Geology Reports⌕ Search

USGS · sir20225026

Depth to water and water quality in groundwater wells in the Ogallala aquifer within the North Plains Groundwater Conservation District, Texas Panhandle, 2019–20, and comparison to 2012–13 conditions

Abstract

The Ogallala aquifer is the primary source of water for agricultural and municipal purposes in the Texas Panhandle. Because most of the groundwater in the Texas Panhandle is withdrawn from the Ogallala aquifer, information on the quality of groundwater in the Ogallala aquifer in this part of Texas is useful for resource characterization. During 2012–13, the U.S. Geological Survey in cooperation with the North Plains Groundwater Conservation District (NPGCD), collected and analyzed water-quality samples from 30 groundwater monitoring wells in the Texas Panhandle. The results of the initial 2012–13 synoptic sampling were published in 2014 to help provide an initial characterization of the spatial and temporal variability of water quality in the NPGCD management area. This report documents the results of a followup synoptic sampling completed between March 2019 and July 2020 by the U.S. Geological Survey, in cooperation with the NPGCD, to further characterize the spatial and temporal characteristics of groundwater in the NPGCD management area; measurements of the depth to water, in feet below land surface, and water-quality samples were obtained from the same 30 monitoring wells that were sampled during 2012–13. The water-quality samples were analyzed for major ions, nutrients, trace elements, and selected organic compounds. Results from the 2019–20 synoptic sampling were compared to drinking-water standards and to the results from the 2012–13 synoptic sampling. Between the 2012–13 and 2019–20 sampling periods, the depth to water increased in 28 of the 30 wells, with a median difference of 18.17 feet. Results from major ion analyses indicate that most of the groundwater samples collected during 2019–20 were classified as magnesium-bicarbonate type, the same water type indicated for most samples during 2012–13. Dissolved-solids concentrations for the wells sampled during 2019–20 ranged from 260 to 774 milligrams per liter (mg/L) with a median dissolved-solids concentration of 316 mg/L, which was slightly higher than the median dissolved-solids concentration of 311 mg/L for the 2012–13 sampling period. Of the four nutrients analyzed, nitrate was the dominant nitrogen species, with a median nitrate concentration of 2.25 mg/L for the 2019–20 sampling period, which was a slight increase relative to the median nitrate concentration of 2.05 mg/L for the 2012–13 sampling period. Accounting for variability in analyses, median major ion concentrations and median concentrations for nutrient species were similar during the 2012–13 and 2019–20 sampling periods. None of the trace element concentrations exceeded any maximum contaminant level or secondary drinking-water standards. Median concentrations of trace elements from the 2012–13 sampling period were compared to those from the 2019–20 sampling period for constituents in cases where at least 50 percent of concentrations measured in the samples were detected at concentrations greater than the highest applicable laboratory reporting level, and variability in analyses was accounted for. Comparison results indicated that that median concentrations of two trace elements (lithium and uranium) increased, whereas median concentrations for two of the other trace elements measured (barium and molybdenum) decreased. Atrazine and deethylatrazine were the only organic compounds detected; both were detected in four of the six samples collected from different wells and analyzed for organic compounds. Concentrations of atrazine and deethylatrazine detections were all less than 0.05 micrograms per liter.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 35.36217605914681° to 36.474306755095235° latitude; -103.062744140625° to -99.986572265625° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Craig A. Mobley, Patricia B. Ging. 2022-04-29. Depth to water and water quality in groundwater wells in the Ogallala aquifer within the North Plains Groundwater Conservation District, Texas Panhandle, 2019–20, and comparison to 2012–13 conditions. https://doi.org/10.3133/sir20225026

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Karst hydrologic processes in carbonate fensters of the western Great Smoky Mountains, Tennessee, 2017–18

The geology of the Great Smoky Mountains in Tennessee and North Carolina is dominated by metamorphic strata. Along the western extent of the range, however, several carbonate fensters expose the Ordovician Jonesboro Limestone along the western edge of the Great Smoky Fault. The fensters (Cades Cove, Tuckaleechee Cove, and Wear Cove) create opportunities for allogenic recharge at the contact between the surrounding, relatively insoluble, strata and the underlying soluble formations, resulting in the development of karst systems. Karst environments have a high degree of connectivity between surface streams and groundwater systems; thus, karst aquifers are inherently vulnerable to contamination from surface activities. Karst environments also provide a specific environment for sensitive biota. Protection of the unique resources of karst environments requires an understanding of the behavior of karst aquifers, knowledge of karst recharge areas, and the mapping of groundwater flow paths. A study began in 2017 to characterize the hydrologic behavior of the karst systems in Great Smoky Mountains National Park through hydrologic monitoring, dye tracing, and seepage investigations. Hydrologic monitoring equipment was installed at several karst hydrogeologic features: two in-cave sites, two major springs, Abrams Creek in Cades Cove, and a karst depression wetland. Dye tracing was conducted to determine resurgences for the cave systems, to delineate spring recharge areas, and to estimate karst groundwater velocities. Seepage investigations along Abrams Creek helped determine if streams were sinking into the Jonesboro Limestone, either at the contact with insoluble strata or as streams flowed across the carbonate fenster. Study results indicate considerable differences in groundwater behavior between the conduit-dominated flow systems in Tuckaleechee Cove compared to the lower-gradient, colluvium-covered karst systems in Cades Cove. Study results also indicate that contaminants in the area of Bull sink and Whiteoak Sink could be rapidly transported through karst groundwater towards springs in Tuckaleechee Cove. Karst resources in Cades Cove are most likely to be affected by local events or activities taking place within the cove itself or in upper Abrams Creek upstream of the Great Smoky Fault. This study provides information on the vulnerability and uniqueness of the karst systems in the western Great Smoky Mountains, which are characterized by complex geology, high-gradient subterranean streams, deep caves, and carbonate fensters.

Tennessee↗

Analysis of groundwater geochemistry in the Lansing, Michigan, area

Groundwater resources in the Lansing, Michigan, area are protected by a wellhead protection plan, but previous studies have indicated that groundwater in this area may be susceptible to surface contamination. The U.S. Geological Survey, in cooperation with the Lansing Board of Water & Light, analyzed geochemical and aquifer characteristics to assess the potential for contamination of groundwater resources. Recharge age categories were determined from tritium concentrations for some wells, and by using ternary diagrams and principal component analysis for other wells. These age classifications, combined with hydrogeologic and geochemical data, were analyzed by using statistical methods to identify trends that may indicate areas of increased groundwater susceptibility. Wells with modern recharge tended to have higher sodium, chloride, and chloride:bromide ratios than did wells with mixed recharge, suggesting greater surface connectivity and potential influence from anthropogenic sources such as road salt. In contrast, wells in the mixed age category exhibited more stable geochemistry and lower constituent concentrations. Classification and regression tree models identified aquifer geometry—particularly the thickness of the uppermost bedrock unit and presence of confining layers—as key predictors of recharge age and geochemical indicators. The trends identified from these analyses could help to reveal locations in the Lansing area that are among the most susceptible to contamination.

Michigan↗

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

California, Idaho, Nevada, Oregon, Utah↗