Geology Reports⌕ Search
Home/Archive/USGS

USGS · tem121

Apache Trail uranium prospect, White Signal district, Grant County, New Mexico

Herman L. Bauer
View original source ↗Read source document ↗Export metadata ↓

Abstract

The Apache Trail uranium prospect in the White Signal district, Grant County. N. Mex., was mapped by the Geological Survey in May 1950. Pre-Cambrian granite is cut by a diabase dike and a parallel quartz-hematite vein, both of which strike easterly and dip 60 to 65 degrees north. Small quantities of copper carbonates and bismuth-gold ore have been mined. The quartz-hematite vein is moderately radioactive and, although no uranium minerals were seen, two samples contained about 0.01 percent uranium. The diabase dike locally contains torbernite. Two samples of diabase contained about 0.04 percent uranium.

Explore related subjects

Trace Elements MemorandumReport
90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 32.591913° to 32.607387° latitude; -108.367767° to -108.334208° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Herman L. Bauer. 1951. Apache Trail uranium prospect, White Signal district, Grant County, New Mexico. https://doi.org/10.3133/tem121

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS1960

"Granite" exploration hole, Area 15, Nevada Test Site, Nye County, Nevada : interim report, Part C, physical properties

Physical properties measurements including porosity, density, permeability, magnetic susceptibility, and thermal conductivity were made on granite samples from the U-15A 'Granite' exploration borehole, Nevada Test Site, Nye County, Nevada. Porosity values range from 0.4 to 4.8 percent, and density values range from 2.56 to 2.69 g/cc (bulk density) and from 2.66 to 2.72 g/cc (grain density). Permeability of fresh rock from the borehole is probably less than 10 -13 millidarcies. Magnetic susceptibility measurements range from 0.36 to 3.48 x 10 -3 cgs units, and thermal conductivity values range from 5.6 to 8.1 cgs units.

Trace Elements Memorandum↗
USGS1959

Lithologic log and drilling information for the Marble exploration hole 3, U15 area, Nevada Test Site, Nye County, Nevada

The Marble exploration hole 3 is in the northern part of the Tippipah Spring NE 7-1/2 minute quadrangle at the north end of Yucca Valley (fig.1). The collar elevation of the hole is about 5,316 feet and has the approximate Nevada State coordinates of N. 903,093 and E. 674,870. The hole was drilled to determine the physical and chemical properties of the marble within a radius of 200 feet of a point 950 feet below the surface. The exploration hole is 978 feet deep and was drilled from June 12 to July 8, 1959, by Minerals Engineering Co. of Grand Junction, Colorado, using conventional NX coring equiipment and a Portadrill 2,500 drill rig. Water-base bentonitic mud was used as the drilling fluid in the upper part of the hole. Clear water was used after circulation became unrestorable below 200 feet. The hole was cased from surface to 20 feet. The drilling rate during coring ranged from 2.0 to 19.3 minutes per foot and averaged 4.6 minutes per foot (table 1). The core recovered was excellent in quality and quantity. The average core recovery is 92.7 percent (table 2).

Nevada↗