Geology ReportsSearch

USGS · wsp2208

Streamflow augmentation at Fosters Brook, Long Island, New York — A hydraulic feasibility study

Abstract

A 27-day streamflow augmentation test was conducted in December 1979 at Fosters Brook, near the south shore of Long Island, to investigate the hydraulic feasibility of pumping ground water to supply flow to an ephemeral stream during dry periods. Measurements of soil moisture in the unsaturated zone beneath the streambed indicate that infiltration rate and soil-moisture content are interrelated. Initial infiltration was measured with a neutron logger; the wetting front traversed the unsaturated zone at an average of 11.2 inches per hour and reached the water table in 5.5 hours. Soil moisture in the unsaturated zone ranged from 20 percent at the start of the test to nearly 41 percent, nearly the saturation point, 20 days later. Stream discharge was measured at four sites along the stream channel, and the augmentation rate was monitored continuously at the starting point. Infiltration rates increased steadily in all reaches during the first 12 days of the test, but from the 12th to the 20th day, when discharge was increased by 50 percent, infiltration rates decreased along the two upstream reaches but continued to increase along the three downstream reaches. Infiltration rates remained constant from days 20 through 26. During the first 24 hours of the test, the stream reached a maximum length of 2,050 feet, but after 13 days, it had shortened to 1,300 feet as a result of seepage losses. The relationship between discharge and stream length was linear within the range of discharge investigated (0.54-1.63 cubic feet per second). Ground-water levels rose in response to flow augmentation and reached a maximum rise of about 6.5 feet in a well situated 14 feet from the center of the streambed and 225 feet downstream from the start of the flow. Measured water-level response was compared to levels predicted by a one-dimensional analytical model and a three-dimensional mathematical model; results indicate that ground-water response is determined principally by streambed characteristics and soil-moisture content in the unsaturated zone. Variations in water temperature and in streambed composition had significant effects upon infiltration rates. Changes in water temperature, amount of vegetation, soil-moisture content, and stream stage, combined with local variations in streambed permeability and aquifer conductivity, make accurate prediction of seepage rates virtually impossible at present. Data from this study suggest that site-specific investigations are necessary wherever streamflow augmentation is planned.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.69° to 40.701° latitude; -73.676° to -73.664° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Keith R. Prince. 1984. Streamflow augmentation at Fosters Brook, Long Island, New York — A hydraulic feasibility study. https://doi.org/10.3133/wsp2208

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper

Sediment-quality assessment of Franklin D. Roosevelt Lake and the upstream reach of the Columbia River, Washington, 1992

Elevated concentrations of trace elements were found in bed sediment of Lake Roosevelt and the Columbia River, its principal source of inflow. Trace-element concentrations in whole water samples did not exceed criteria for freshwater organisms. Bed sediments of Lake Roosevelt were analyzed for organic compounds associated with wood-pulp waste. Dioxins and furans were found in suspended sediment and water of the Columbia River. Abundance and diversity of benthic invertebrate communities were analyzed.

Water Supply Paper