Geology Reports⌕ Search

USGS · sir20235023

Sediment transport in two tributaries to the San Joaquin River immediately below Friant Dam—Cottonwood Creek and Little Dry Creek, California

Abstract

Two tributaries to the greater San Joaquin River watershed, Cottonwood and Little Dry Creeks, in California’s Central Valley, were assessed for sediment and streamflow dynamics between October 1, 2011, and September 30, 2019. The two systems deliver sediment to the San Joaquin River below Friant Dam, California. Dams create downstream discontinuities in streamflow and sediment transport and therefore influence fish habitat and sediment dynamics. Because these two creeks are directly downriver from Friant Dam, they become the most upstream source of sediment to the San Joaquin River below Friant Dam. The quality and quantity of spawning habitat for fish in the gravel-bedded reach of the San Joaquin River relies on a range of bed material particle size suitable for redd structure. The effects of coarse-sand to fine-gravel supply on salmonid habitat depends primarily on the size of the sediment and the timing of its addition from tributaries to the San Joaquin River; thus, understanding the timing, quantity, and size of sediment supplied from these two tributaries is critical to the management of ecological and biological sustainability. Streamflow from Cottonwood and Little Dry Creeks, along with streamflow from the San Joaquin River below Friant Dam, were compared to continuously measured water-surface elevations to quantify the timing and direction of streamflow. Suspended-sediment samples were collected with multiple automatic samplers and analyzed for concentration and grain-size distribution. Measured suspended-sediment concentrations and streamflows were used to develop sediment rating curves and compute continuous estimates of suspended-sediment load for each tributary. Satellite imagery was used to qualify spatial and temporal dynamics through the lower watersheds and support more quantitative sediment-load estimates. Computed annual sediment loads ranged from 1.32x10 1 to 2.68x10 4 metric tons for Little Dry Creek and 9.82 to 1.98x10 3 metric tons for Cottonwood Creek. Sediment loads computed during the study period for both watersheds show that annual loads were highest during water year 2017 (October 1, 2016, to September 30, 2017). Sediment transport primarily occurred between the months of January and March. In both tributaries, grain-size distributions of suspended sediment were predominantly coarse-sized sand and were finer than the remnant bed material. Both creeks demonstrate backwater effects from the San Joaquin River, but the more tortuous stream channel and historical mining pits within Little Dry Creek provide more capacity for sediment storage compared to the less complex stream network of Cottonwood Creek. Because loads were computed based on upstream streamgages and not at the confluence of each tributary to the San Joaquin River, annual load estimates do not represent direct flux into the San Joaquin River; instead, these results indicated that in Little Dry Creek, particularly, the lowest portion of the watershed stores sediment before it reaches the San Joaquin River.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 36.75° to 37.1667° latitude; -119.833333° to -119.375° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Dan R.W. Haught, Mathieu D. Marineau, Justin Toby Minear, Scott Wright, Joan V. Lopez. 2023-05-02. Sediment transport in two tributaries to the San Joaquin River immediately below Friant Dam—Cottonwood Creek and Little Dry Creek, California. https://doi.org/10.3133/sir20235023

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

Scientific Investigations Report↗

Groundwater budget for the Portneuf River Basin, southeastern Idaho

The U.S. Geological Survey, in cooperation with the Idaho Department of Water Resources, developed the first groundwater budget for the upper Portneuf River Basin in southeastern Idaho, a tributary of the Snake River. A groundwater budget for the Portneuf River Basin supports water resource and administrative management decisions within the basin and for downstream users of the eastern Snake River Plain aquifer. The analysis quantifies inflows, outflows, and residuals for an aquifer system defined by the Idaho Department of Water Resources under three recent precipitation conditions: an average year (2016), a dry year (2021), and a wet year (2023). The budget was calculated for the basin and for two subbasins delineated by the U.S. Geological Survey streamgage Portneuf River at Topaz, Idaho (13073000): the above Topaz subbasin, which includes the Portneuf-Gem valley, and the below Topaz subbasin, which includes Marsh Valley. Aquifer inflows include mountain-front recharge; areal recharge; recharge from applied water, including recharge from irrigation, canal seepage, and effluent returns; groundwater flow into the basin; and reservoir seepage. Outflows include groundwater pumping for agricultural, municipal, and domestic uses; subsurface outflow through the Portneuf gap; and discharge to streams as base flow. Estimated annual inflows for the full basin ranged from 116,880 acre-feet in 2021 to 154,880 acre-feet in 2023, and outflows ranged from 132,190 acre-feet in 2016 to 158,490 acre-feet in 2023. Basinwide residuals, the change in storage plus uncertainty, were −2,410 acre-feet in 2016, −18,410 acre-feet in 2021, and −3,610 acre-feet in 2023, and each subbasin had a mixture of negative and positive residuals. These basinwide results, interpreted as change in storage plus water-budget uncertainty, indicate minor net losses that increase with dry conditions, consistent with well depth-to-water measurements indicating gradual multi-decadal declines. Patterns in subbasin residuals are driven by irrigation practices and surface-water management; for example, the above Topaz subbasin relies more on groundwater for irrigation, resulting in more negative residuals during dry years. In contrast, the below Topaz subbasin depends more on surface water, producing positive residuals during dry years because of irrigation losses and canal seepage. The analyses for both subbasins indicate decades-long groundwater declines, which agree with the overall negative residuals calculated. The largest sources of uncertainty include climate inputs (precipitation and evapotranspiration) and poorly constrained components such as groundwater inflow and tributary stream infiltration. These findings provide insight into how climatic variables and irrigation practices affect groundwater inflows and outflows within the Portneuf River Basin.

Idaho↗

World minerals outlook—Antimony, copper, graphite, niobium, potash, silicon, silver, and tungsten through 2030

Demand for mineral commodities continues to increase owing to rapid technological advancements and global economic growth. To support this increase in demand, information about current and near-term supplies of these mineral commodities is essential. Such data help evaluate the health and stability of global supply chains and protect against potential supply risks. Current production and production capacity data coupled with information regarding near-term expected changes (such as facility closures, planned expansions, or the completion of new mineral production projects) can provide insight into expected future market developments and expected available supply of mineral commodities. This report within the “World Minerals Outlook” series analyzes data for antimony, copper, natural graphite, niobium, potash, silicon metal, silver, and tungsten—eight mineral commodities listed in the 2025 List of Critical Minerals. World production data from 2019 through 2025, as well as estimated world capacity data from 2023 through 2025 were analyzed. Using these data, near-term (2026–2030) expected world capacities were estimated. For antimony, copper, niobium, silicon metal, silver, and tungsten, modest increases in production capacity of 4 to 10 percent were expected between 2025 and 2030, whereas capacities for natural graphite and potash were expected to increase by about 18 to 20 percent.

Scientific Investigations Report↗