near the top of the outer pseudofault scarp, although no hydrothermal venting was observed.

Marine Geophysical Research↗