Geology Reports⌕ Search

USGS · 70129660

Fresh-water cementation of a 1,000-year-old oolite

Abstract

Calcite cementation of aragonite ooid sand is producing oolite on Joulters Cays, Bahamas. During the last 1,000 years, calcite cement has formed at an average rate of between 27 and 55 cm 3 /m 3 /yr and is derived from dissolution of ooid aragonite in fresh water. The dissolution-reprecipitation of carbonate minerals in the aquifer results in ground waters of unusually high Sr content. Sea water and mixtures of fresh and sea water appear to inhibit cementation. A pronounced cement fabric change occurs across the water table and has produced an obvious petrographic record of fresh-water diagenesis. Above the water table, cement is typically near grain contact positions, where water is held by capillarity; below the water table, cement is more randomly distributed around grains. At the water table a transition zone, 1 meter thick, marks the boundary between cement textures. No porosity reduction is associated with cementation; calcite cement precipitation is apparently compensated by an equal or greater amount of aragonite dissolution in the interval undergoing cementation. Permeability is more variable above the water table than below it, reflecting early channelling of flow patterns in the vadose zone. Effective permeability below the water table is one to two orders of magnitude higher than above the water table because of entrained gas in the vadose zone. This permeability difference promotes preservation of unstable minerals above the water table and continued diagenetic alteration below the water table.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R. B. Halley, P. M. Harris. 1979. Fresh-water cementation of a 1,000-year-old oolite. https://doi.org/10.1306/212f7892-2b24-11d7-8648000102c1865d

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Role of microbial processes in linking sandstone diagenesis with organic-rich clays

Numerous chemical reactions within clay sequences have been proposed to produce dissolved material for diagenesis of deeply-buried sands. However, reactions responsible for solubilizing inorganic and organic constituents in clays at intermediate depths, and their importance to sandstone diagenesis, have not been evaluated. Results from this study show that the processes of microbial organic-acid production (via fermentation) in clays and microbial organic-acid consumption (via sulfate reduction) in sands effectively link organic-rich clays to sandstone diagenesis in the Black Creek Formation of South Carolina. Diagenetic processes have resulted in the formation of 10 volume percent calcite cement, 0.1 volume percent authigenic pyrite, and 1.5 volume percent secondary porosity in Black Creek sands. However, the distribution of these diagenetic processes is not uniform, resulting in net destruction of porosity in some parts of the sand and net porosity enhancement in other parts. Mass balance-derived rates of microbial organic-acid production (10 (super -5) mmole carbon 1 (super -1) yr (super -1) ) and microbial CO 2 production (4 x 10 (super -5) mmole l (super -1) yr (super -1) ) show that microbial processes can account for all organic carbon in the calcite cements (at least 11% of carbonate carbon based on isotope-balance calculations), all observed authigenic pyrite, and all observed secondary porosity. These findings show that microbial processes can serve to link organic-rich clays with sandstone diagenesis at intermediate depths.

Journal of Sedimentary Petrology↗

Lithofacies analysis of colluvial sediments - an aid in interpreting the recent history of Quaternary normal faults in the Basin and Range Province, western United States

Inferring the frequency and magnitude of past earthquakes from the stratigraphy in exposures of normal-faulted sediments is difficult because colluvial lithofacies assemblages adjacent to faults are complex. Similarities in facies assemblages adjacent to young fault scarps in arid to semiarid areas, such as the Basin and Range province, allow lithofacies to be grouped into two genetic architectural elements: debris and wash elements. Upper and lower facies associations can commonly be recognized within each element. A lithofacies code scheme, similar to those used in the analysis of fluvial and glacial lithofacies sequences, provides a concise way of illustrating lithofacies relations in fault exposures. The source lithology of colluvial lithofacies is shown in the code, and soil-horizon symbols can be included. The architecture of lithofacies assemblages near fault scarps in semiarid areas is explained by a model of colluvial sedimentation in response to a single surface faulting event. Analysis of lithofacies assemblages exposed in three trenches across normal faults in the eastern Basin and Range shows how the model can be used to interpret fault histories. Similar facies analysis methods may be useful in interpreting colluvial sequences formed by non-tectonic processes.

Journal of Sedimentary Petrology↗

Mineralogy of the silt fraction in surficial sediments from the outer continental shelf off southeastern New England

The silt-sized heavy mineral assemblage, which is predominantly detrital, has been concentrated in this fraction by hydraulic factors and ranges between 11.8 wt. % of the silt fraction in the sandy sediments near Georges Bank to 3.4% in the clayey silt deposit south of Martha's Vineyard. By contrast, the sand fraction averages only 1.5% heavy minerals. Lateral variability within the silt-sized heavy mineral assemblage is considerable. Zircon and ilmenite abundances progressively decrease from east to west on the continental shelf off southeastern New England. Conversely, abundances within the amphibole and the epidote groups increase from east to west.

Journal of Sedimentary Petrology↗