Geology ReportsSearch

USGS · wsp1841

Geology and ground water of the Savannah River Plant and vicinity, South Carolina

Abstract

The area described in this report covers approximately 2,600 square miles in west-central South Carolina and includes the site of the Savannah River Plant, a major production facility of the U.S. Atomic Energy Commission. The climate, surface drainage, and land forms of the study area are typical of the southern part of the Atlantic Coastal Plain. Precipitation is normally abundant and fairly evenly distributed throughout the year, and the mean annual temperature is moderately warm (64?F). The major streams that drain the area (the Savannah, Salkehatchie, and Edisto Rivers) have low gradients and flow in a southeasterly direction toward the Atlantic Ocean. Surface features of the area include narrow, flat-bottomed, steep-sided valleys and broad gently rolling interfluvial areas. Those parts of the Coastal Plain included within the report area can be subdivided into the Aiken Plateau, the Congaree Sandhills, and the Coastal Terraces. The area is underlain by a sequence of unconsolidated and partly consolidated sediments of Late Cretaceous, Tertiary, and Quaternary age. The unconsolidated sediments were deposited unconformably on a basement of igneous and metamorphic rocks of Precambrian and Paleozoic age and sedimentary rocks of Triassic age. The basement rocks are similar to the granite-diorite complex of the Charlotte Belt, the metamorphosed rocks of the Carolina Slate Belt, and the consolidated sediments of the Newark Group. The unconsolidated sediments strike about N. 60 ? E. and dip 6-20 feet per mile to the southeast. They form a wedge-shaped mass that increases in thickness toward the southeast to slightly more than 1,200 feet in the vicinity of Allendale, S.C., on the southeast or downdip side of the study area. The oldest or lowermost unconsolidated sedimentary unit, the Tuscaloosa Formation of Late Cretaceous age, is overlain in the subsurface by beds that are also probably Late Cretaceous in age and that herein are named the Ellenton Formation. The Upper Cretaceous deposits are, in turn, overlain by the, McBean Formation and the Congaree(?) Formation of middle Eocene age, the Barnwell Formation of late Eocene age, the Hawthorn Formation of early and middle Miocene age, and by fluvial and marine(?) terrace deposits of Pliocene(?), Pleistocene, and Recent age. In the mapped area, the Congaree(?) Formation includes undifferentiated rocks (mostly Congaree and Barnwell Formations and some Mcbean outliers). (See map explanation.) Structurally, the Upper Cretaceous sediments are overlapped to the northwest by Tertiary deposits. A preliminary geologic map of the general area is included in the report. The principal aquifer in the area is composed of the beds of medium to coarse sand and gravel contained in the Tuscaloosa and Ellenton Formations. Subordinate aquifers include deposits of sand and limestone of Tertiary and Quaternary age. The ground water in the principal aquifer occurs under water-table conditions in the outcrop area of the Tuscaloosa Formation in the northern and western parts of the study area, but it is under artesian pressure downdip in the southern and eastern parts of the study area. Contours drawn on the piezometric surface of the water in the principal aquifer indicate that water is recharged to the aquifer mainly by leakage through the overlying Tertiary formations. Likewise, the piezometric contours show that the outcrop area of the Tuscaloosa Formation functions chiefly as an area of discharge. Doubtless, water is also discharged from the aquifer by moving downdip to areas near the coast where the prevailing hydraulic gradient may favor the upward leakage of water through the upper confining beds. The hydraulic properties of the principal aquifer were determined by a series of pumping tests. The results indicate that the aquifer is highly productive and could supply 15 million gallons per day in the vicinity of the Savannah River Plant without exceeding the available drawdown.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 33.0923° to 33.8751° latitude; -82.0125° to -81.1873° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

George E. Siple. 1967. Geology and ground water of the Savannah River Plant and vicinity, South Carolina. https://doi.org/10.3133/wsp1841

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper

Sediment-quality assessment of Franklin D. Roosevelt Lake and the upstream reach of the Columbia River, Washington, 1992

Elevated concentrations of trace elements were found in bed sediment of Lake Roosevelt and the Columbia River, its principal source of inflow. Trace-element concentrations in whole water samples did not exceed criteria for freshwater organisms. Bed sediments of Lake Roosevelt were analyzed for organic compounds associated with wood-pulp waste. Dioxins and furans were found in suspended sediment and water of the Columbia River. Abundance and diversity of benthic invertebrate communities were analyzed.

Water Supply Paper