Geology Reports⌕ Search

USGS · 70020088

Soufrière Hills eruption, Montserrat, 1995 - 1997: volcanic earthquake locations and fault plane solutions

Abstract

A total of 9242 seismic events, recorded since the start of the eruption on Montserrat in July 1995, have been uniformly relocated with station travel-time corrections. Early seismicity was generally diffuse under southern Montserrat, and mostly restricted to depths less than 7 km. However, a NE-SW alignment of epicentres beneath the NE flank of the volcano emerged in one swarm of volcano-tectonic earthquakes (VTs) and later nests of VT hypocentres developed beneath the volcano and at a separated location, under St. George's Hill. The overall spatial distribution of hypocentres suggests a minimum depth of about 5 km for any substantial magma body. Activity associated with the opening of a conduit to the surface became increasingly shallow, with foci concentrated below the crater and, after dome building started in Fall 1995, VTs diminished and repetitive swarms of ‘hybrid’ seismic events became predominant. By late-1996, as magma effusion rates escalated, most seismic events were originating within a volume about 2 km diameter which extended up to the surface from only about 3 km depth - the diminution of shear failure earthquakes suggests the pathway for magma discharge had become effectively unconstricted. Individual and composite fault plane solutions have been determined for a few larger earthquakes. We postulate that localised extensional stress conditions near the linear VT activity, due to interaction with stresses in the overriding lithospheric plate, may encourage normal fault growth and promote sector weaknesses in the volcano.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

W. P. Aspinall, A.D. Miller, L.L. Lynch, J.L. Latchman, R.C. Stewart, R.A. White, J.A. Power. 1998-09-15. Soufrière Hills eruption, Montserrat, 1995 - 1997: volcanic earthquake locations and fault plane solutions. https://doi.org/10.1029/98gl00858

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Evolution of summit magma pressure during the 2018 caldera collapse at Kılauea volcano

We utilized geodetic data from the 16 May to 4 August 2018 caldera collapse sequence to refine the geometries and pressure evolution of two summit reservoirs at Kīlauea volcano: the shallower Halema‘uma‘u (HMM) and deeper South Caldera (SC) reservoirs. We modeled magma reservoirs as pressurized spheroidal cavities and constrained reservoir geometries with Global Positioning System (GPS) and Interferometric Synthetic Aperture Radar displacements. Inverting high-rate GPS and borehole tilt time series recovered time-dependent reservoir pressure changes and caldera ring fault shear stress. During the collapse sequence, the HMM reservoir accommodated episodic, co-collapse pressure increases of 1.9 MPa (median) and a net 5.8 MPa (median) decrease. Simultaneously, the SC reservoir underwent monotonic depressurization of 6.7 MPa (median). Negligible co-collapse pressure changes in the SC reservoir imply it was not exclusively supplying magma to the eruption vent. These results provide a coherent view of magma reservoir pressure evolution during the 2018 eruption.

Hawaii↗

EMIT reveals elevated calcite signatures in shorelines of Lake Powell and Lake Mead exposed by drought and Colorado River management

Nearly half of Earth’s seasonal freshwater storage variability occurs in human-managed reservoirs, resulting in large areas of reservoir-bed that are episodically inundated or subaerially exposed. Here we use hyperspectral data from NASA’s Earth Surface Mineral Dust Source Investigation (EMIT) mission to map calcite mineral assemblages across exposed surfaces in two large U.S. reservoirs, Lake Mead and Lake Powell. Results show distinct patterns in the occurrence of carbonate, clay, and mica minerals. Reservoir-deposited sediments exhibited significantly higher calcite proportions than adjacent, lithologically similar, non-inundated terrestrial surfaces. These differences likely reflect hydrologically-driven calcite precipitation, wherein warm, clear, productive reservoir waters drive calcium carbonate out of solution. We also detect reductions in calcite proportions in areas of the shoreline disturbed by human recreation. EMIT's imaging capabilities enable rapid, high-resolution mineralogical inventories across vast areas where field sampling is infeasible. We find EMIT is a scalable tool for monitoring geochemical changes associated with large water level fluctuations.

Arizona, Nevada, Utah↗

First application of a coastal-dune model (AeoLiS) to simulate fluvial-aeolian morphodynamics

Quantifying aeolian processes is important to decision-making in river management and for optimizing strategies for ecosystem conservation, natural resource management, and recreation. We applied the AeoLiS aeolian transport model, originally developed for coastal environments, to a dryland river corridor to evaluate its ability to simulate sediment dynamics in a fluvial-aeolian system. The model reproduced spatial and temporal patterns of geomorphic change at a Grand Canyon sandbar, including aeolian dune formation, observed in field data. The model effectively captured trends in observed sediment movement in the spring and summer months. Thus, despite assuming a single grain-size, static vegetation, and not directly accounting for variable sediment supply from fluvial sources, the model performs well at capturing aeolian processes in a complex fluvial-aeolian system. AeoLiS demonstrates strong potential for dryland river applications and management, due to its flexibility and compatibility with coupled modeling frameworks.

Arizona↗