Geology ReportsSearch

USGS · wsp1598

Geology and ground-water resources of the Ahtanum Valley, Yakima County, Washington

Abstract

The Ahtanum Valley covers an area of about 100 square miles in an important agricultural district in central Yakima County, Wash. Because the area is semiarid, virtually all crops require irrigation. Surface-water supplies are inadequate in most of the area, and ground water is being used increasingly for irrigation. The purpose of this investigation was the collection and interpretation of data, pertaining to ground water in the area as an aid in the proper development and management of the water resources. The occurrence and movement of ground water in the Ahtanum Valley are directly related to the geology. The valley occupies part of a structural trough (Ahtanum-Moxee subbasin) that is underlain by strongly folded flow layers of a thick sequence of the Yakima basalt. The upper part of the basalt sequence interfingers with, and is conformably overlying by, sedimentary rocks of the Ellensburg formation which are as much as 1,000 feet thick. These rocks are in turn overlying unconformably by cemented basalt gravel as much as 400 feet thick. Unconsolidated alluvial sand and gravel, as much as 30 feet thick, form the valley floor. Although ground water occurs in each of the rock units within the area, the Yakima basalt and the unconsolidated alluvium yield about three-fourths of the ground water currently used. Wells in the area range in depth from a few feet to more than 1,200 feet and yield from less than 1 to more than 1,030 gallons per minute. Although water levels in water-table wells usually are shallow--often less than 5 feet below the land surface--levels in deeper wells tapping confined water range from somewhat above the land surface (in flowing wells) to about 200 feet below. Wells drilled into aquifers in the Yakima basalt, the Ellensburg formation, and the cemented gravel usually tap confined water, and at least 12 wells in the area flow or have flowed in the past. Ground-water levels fluctuate principally in response to changes in stream levels, variations in the flow of irrigation ditches and in rates of water application, variations in local precipitation, and seasonal differences in withdrawals from wells. Annual fluctuations of levels generally are less than 10 feet except in localities of heavy pumping. Periodic measurements of water levels in two observation wells in the area indicate, locally at least, a persistent decline in artesian pressures in confined basalt aquifers, although the record is too short to show whether withdrawal by pumping has reached, or is nearing, an optimum balance with recharge. The aquifers are recharged by precipitation, by infiltration from streams, and by ground-water underflow into the area. Ground water is discharged by seepage to streams, by evapotranspiration, by springs and seeps at the land surface, and, artificially, by withdrawal from wells. It is estimated that the seepage discharge to the Yakima River from the area studied may range from about 20,000 to 25,000 acre-feet per year. The consumptive waste of ground water by phreatophytes probably exceeds 4,000 acre-feet per year and may represent a large reclaimable source of water in the area. The annual withdrawal of ground water from wells in the area for domestic, industrial, irrigation, public, and stock supplies is estimated to be 6,300 acre-feet. The chemical quality of the ground water generally is satisfactory for most purposes, although the water from many wells is harder than is desirable for domestic use.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 46.493° to 46.575° latitude; -120.924° to -120.457° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

B. L. Foxworthy. 1962. Geology and ground-water resources of the Ahtanum Valley, Yakima County, Washington. https://doi.org/10.3133/wsp1598

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper

Sediment-quality assessment of Franklin D. Roosevelt Lake and the upstream reach of the Columbia River, Washington, 1992

Elevated concentrations of trace elements were found in bed sediment of Lake Roosevelt and the Columbia River, its principal source of inflow. Trace-element concentrations in whole water samples did not exceed criteria for freshwater organisms. Bed sediments of Lake Roosevelt were analyzed for organic compounds associated with wood-pulp waste. Dioxins and furans were found in suspended sediment and water of the Columbia River. Abundance and diversity of benthic invertebrate communities were analyzed.

Water Supply Paper