Geology Reports⌕ Search

USGS · wsp1776

Geology and ground-water resources of Washington, D.C., and vicinity, with a section on chemical quality of the water

Abstract

The area of this report includes 436 square miles centered about the District of Columbia. The area contains parts of two distinctly different physiographic provinces-the Piedmont and the Coastal Plain. The Fall Line, which separates the Piedmont province on the west from the Coastal Plain Province on the east, bisects the area diagonally from northeast to southwest. Northwest of the Fall Line, deeply weathered igneous and metamorphic rocks are exposed ; to the southeast, these rocks are covered by Coastal Plain sediments; the nonconformity between crystalline rock and sediments dips southeast at an average rate of about 125 feet per mile. The rocks of the Piedmont include: (1) schist, phyllite, and quartzite of the Wissahickon Formation; (2) altered mafic rocks such as greenstone and serpentine; (3) the Laurel Gneiss of Chapman, 1942, and the Sykesville Formation of Jonas, 1928--both probably derived from the Wissahickon ; and (4) later granitic intrusive rocks. Lying upon this basement of hard rocks east of the Fall Line are the generally unconsolidated sediments of the Coastal Plain, which include gravel, sand, and clay, ranging in age from Cretaceous to Recent. These sediments measure only a few inches at their western extremity but thicken to 1,800 feet at the southeast corner of the mapped area. Owing to the great diversity in the geology of the two provinces, the waterbearing characteristics of the rocks also vary greatly. In the Piedmont, ground water occurs under unconfined or water-table conditions in openings and fissures in the hard rocks or in the residual weathered blanket that overlies them. In the Coastal Plain, the shallow wells tap unconfined water, but beneath the upper clay layers the water is contained in the sand and gravel under artesian pressure and must be recovered by deep drilled wells. Wells are of three types--drilled, bored, and dug. Drilled wells furnish a permanent water supply and are the least subject to pollution when properly constructed. Bored or dug wells allow greater storage capacity and are satisfactory for domestic supplies in some locations, but they are polluted easily. If not properly constructed or of sufficient depth, they may fail in dry weather. Ground-water supplies for domestic use, 5 to 10 gpm (gallons per minute), are obtainable in most places. In the Piedmont, recorded yields in drilled wells range from 0.2 to 212 gpm. In the Coastal Plain, wells yield from 1 to 800 gpm. The quality of the ground water in the report area is generally satisfactory for domestic, industrial, and irrigation use. High iron content and corrosiveness are troublesome in places. The water is soft to moderately hard--2 to 175 ppm (parts per million). Water in the Piedmont province is. dominantly the calcium and bicarbonate type; in the Coastal Plain most water is of calcium-magnesium bicarbonate type. In the Piedmont, careful location of wells with respect to the geology (rock type and structure) and to topography usually results in higher yields and may mean the difference between success and failure. In the Coastal Plain, drilled artesian wells are not affected by topography, but the yield obtained depends upon the penetration of a water-bearing sand or gravel bed at sufficient depth. The early settlers obtained water from the springs and streams, and later from dug wells. After Washington was established as the Capital in 1800, water was obtained from public and privately owned wells. Water was piped from some of the springs to government buildings and to private homes and business houses. In 1863 a diversion dam was completed in the Potomac above Great Falls and a conduit was built into the city to furnish a public water supply. This system with modifications has been in use ever since. A new diversion dam and pumping station at Little Falls was put into service in the summer of 1959.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 38.791513° to 38.99511° latitude; -77.1199° to -76.909395° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Paul McKelvey Johnston, D. E. Weaver, Leonard Siu. 1964. Geology and ground-water resources of Washington, D.C., and vicinity, with a section on chemical quality of the water. https://doi.org/10.3133/wsp1776

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper↗

Use of stable isotopes of carbon, nitrogen, and sulfur to identify sources of nitrogen in surface waters in the lower Susquehanna River basin, Pennsylvania

With the exception of sewage and septic effluents, most nitrogen sources and soils contain larger proportions of organic and reduced forms of carbon, nitrogen, and sulfur than inorganic, oxidized forms. In contrast, most surface water and ground water contains larger proportions of dissolved inorganic carbon, nitrogen, and sulfur forms than organic forms. Data indicate that carbon, nitrogen, and sulfur are extensively processed in soils and streams.

Water Supply Paper↗

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper↗