Geology ReportsSearch

USGS · tem742

Airborne and ground reconnaissance of part of the syenite complex near Wausau, Marathon county, Wisconsin

Abstract

Airborne and ground reconnaissance for radioactive minerals in part of the syenite complex near Wausau, Marathon county, Wis., found 12 radioactive mineral localities. The rocks in the area are of Precambrian age and consist of syenite and nepheline syenite, which have intruded older granite, greenstone, quartzite, and argillite. There are very few outcrops, and much of the bedrock is deeply weathered and covered by residual soil. Thorium-bearing zircon pegatite float was found within the area of syenite and nepheline syenite at four localities. Reddish-brown euhedral to subeuhedral crystals of well-zoned zircon (variety cyrtolite) comprise more than 40 percent of some of the specimens. The radioactive mineral at four localities outside the area of syneites was identified as thorogummite, which occurred in nodular masses in residual soil. Alinement of the thorogummite float and associated radioactivity suggests that the thorogummite has resulted from weathering of narrow veins or pegmatites containing thorium-bearing minerals. Unidentified thorium-bearing minerals were found at three localities, and a specimen of allanite weighing about 2 pounds was found at one locality. Shallow trenches at two of the largest radioactivity anomalies showed that the radioactive material extended down into weathered bedrock. The occurrences might warrant additional physical exploration should there be sufficient demand for thorium. Further reconnaissance in the area would probably result in the discovery of additional occurrences.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 44.937957° to 45.002181° latitude; -89.758701° to -89.655888° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R.C. Vickers. 1955. Airborne and ground reconnaissance of part of the syenite complex near Wausau, Marathon county, Wisconsin. https://doi.org/10.3133/tem742

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

"Granite" exploration hole, Area 15, Nevada Test Site, Nye County, Nevada : interim report, Part C, physical properties

Physical properties measurements including porosity, density, permeability, magnetic susceptibility, and thermal conductivity were made on granite samples from the U-15A 'Granite' exploration borehole, Nevada Test Site, Nye County, Nevada. Porosity values range from 0.4 to 4.8 percent, and density values range from 2.56 to 2.69 g/cc (bulk density) and from 2.66 to 2.72 g/cc (grain density). Permeability of fresh rock from the borehole is probably less than 10 -13 millidarcies. Magnetic susceptibility measurements range from 0.36 to 3.48 x 10 -3 cgs units, and thermal conductivity values range from 5.6 to 8.1 cgs units.

Trace Elements Memorandum

Lithologic log and drilling information for the Marble exploration hole 3, U15 area, Nevada Test Site, Nye County, Nevada

The Marble exploration hole 3 is in the northern part of the Tippipah Spring NE 7-1/2 minute quadrangle at the north end of Yucca Valley (fig.1). The collar elevation of the hole is about 5,316 feet and has the approximate Nevada State coordinates of N. 903,093 and E. 674,870. The hole was drilled to determine the physical and chemical properties of the marble within a radius of 200 feet of a point 950 feet below the surface. The exploration hole is 978 feet deep and was drilled from June 12 to July 8, 1959, by Minerals Engineering Co. of Grand Junction, Colorado, using conventional NX coring equiipment and a Portadrill 2,500 drill rig. Water-base bentonitic mud was used as the drilling fluid in the upper part of the hole. Clear water was used after circulation became unrestorable below 200 feet. The hole was cased from surface to 20 feet. The drilling rate during coring ranged from 2.0 to 19.3 minutes per foot and averaged 4.6 minutes per foot (table 1). The core recovered was excellent in quality and quantity. The average core recovery is 92.7 percent (table 2).

Nevada