Geology ReportsSearch

USGS · wsp2231

Controls on phosphorus mobility in the Potomac River near the Blue Plains wastewater treatment plant

Abstract

The Blue Plains wastewater treatment plant is the largest point source of phosphorus in the Potomac River basin, discharging an average of 2 metric tons of phosphorus into the river each day in 1980. An intensive study of the water and sediments in the vicinity of the treatment plant was conducted in 1979-80 in order to characterize the major factors controlling the mobility of effluent-derived phosphorus in the area. The transport of phosphorus near the treatment plant was found to be affected by the circulation regime, by inorganic adsorption reactions with sediments, and by metabolic uptake and release by phytoplankton. The effect of river discharge on the convective transport of phosphorus near the outfall is significantly reduced by a mid-river shoal area, which confines the flow path of the effluent to an embayment on the eastern side of the river for a distance of 4 kilometers below the outfall. This embayment appears to serve as a sediment trap, where protection from bottom scour during high-flow events has permitted fine-grained sediments to accumulate. Measurements of mean residence time indicate that the effluent leaves the embayment area 21? days after being discharged from the outfall. Measurements of the linear decay constant for the removal of dissolved phosphorus from the water column reveal a diurnal cycle corresponding to the metabolic utilization of phosphorus by phytoplankton. This cyclic removal is superimposed on a constant and noncyclic adsorption of phosphorus by inorganic phases. Forty-eight hour average values of the linear decay constant for dissolved phosphorus in the area range from 0.4 to 1.1 per day. Analyses of bottom sediments indicate that approximately 13 percent of the phosphorus discharged between September 1977 and August 1980 has been retained in the embayment. The primary inorganic phase responsible for phosphorus adsorption is amorphous iron (ferric oxy-hydroxides); amorphous aluminum and clay minerals appear to play secondary roles. The accumulation of sorbed phosphorus in the embayment has been promoted by the deposition of fine-grained sediments enriched in ferric oxy-hydroxides. Conversely, the absence of ferric oxy-hydroxides in coarse-grained sediments near the outfall has facilitated the precipitation of the ferrous phosphate mineral vivianite.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 38.810419613702024° to 38.89383860542579° latitude; -77.07149505615234° to -77.00042724609374° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Hearn. 1985. Controls on phosphorus mobility in the Potomac River near the Blue Plains wastewater treatment plant. https://doi.org/10.3133/wsp2231

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper

Sediment-quality assessment of Franklin D. Roosevelt Lake and the upstream reach of the Columbia River, Washington, 1992

Elevated concentrations of trace elements were found in bed sediment of Lake Roosevelt and the Columbia River, its principal source of inflow. Trace-element concentrations in whole water samples did not exceed criteria for freshwater organisms. Bed sediments of Lake Roosevelt were analyzed for organic compounds associated with wood-pulp waste. Dioxins and furans were found in suspended sediment and water of the Columbia River. Abundance and diversity of benthic invertebrate communities were analyzed.

Water Supply Paper