Geology Reports⌕ Search
Home/Archive/USGS

USGS · tem222

Garo uranium deposits, Park County, Colorado

Garland B. Gott
View original source ↗Read source document ↗Export metadata ↓

Abstract

The uranium deposits, three-fourths of a mile south of Garo, Park County, Colo., were mined over 30 years ago for radium ore. The old workings are now abandoned and inaccessible. Forty tons of ore that contained 1.0 percent uranium are reported to have been mined from two light-gray sandstone beds that are stratigraphically about 100 feet apart. The minerals reported to occur in these sandstones are carnotite, malachite, azurite, calciovolborthite, and volborthite. The deposits are in close proximity to a radioactive cherty limestone which is one foot thick, that contains as much as 0.01 percent uranium. The uranium in the carnotite and the uranium in the chert may be genetically related. Mr. ¥. H. Gaddis of Hartsel, Colo., has recently attempted to reopen some of the workings, but as of April 1951 this operation had not revealed any significant new data. Future prospecting should be initiated in the two sandstone beds that have been mineralized. The chert can be used as a marker bed in correlating the sandstones from one exposure to another.

Explore related subjects

Trace Elements MemorandumReport
90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 38.6931° to 39.5682° latitude; -106.2102° to -105.3282° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Garland B. Gott. 1951. Garo uranium deposits, Park County, Colorado. https://doi.org/10.3133/tem222

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS1960

"Granite" exploration hole, Area 15, Nevada Test Site, Nye County, Nevada : interim report, Part C, physical properties

Physical properties measurements including porosity, density, permeability, magnetic susceptibility, and thermal conductivity were made on granite samples from the U-15A 'Granite' exploration borehole, Nevada Test Site, Nye County, Nevada. Porosity values range from 0.4 to 4.8 percent, and density values range from 2.56 to 2.69 g/cc (bulk density) and from 2.66 to 2.72 g/cc (grain density). Permeability of fresh rock from the borehole is probably less than 10 -13 millidarcies. Magnetic susceptibility measurements range from 0.36 to 3.48 x 10 -3 cgs units, and thermal conductivity values range from 5.6 to 8.1 cgs units.

Trace Elements Memorandum↗
USGS1959

Lithologic log and drilling information for the Marble exploration hole 3, U15 area, Nevada Test Site, Nye County, Nevada

The Marble exploration hole 3 is in the northern part of the Tippipah Spring NE 7-1/2 minute quadrangle at the north end of Yucca Valley (fig.1). The collar elevation of the hole is about 5,316 feet and has the approximate Nevada State coordinates of N. 903,093 and E. 674,870. The hole was drilled to determine the physical and chemical properties of the marble within a radius of 200 feet of a point 950 feet below the surface. The exploration hole is 978 feet deep and was drilled from June 12 to July 8, 1959, by Minerals Engineering Co. of Grand Junction, Colorado, using conventional NX coring equiipment and a Portadrill 2,500 drill rig. Water-base bentonitic mud was used as the drilling fluid in the upper part of the hole. Clear water was used after circulation became unrestorable below 200 feet. The hole was cased from surface to 20 feet. The drilling rate during coring ranged from 2.0 to 19.3 minutes per foot and averaged 4.6 minutes per foot (table 1). The core recovered was excellent in quality and quantity. The average core recovery is 92.7 percent (table 2).

Nevada↗