Geology Reports⌕ Search

Geology topics

R. B. Halley

Publications and source records attributed to R. B. Halley.

32 records · Page 2Linked to original sources

Sea-level records at ~80 ka from tectonically stable platforms: Florida and Bermuda

Studies from tectonically active coasts on New Guinea and Barbados have suggested that sea level at ∼ 80 ka was significantly lower than present, whereas data from the Atlantic and Pacific coasts of North America indicate an ∼ 80 ka sea level close to that of the present. We determined ages of corals from a shallow submerged reef off the Florida Keys and an emergent marine deposit on Bermuda. Both localities are on tectonically stable platforms distant from plate boundaries. Uranium-series ages show that corals at both localities grew during the ∼80 ka sea-level highstand, and geologic data show that sea level at that time was no lower than 7–9 m below present (Florida) and may have been 1–2 m above present (Bermuda). The ice-volume discrepancy of the 80 ka sea-level estimates is greater than the volume of the Greenland or West Antarctic ice sheets. Comparison of our ages with high-latitude insolation values indicates that the sea-level stand near the present at ∼80 ka could have been orbitally forced.

Florida↗

Preliminary analysis of down-core biotic assemblages Bob Allen Keys, Everglades National Park, Florida Bay

Introduction A series of short piston cores (< 2m) were taken from eleven stations in Florida Bay in May, 1994 by researchers from the U.S. Geological Survey (St. Petersburg, FL., Woods Hole, MA., and Denver CO.) in cooperation with South Florida Water Management District, and the Everglades National Park, and the National Oceanic and Atmospheric Administration (NOAA). Core 6A from Bob Allen Keys (25° 1.391” N, 80°39.41” W) penetrated 172 cm of Holocene sediments in 0.6 m of water on a grass covered mud bank, approximately 1.75 miles (2.82 km) east of the water monitoring station on the southern end of the Bob Allen Keys. Core 6A was sampled for particle size, insoluble residue, water content, loss on ignition, Pb 210 , Rasup>222, and paleontologic analyses. Here we present the results of the preliminary paleontologic analyses of the biotic components from core #6A. The Everglades/Florida Bay ecosystem has formed over the last 5000 years at the southern tip of peninsular Florida. Here it has been influenced by Atlantic, Caribbean and Gulf of Mexico waters, and by tropical and subtropical climatic regimes. This location ensures that over time the ecosystem has undergone climatic changes on both a seasonal and long term basis, and that it has been subjected to many major storms. Additionally, in the last century, the hydrologic regime of the region has been altered profoundly through construction of a canal system to control flooding in southern Florida. This system regulates the timing and amount of freshwater flow into Florida Bay. Recently, algal blooms, seagrass, and sponge die-offs, and declining numbers of shellfish, have been reported in Florida Bay; although it has been assumed that these changes have resulted from human alteration of freshwater flow into the bay, this assumption has not been rigorously tested. The research described here is part of a project designed to examine the history of the Everglades/Florida Bay ecosystem over the last 150 years and to test assumptions of cause and effect. The purpose of the project is two-fold; first, to determine the characteristics of the ecosystem prior to significant human-induced alteration, including the natural range of variation in the ecosystem. This information will establish a baseline for restoration of the system. Second, the project aims to establish the extent, range, and timing of changes to the ecosystem over the last 150 years, and to determine whether these changes correlate with human alteration of the environment, or meteorological patterns, such as precipitation and major storms, or a combination of factors.

Florida↗

Fluid inclusions in vadose cement with consistent vapor to liquid ratios, Pleistocene Miami Limestone, southeastern Florida

Vadose cements in the Late Pleistocene Miami Limestone contain regions with two-phase aqueous fluid inclusions that have consistent vapor to liquid (V-L) ratios. When heated, these seemingly primary inclusions homogenize to a liquid phase in a range between 75°C and 130°C (mean = 100° C ) and have final melting temperatures between −0.3° and 0.0°C. The original distribution of T h was broadened during measurements because of fluid inclusion reequilibration. The narrow range of T h in these fluid inclusions suggest unusually consistent V-L ratios. They occur with small, obscure, single phase liquid-filled inclusions, which infer a low temperature origin (less than 60°C), and contradict the higher temperature origin implied by the two phase inclusions. The diagenetic environment producing these seemingly primary fluid inclusions can be inferred from the origin of the host calcite enclosing them. The δ 18 O composition of these cements (−4 to−5.5%., PDB) and the fresh water in the fluid inclusions are consistent with precipitation from low-temperature meteoric water. The carbon-isotope composition of the vadose cements that contain only rare two-phase fluid inclusions are comparable to the host rock matrix (δ 13 C between 0 and +4%., PDB). Cements that contain common two-phase fluid-inclusions have a distinctly lighter carbon isotopic composition of −3 to −5%.. The carbon isotope composition of cements that contain common two-phase inclusions are about 6%. lighter than those of other vadose cements; models of early meteoric diagenesis indicate that this is the result of precipitation from water that has been influenced by soil gas CO 2 . Our hypothesis is that the primary fluid inclusions, those with consistent V-L ratios and the single-phase liquid inclusions, form at near-surface temperature (25°C) and pressure when consistent proportions of soil gas and meteoric water percolating through the vadose zone are trapped within elongate vacuoles. This study corroborates that T h measurements on two phase inclusions in vadose cements can be misleading evidence of thermal diagenesis, even if the measurements are well grouped.

Geochimica et Cosmochimica Acta↗

Carbonate porosity versus depth: A predictable relation for south Florida

This study examines the porosity of limestones and dolomites in the South Florida basin. Porosity data are derived from borehole-gravity measurements and from suites of acoustic, neutron, and density logs. Both types of wire-line measurements sample large volumes of rock relative to petrographic methods and can be examined at vertical scales approaching those of aquifers and hydrocarbon reservoirs. Investigation depths range from the surface to about 18,000 ft (5,500 m) and span the transition from high-porosity near-surface carbonate sediments of Pleistocene age to much denser Mesozoic carbonate rocks with porosities of only a few percent. Carbonate porosity in the South Florida basin was affected by a variety of diagenetic processes. However, a number of factors that could complicate porosity-depth relations are of limited importance in southern Florida. The basin contains little clastic material; present depths of burial are about equal to maximum depths of burial; the influences of tectonism, geopressures, and hydrocarbon accumulations are minimal. Curves of porosity versus depth, reflecting large-scale porosity-loss processes in the subsurface, are derived for a composite carbonate section and for carbonate strata of different ages and compositions. The decrease of porosity with depth for a composite carbonate section representing a wide range of depositional environments and subsequent diagenetic histories can be characterized by the exponential function ^phgr = 41.73e -z 8197/ (ft) [^phgr = 41.73e -z 2498/ (m)], where ^phgr is the porosity (%) and z is the depth below ground level (feet or meters). Average porosity is reduced by a factor of two in a depth interval of about 5,700 ft (1,740 m). Carbonate strata of different ages that are buried to equal depths show no systematic porosity differences. This implies that the effect of time on porosity in these rocks is probably subordinate to that of burial depth. The data also show a faster than expected rate of porosity decrease with depth for rocks of Eocene age and younger. If it is assumed that the decrease in the volume of evaporites in these rocks indicates less saline pore fluids, porosity loss in shallow-water carbonates may be inversely related to the magnesium content of pore waters. Dolomite porosity is lower than limestone porosity in the near surface, but does not decrease as rapidly with depth. Below about 5,600 ft (1,700 m), dolomite is more porous than limestone. It is hypothesized that most dolomitization occurred relatively early and either reduced original porosity or selectively favored lower-porosity limestones. With continued burial, dolomite was more resistant than limestone to associated porosity-reducing effects.

Florida↗

Fresh-water cementation of a 1,000-year-old oolite

Calcite cementation of aragonite ooid sand is producing oolite on Joulters Cays, Bahamas. During the last 1,000 years, calcite cement has formed at an average rate of between 27 and 55 cm 3 /m 3 /yr and is derived from dissolution of ooid aragonite in fresh water. The dissolution-reprecipitation of carbonate minerals in the aquifer results in ground waters of unusually high Sr content. Sea water and mixtures of fresh and sea water appear to inhibit cementation. A pronounced cement fabric change occurs across the water table and has produced an obvious petrographic record of fresh-water diagenesis. Above the water table, cement is typically near grain contact positions, where water is held by capillarity; below the water table, cement is more randomly distributed around grains. At the water table a transition zone, 1 meter thick, marks the boundary between cement textures. No porosity reduction is associated with cementation; calcite cement precipitation is apparently compensated by an equal or greater amount of aragonite dissolution in the interval undergoing cementation. Permeability is more variable above the water table than below it, reflecting early channelling of flow patterns in the vadose zone. Effective permeability below the water table is one to two orders of magnitude higher than above the water table because of entrained gas in the vadose zone. This permeability difference promotes preservation of unstable minerals above the water table and continued diagenetic alteration below the water table.

Joulters Cays↗

Estimating pore and cement volumes in thin section

Point count estimates of pore, grain and cement volumes from thin sections are inaccurate, often by more than 100 percent, even though they may be surprisingly precise (reproducibility + or - 3 percent). Errors are produced by: 1) inclusion of submicroscopic pore space within solid volume and 2) edge effects caused by grain curvature within a 30-micron thick thin section. Submicroscopic porosity may be measured by various physical tests or may be visually estimated from scanning electron micrographs. Edge error takes the form of an envelope around grains and increases with decreasing grain size and sorting, increasing grain irregularity and tighter grain packing. Cements are greatly involved in edge error because of their position at grain peripheries and their generally small grain size. Edge error is minimized by methods which reduce the thickness of the sample viewed during point counting. Methods which effectively reduce thickness include use of ultra-thin thin sections or acetate peels, point counting in reflected light, or carefully focusing and counting on the upper surface of the thin section.

Journal of Sedimentary Petrology↗

Topographic control and accumulation rate of some Holocene coral reefs: south Florida and Dry Tortugas

Core drilling and examination of underwater excavation on 6 reef sites in south Florida and Dry Tortugas revealed that underlying topography is the major factor controlling reef morphology. Carbon-14 dating on coral recovered from cores enables calculation of accumulation rates. Accumulation rates were found to range from 0.38 m/1000 years in thin Holocene reefs to as much as 4.85 m/1000 years in thicker buildups. Cementation and alteration of corals were found to be more pronounced in areas of low buildup rates than in areas of rapid accumulation rates. Acropora palmata, generally considered the major reef builder in Florida, was found to be absent in most reefs drilled. At Dry Tortugas, the more than 13-meter thick Holocene reef did not contain A. palmata. The principal reef builders in this outer reef are the same as those which built the Pleistocene Key Largo formation, long considered to be fossilized patch reef complex.

Florida↗

Recent and relict topography of Boo Bee patch reef, Belize

Five core borings were taken on and around Boo Bee Patch Reef to better understand the origin of such shelf lagoon reefs. The cores reveal 4 stages of development: (1) subaerial exposure of a Pleistocene "high" having about 8 meters of relief, possibly a Pleistocene patch reef; (2) deposition of peat and impermeable terrigenous clay 3 meters thick around the high; (3) initiation of carbonate sediment production by corals and algae on the remaining 5 meters of hard Pleistocene topography and carbonate mud on the surrounding terrigenous clay; and (4) accelerated organic accumulation on the patch reef. Estimates of patch reef sedimentation rates (1.6 m/1000 years) are 3 to 4 times greater than off-reef sedimentation rates (0.4-0.5 m/1000 years). During periods of Pleistocene sedimentation on the Belize shelf, lagoon patch reefs may have grown above one another, stacking up to form reef accumulation of considerable thickness.

Conference Paper↗