Geology ReportsSearch

USGS · tem514

Rosamond Prospect, Kern county, California

Abstract

Small quantities of autunite and gummite (?) occur in tuffaceous sedimentary rocks of the Rosamond formation of Miocene age at the Rosamond prospect. The property is about 10 miles south of Mojave, Jern County, California, in the western Mojave Desert. Examination of the propert in January 1952, by George W. Walker and Luther H. Baumgardner of the U.S. Geological Survey, indicates the the autunite occurs principally as coating on fracture and joint surfaces and, to a less extent, as disseminations in the tuffaceous rocks adjacent to faults. A waxy, reddish-brown, radioactive mineral, here called gummite (?), is found in small quantities on slickensided fault surfaces associated with iron oxides and chlorite (?). The uranium minerals are erratically distributed over an area of about 15 acres. Assay of 12 samples indicate a uranium content ranging from 0.002 to 0.59 percent and an average content of slightly less than 0.08 percent uranium.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 34.7885° to 35.7983° latitude; -120.1942° to -117.6166° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

George W. Walker. 1953. Rosamond Prospect, Kern county, California. https://doi.org/10.3133/tem514

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

"Granite" exploration hole, Area 15, Nevada Test Site, Nye County, Nevada : interim report, Part C, physical properties

Physical properties measurements including porosity, density, permeability, magnetic susceptibility, and thermal conductivity were made on granite samples from the U-15A 'Granite' exploration borehole, Nevada Test Site, Nye County, Nevada. Porosity values range from 0.4 to 4.8 percent, and density values range from 2.56 to 2.69 g/cc (bulk density) and from 2.66 to 2.72 g/cc (grain density). Permeability of fresh rock from the borehole is probably less than 10 -13 millidarcies. Magnetic susceptibility measurements range from 0.36 to 3.48 x 10 -3 cgs units, and thermal conductivity values range from 5.6 to 8.1 cgs units.

Trace Elements Memorandum

Lithologic log and drilling information for the Marble exploration hole 3, U15 area, Nevada Test Site, Nye County, Nevada

The Marble exploration hole 3 is in the northern part of the Tippipah Spring NE 7-1/2 minute quadrangle at the north end of Yucca Valley (fig.1). The collar elevation of the hole is about 5,316 feet and has the approximate Nevada State coordinates of N. 903,093 and E. 674,870. The hole was drilled to determine the physical and chemical properties of the marble within a radius of 200 feet of a point 950 feet below the surface. The exploration hole is 978 feet deep and was drilled from June 12 to July 8, 1959, by Minerals Engineering Co. of Grand Junction, Colorado, using conventional NX coring equiipment and a Portadrill 2,500 drill rig. Water-base bentonitic mud was used as the drilling fluid in the upper part of the hole. Clear water was used after circulation became unrestorable below 200 feet. The hole was cased from surface to 20 feet. The drilling rate during coring ranged from 2.0 to 19.3 minutes per foot and averaged 4.6 minutes per foot (table 1). The core recovered was excellent in quality and quantity. The average core recovery is 92.7 percent (table 2).

Nevada