Geology ReportsSearch

USGS · 70001224

The nature of surface tilt along 85 km of the San Andreas fault-preliminary results form a 14-instrument array

Abstract

The continuous monitoring of surface deformation near active faults is clearly necessary for an understanding of elastic strain accumulation and elastic and anelastic strain release associated with earthquakes. Fourteen 2-component tiltmeters have been installed in shallow boreholes along 85 km of the currently most active section of the San Andreas fault in the western United States. These instruments operate at a sensitivity of 10 −8 radians. Five of these tiltmeters, extending along one 35 km section of the fault, have been in operation since June 1973. The results indicate that regional tectonic tilting has occurred before more than ten individual earthquakes or groups of earthquakes with epicenters within ten earthquake source dimensions of one or more instruments. This tilting has a time scale of up to a month depending on earthquake magnitude. The amplitude of these tilts exceeds by almost an order of magnitude that expected from a dislocation model of the source using seismically determined parameters. No indication of rapid or accelerated tilt just prior to these earthquakes has been seen.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 34.288991865037524° to 35.96911507577482° latitude; -120.1904296875° to -118.38867187500001° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

C.E. Mortensen, M.J.S. Johnston. 1975. The nature of surface tilt along 85 km of the San Andreas fault-preliminary results form a 14-instrument array. https://doi.org/10.1007/bf01592914

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Introduction to “Global tsunami science: Past and future, Volume I”

Twenty-five papers on the study of tsunamis are included in Volume I of the PAGEOPH topical issue “Global Tsunami Science: Past and Future”. Six papers examine various aspects of tsunami probability and uncertainty analysis related to hazard assessment. Three papers relate to deterministic hazard and risk assessment. Five more papers present new methods for tsunami warning and detection. Six papers describe new methods for modeling tsunami hydrodynamics. Two papers investigate tsunamis generated by non-seismic sources: landslides and meteorological disturbances. The final three papers describe important case studies of recent and historical events. Collectively, this volume highlights contemporary trends in global tsunami research, both fundamental and applied toward hazard assessment and mitigation.

Pure and Applied Geophysics PAGEOPH

Implications of Coulomb plasticity for the velocity dependence of experimental faults

Simulated fault gouges often deform more stably than initially bare surfaces of the same composition. It is important to understand why the sliding stability is enhanced because the presence of gouge on natural faults may have the same effect as seen in experiments, and thus explain the absence of earthquakes at shallow depths. Gouge stabilization in experiments has been attributed to positive contributions to velocity dependence within gouge layers from either dilation (Maroneet al., 1990) or grain fracture (Biegelet al., 1989). In this study we test the hypothesis that some aspects of gouge and initially bare surface velocity dependence are identical by measuring the time-dependent constitutive parameter b. An important result follows however from stress analysis: if both sample configurations are frictional in the Mohr-Coulomb sense, each configuration is required to deform on planes of distinctly different orientation. The measured strength and velocity dependence will reflect this geometric difference. Our observed values of b for simulated granite and quartz gouge are two to two and a half times smaller than b for initially bare surfaces. This difference is completely accounted for if gouge is represented as a cohesionless-Coulomb plastic material. The analysis demonstrates the following points: 1) gouge deformation is fully consistent with Coulomb plasticity, 2) observed gouge velocity dependence is a function of observed strength and 3) the constitutive parameter b is the same for both bare surfaces and gouge. Furthermore, the results suggest that there is no time-dependent strengthening associated with stabilizing effects in gouge. These observations provide a framework for understanding how slip on initially bare surfaces and gouge deformation are related. ?? 1995 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH

The effect of fault-bend folding on seismic velocity in the marginal ridge of accretionary prisms

Fluid venting in accretionary prisms, which feeds chemosynthetic biological communities, occurs mostly on the marginal thrust ridge. New seismic data for the marginal ridge of the Cascadia prism show significantly lower velocity than that in the adjacent oceanic basin and place important constraints on the interpretations of why fluid venting occurs mostly on the marginal ridge. We employed a finite-element method to analyze a typical fault-bend folding model to explain the phenomenon. The fault in the model is simulated by contact elements. The elements are characterized not only by finite sliding along a slide line, but also by elastoplastic deformation. We present the results of a stress analysis which show that the marginal ridge is under subhorizontal extension and the frontal thrust is under compression. This state of stress favors the growth of tensile cracks in the marginal ridge, facilitates fluid flow and reduces seismic velocities therein; on the other hand, it may close fluid pathways along the frontal thrust and divert fluid flow to the marginal ridge. ?? 1995 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH