Geology Reports⌕ Search

USGS · sir20205072

Quality of pesticide data for groundwater analyzed for the National Water-Quality Assessment Project, 2013–18

Abstract

The National Water-Quality Assessment (NAWQA) Project of the U.S. Geological Survey (USGS) submitted nearly 1,900 samples collected from groundwater sites across the United States in 2013–18 for analysis of 225 pesticide compounds (pesticides and pesticide degradates, hereafter referred to as “pesticides”) by USGS National Water Quality Laboratory schedule 2437 (S2437). For the associated NAWQA study of pesticide occurrence and concentration in groundwater, and for other studies using pesticide results determined by S2437, it is necessary to assess the ability of reported results to meet data-quality requirements that will allow study objectives to be achieved. This assessment of the quality of S2437 results reported in 2013–18 examined data from field and laboratory quality-control samples, along with third-party performance assessment samples, to estimate bias and variability and to identify their potential sources, with an emphasis on implications for the interpretation of pesticide data for groundwater. Results indicate that measurements produced by the S2437 method for most pesticides have bias and variability that would be considered acceptable for many interpretative studies, which could therefore use the results without qualification or censoring. However, the reported data for a subset of pesticides have the potential for unacceptable contamination bias, high or low recovery bias, or high variability as a consequence of method performance and (or) nonlaboratory factors that could preclude their use for certain common objectives or could necessitate adjustment or qualification to meet those objectives. Based on data for laboratory blanks, censoring of some detections for a subset of pesticides reported by the laboratory in environmental samples might be necessary or desirable to avoid an unacceptably high likelihood of a false-positive result caused by laboratory contamination. The 90-percent upper confidence limit for the 95th percentile of laboratory blank concentration equals or exceeds the minimum reported groundwater concentration in at least 1 water year for 28 pesticides. During at least 1 water year, this upper confidence limit exceeds the maximum laboratory detection limit for 17 pesticides and exceeds the maximum laboratory reporting limit for 3 pesticides (ametryn, atrazine, and diazinon). The level of contamination indicated by this upper confidence limit should not substantially affect the suitability of reported environmental concentrations for any compound for comparison with corresponding human-health benchmarks. Despite being subjected to the same laboratory processes as laboratory blanks, field blanks indicated little evidence of contamination bias. This observation could largely be the consequence of data-reporting practices, which utilize detections in laboratory blanks to censor results in associated field samples (including blanks and environmental samples) when relative concentrations indicate that a result could have a substantial contribution from laboratory contamination. Laboratory censoring appears likely to reduce the risk of false-positive results in environmental samples below the level that laboratory blank results alone would imply. Whereas data available for third-party blind blank samples analyzed in 2018 indicate that only propoxur had any false-positive results, data for pesticides that were not spiked into blind spike samples analyzed in 2013–18 indicate that the false-positive rates for 31 pesticides exceeded 1 percent when considering only detections reported at concentrations greater than the maximum detection limit. Although about half of these pesticides lack substantial supporting evidence of contamination bias based on laboratory blank or field blank detections, indicating that spiking issues or degradation of parent compounds within the spiked samples might be a contributing factor to some false-positive results, these results indicate the need to closely examine detections reported for some pesticides in environmental samples analyzed during a similar period for possible contributions from contamination bias. Data for blind spike samples that were spiked at concentrations above the maximum reporting limit indicate that false-negative rates for eight pesticides exceed 10 percent; substantial low bias could affect results reported for these pesticides in environmental samples analyzed during a similar period. Data for laboratory reagent spikes, which measure recovery of pesticides in blank water, show little evidence for unacceptable recovery bias for S2437 pesticides. However, field matrix spikes, which measure recovery of pesticides in environmental matrices, indicate that degradation and (or) matrix effects could result in moderate to substantial low bias for groundwater results for several pesticides. Low bias could cause some reported concentrations to be categorized as being below a benchmark when the actual concentration in groundwater is greater than the benchmark. Occurrence and concentrations in groundwater could be substantially underrepresented for six pesticides with benchmarks (1H-1,2,4-triazole, asulam, bifenthrin, cis-permethrin, fenbutatin oxide, and naled) that have median recoveries between zero and 50 percent in field matrix spikes. Two compounds (didealkylatrazine and 2-hydroxy-6-ethylamino-4-amino-s-triazine) have median recoveries near or greater than 150 percent in field matrix spikes, indicating a substantial high bias. Plots of data for all spike types show clear changes in the typical recovery with time for some pesticides, which would require further examination for evaluation of temporal trends in environmental concentrations. Data for laboratory reagent spikes indicate that nearly all S2437 pesticides have acceptable variability resulting from random measurement error. Only two compounds (fenbutatin oxide and naled) have F-pseudosigma values greater than 30 percent for recovery, which implies the potential for relatively high variability in reported concentrations and could affect comparison of concentrations to benchmarks and determination of whether concentrations for samples collected at separate locations or times are truly different with a specified level of confidence. Data for third-party blind spike samples show relatively high variability for a greater number of pesticides, although these results likely reflect the influence of degradation and (or) differences in the magnitude and variability of concentrations used for blind spikes relative to laboratory reagent spikes. Detailed analysis of variability using field replicate data is possible for only 12 pesticides on S2437; low variability in analyte detection and concentration is indicated for most of these pesticides in groundwater.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 25.08° to 49.38905° latitude; -124.68721° to -66.96466° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Laura M. Bexfield, Kenneth Belitz, Mark W. Sandstrom, Delicia Beaty, Laura Medalie, Bruce D. Lindsey, Lisa H. Nowell. 2020-07-27. Quality of pesticide data for groundwater analyzed for the National Water-Quality Assessment Project, 2013–18. https://doi.org/10.3133/sir20205072

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Slip tendency and dilation tendency of Quaternary faults in the Great Basin region, Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming

This report presents the results of slip tendency and dilation tendency analysis of Quaternary faults in the Great Basin region, in the states of Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming. This effort was undertaken as part of two studies: the U.S. Department of Energy Geothermal Technologies Office-funded Innovative Geothermal Exploration through Novel Investigations of Undiscovered Systems (INGENIOUS) project, which is a multidisciplinary, multi-institution effort to develop new methodologies and best practices to accelerate the discovery of new, commercially viable hydrothermal resources; and the U.S. Geological Survey Geothermal Resources Investigations Project. The goal of this work is to identify faults and fault segments that are appropriately oriented to be stress-loaded for slip or to dilate under the ambient stress conditions. Both conditions may make such faults more likely to host permeability and fluid flow relative to other faults in the region. Slip tendency and dilation tendency were calculated for all fault segments in the study area from the U.S. Geological Survey Quaternary Fault and Fold Database. Results demonstrate that faults with high slip tendency and dilation tendency are common in the Great Basin region. The areas containing many high slip tendency and dilation tendency fault segments are associated with high strain rates. These areas also host a relatively high proportion of the known hydrothermal systems. This indicates that faults with high slip tendency and dilation tendency in areas with high strain-rate are potentially most prospective for hosting hydrothermal systems. The database published in coordination with this report contains the slip tendency and dilation tendency results data, including the fault geometry and stress data used to calculate these quantities, for both the Great Basin study area and the smaller INGENIOUS study area.

Arizona, California, Idaho, Nevada, Oregon, Utah, ↗

A spatial analysis of the groundwater emergence flood hazard in Long Island, New York, and coastal areas surrounding Long Island Sound in New York, Connecticut, and Rhode Island

Long Island, New York, and nearby coastal areas surrounding Long Island Sound are densely populated and, like other coastal areas, are susceptible to flooding from several potential sources, including stormwater from precipitation events, tidal flooding and storm surge, and groundwater emergence flooding. Groundwater emergence fooding refers to the intersection of a rising water table with land surface or critical infrastructure. Many studies of flood drivers either neglect or only briefly discuss how shallow groundwater conditions may contribute to or exacerbate flood conditions. As a part of a comprehensive study of compound flood hazards in the coastal areas of Long Island and Long Island Sound, a spatial analysis was completed by the U.S. Geological Survey, in cooperation with the Environmental Protection Agency’s Long Island Sound Partnership, formerly called the Long Island Sound Study, using available regional datasets to characterize the potential hazard for groundwater emergence flooding. The approximately 3,100 square mile study area was subdivided into 11,407 grid cells that were 900 meters by 900 meters (approximately 3,000 feet by 3,000 feet), for the purpose of integrating the spatial datasets to calculate and map the groundwater emergence flood hazard. The depth to the water table, hydrologic soil groups, and National Land Cover Database were harmonized to the common grid. A groundwater emergence flood hazard score was calculated for each grid cell for current average conditions following a set of rules accounting for the depth to the water table and the percentage of area within each cell with slow infiltrating soils. A scenario with a higher sea-level position was also calculated for the Long Island part of the study area. The calculated groundwater emergence flood hazard score was reviewed in conjunction with the National Land Cover Database to identify developed areas and associated infrastructure that may be at risk of potential groundwater emergence flooding. Study results indicate that the groundwater emergence flood hazard is highest in coastal areas and near surface water where the water table is close to ground surface. Inland areas away from surface waterbodies are not likely to be exposed to groundwater emergence flooding. For Long Island, in the scenario with higher sea-level position, a greater groundwater emergence flood hazard is calculated for some locations closer to the coast and where land is submerged. Away from the coast and surface-water drainage, the groundwater emergence flood hazard is similar between the current average sea-level condition and the higher sea-level position scenario.

Connecticut, New York, Rhode Island↗

Streamflow assessment of Birch Creek, southern boundary of the Blackfeet Indian Reservation, Pondera County, northwestern Montana—Synoptic and continuous streamflow measurements through 2022

The U.S. Geological Survey, in cooperation with the Blackfeet Water Department, performed this study to assist water-resource managers in understanding and quantifying irrigation diversions, instream flows, and the spatial and temporal streamflow dynamics of Birch Creek in northwestern Montana. Birch Creek forms the southernmost boundary of the Blackfeet Indian Reservation and is highly valued culturally as an aquatic life and wildlife resource and as a principal source of water for irrigation. The study area included Birch Creek from Swift Dam to 53.3 miles downstream just above its confluence with the Two Medicine River. The study period was calendar year 2022, but selected historical information was also included in the study. Birch Creek streamflow originates through releases from Swift Reservoir, with the largest releases typically occurring during the irrigation season (May–October) to primarily meet the needs of downstream irrigators. This study included the compilation and collection of (1) continuous streamflow measured at streamgages installed for this study, (2) instantaneous streamflow measurements made during four synoptic events, and (3) reported daily values of Swift Reservoir outflow and irrigation diversions. Continuous streamflow data were available from two U.S. Geological Survey streamgages: Birch Creek below Heart Butte Road, near Heart Butte, Montana (upper streamgage; station 06094900), at river mile 12.9 and Birch Creek at Bullhead Bridge near Valier, Mont. (lower streamgage; station 06098120), at river mile 53.3. The upper streamgage (station 06094900) was primarily affected by the regulated releases from Swift Dam with daily mean streamflow typically slightly higher than the reported Swift Reservoir outflows. Daily mean streamflow ranged from 9.87 cubic feet per second (ft 3 /s) (November 18, 2022) to 640 ft 3 /s (June 22, 2022) during September 16, 2021–December 31, 2022. The mean annual streamflow was 122 ft 3 /s in water year 2022 (a water year is the 12-month period from October 1 to September 30 and is designated by the year in which it ends), about 13 percent greater than the mean annual reported Swift Reservoir outflows. The lower streamgage (station 06098120) was downstream from all major tributaries and diversions within the Birch Creek drainage basin. Daily mean streamflow ranged from 6.02 ft 3 /s (September 8, 2022) to 95.0 ft 3 /s (June 5, 2021) during August 26, 2020–December 31, 2022. Mean annual streamflow was 27.8 ft 3 /s for water year 2022. Flows at the lower streamgage (station 06098120) were typically lower than at the upper streamgage (station 06094900) from late April to early October, whereas flows from early October to late spring were similar to or greater than those at the upper streamgage. The upper streamgage had a total streamflow volume of 87,960 acre-feet (acre-ft) for water year 2022, whereas the lower streamgage had a total streamflow of 20,357 acre-ft. A net volume of about 67,603 acre-ft was removed from Birch Creek through diversions, losses to groundwater, and evapotranspiration along that reach during water year 2022. Most of the changes in main-stem streamflow could be accounted for by the tributary inflows or diversion outflows. The most dynamic streamflow gains and losses occurred along the upper few miles of Birch Creek. Streamflow was consistently lost to the groundwater system immediately below Swift Dam and then returned to levels that slightly exceeded the outflow at the dam near river mile 11.0. The overall net gains for the entire 53.3-mile study reach ranged from 15.5 to 42.6 ft 3 /s among the synoptic events. On several occasions, streamflow fell below minimum instream flow conditions specified in the Blackfeet Compact (water rights compact among the Blackfeet Tribe, State of Montana, and United States), which are subject to a 15-year deferral period (until June 12, 2033). Notably, a section of Birch Creek immediately downstream from Swift Dam was completely dry during the October 18, 2022, synoptic event.

Montana↗