Geology Reports⌕ Search

USGS · sir20185082

Preliminary groundwater salinity mapping near selected oil fields using historical water-sample data, central and southern California

Abstract

The distribution of groundwater salinity was mapped for 31 oil fields and adjacent aquifers and summarized by 8 subregions across major oil-producing areas of central and southern California. The objectives of this study were to describe the distribution of groundwater near oil fields having total dissolved solids less than 10,000 milligrams per liter (mg/L) based on available data and to document where data gaps exist. Salinity was represented by the measured or calculated concentration of total dissolved solids (TDS) in samples of produced water obtained from petroleum wells and groundwater obtained from water wells. The water chemistry data were used to estimate the minimum depths of TDS greater than 3,000 mg/L and greater than 10,000 mg/L in areas near selected oil fields using historical water-chemistry data coupled with available well-location and construction information. The 10,000 mg/L threshold, representing the highest level of TDS concentration of water that could be considered as a potential source of drinking water, was present in all but 4 (Jasmin, Kern Bluff, Kern Front, and Mount Poso) of the 31 individual oil fields. Among petroleum wells, the median TDS concentration of produced water ranged from 500 mg/L for the Jasmin field to 32,636 mg/L for the Elk Hills field. Among water wells, median TDS concentrations, either reported or calculated from specific conductance, ranged from 151 mg/L for wells within 2 miles of the Ten Section field to 9,750 mg/L for wells within 2 miles of the combined North and South Belridge fields. In general, TDS across the eight geographic subregions increased with depth, but the relation of TDS with depth varied regionally. The most pronounced increases in TDS with depth were across the West Kern Valley Floor and West Kern Valley Margin subregions on the west side of the San Joaquin Valley, and in the vicinity of the Wilmington field in the Los Angeles Basin subregion; in these areas, relatively high TDS concentrations greater than 10,000 mg/L were present within the upper few hundred to several thousand feet of land surface. Total dissolved solids concentrations increased more gradually with depth in the Middle Kern Valley Floor subregion, in the South Kern Valley Margin subregion, in the vicinity of the Montebello and Santa Fe Springs fields in the Los Angeles Basin subregion, and in the Central Coast Basin subregion. The Kern Sierran Foothills and East Kern Valley Floor subregions, on the east side of the San Joaquin Valley, had the most gradual increases in TDS with depth. Fields in the East Kern Valley Floor subregion generally had groundwater and produced water with TDS less than 10,000 mg/L that extended to a large depth compared to most other subregions. Overall, the west side of the San Joaquin Valley in Kern County and the Wilmington field in Los Angeles County generally have the highest TDS values and the shallowest depths to high TDS. High TDS at relatively shallow depths on the west side of the San Joaquin Valley may be because of a combination of natural conditions and anthropogenic factors. In the vicinity of the Wilmington field in the Los Angeles Basin subregion, high TDS at relatively shallow depths is attributable at least in part to seawater intrusion. Fields on the east side of the San Joaquin Valley in Kern County have the lowest TDS and greatest depths to TDS greater than 10,000 mg/L because of their geologic setting adjacent to Sierra Nevada recharge areas. Reconnaissance salinity mapping was limited by several factors. The primary limitation was the lack of well-construction data for a significant number of water wells. Bottom perforation, well depth, or hole depth were not available for 35 percent of wells used for salinity mapping. A second limitation was variability in data quality. Total dissolved solids and specific conductance data were compiled from different data sources with varying degrees of documentation that ranged from comprehensive to very little or none. As a result, it was not always possible to assess the quality of the provided data with respect to either conditions at each well during sampling or the methodology used for sample collection and analysis. A third limitation was the lack of wells, either petroleum or water, and associated TDS data over large vertical intervals for some fields. As a result, the distribution of salinity and the depths at which TDS concentration exceeds the 3,000 and 10,000 mg/L thresholds could not always be precisely determined. This analysis highlights key gaps that need to be filled with additional analysis of other sources of information, such as borehole geophysical logs and new water sample or geophysical data collection.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 33.280027811732154° to 36.5° latitude; -120.75622558593749° to -118° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Loren F. Metzger, Matthew K. Landon. 2018-07-24. Preliminary groundwater salinity mapping near selected oil fields using historical water-sample data, central and southern California. https://doi.org/10.3133/sir20185082

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Baseline water-quality inventory and summary for the Paterson Great Falls National Historical Park, New Jersey

The Paterson Great Falls National Historical Park (PAGR), established in 2011 in the City of Paterson, New Jersey, contains many cultural, historical, and natural resources. Because of the PAGR’s young age and limited resources, a long record of natural resource data is not available for use to guide future park management and planning decisions. A detailed natural resource inventory was identified as an immediate need in the “Foundation Document—Paterson Great Falls National Historical Park,” given the history of extensive industrial activity throughout the PAGR and the Passaic River Basin. The U.S. Geological Survey, in cooperation with the National Park Service and the Urban Waters Federal Partnership for the Lower Passaic River, inventoried water-quality monitoring efforts and compiled historical water-quality data from secondary data sources to define baseline conditions in the PAGR and the surrounding study area. This report documents the methods used to harmonize water-quality data aggregated from multiple sources for the PAGR study area. Procedures implemented during data harmonization include compiling data from multiple sources, assessing the dataset for completeness, addressing metadata concerns, and creating a consistent and quality-assured dataset for future analysis. The harmonized dataset contains 14 aggregated surface-water sites, 1,103 individual sampling days, and 32,000 water-quality records throughout the period of record defined for this study (1952–2021). Summary statistics and comparison to water-quality criteria are provided for focus parameters that can support PAGR management, including field properties, suspended material, total dissolved solids, specific conductance, chloride, sulfate, Escherichia coli, nutrients, contaminants of concern related to fish consumption advisories, and litter and floatable debris. A spatial data gap was identified for the recreational area near the base of the Great Falls and immediately downstream from a known combined sewer overflow discharge location. Analytic data gaps were identified for continuous streamflow and water-quality parameters, floatable debris characterization, and harmful algal blooms identification. Continuous collection of contaminants of concern was identified as a temporal data gap, as these parameters were not consistently collected within the study area. The water-quality data synthesis and summary presented in this report can assist PAGR staff in understanding the complex baseline water resources within the study area and can serve as a baseline to design future water-quality monitoring efforts and evaluate changes in water quality over time. The harmonized dataset, as well as future New Jersey Department of Environmental Protection and New Jersey Harbor Discharge Group monitoring data and assessments, can also be used to examine the status and trends in surface-water quality, support compliance with the Clean Water Act (33 U.S.C. 1251 et seq.), and further investigate changes to park water resources that can affect ecological and human health.

New Jersey↗

Slip tendency and dilation tendency of Quaternary faults in the Great Basin region, Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming

This report presents the results of slip tendency and dilation tendency analysis of Quaternary faults in the Great Basin region, in the states of Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming. This effort was undertaken as part of two studies: the U.S. Department of Energy Geothermal Technologies Office-funded Innovative Geothermal Exploration through Novel Investigations of Undiscovered Systems (INGENIOUS) project, which is a multidisciplinary, multi-institution effort to develop new methodologies and best practices to accelerate the discovery of new, commercially viable hydrothermal resources; and the U.S. Geological Survey Geothermal Resources Investigations Project. The goal of this work is to identify faults and fault segments that are appropriately oriented to be stress-loaded for slip or to dilate under the ambient stress conditions. Both conditions may make such faults more likely to host permeability and fluid flow relative to other faults in the region. Slip tendency and dilation tendency were calculated for all fault segments in the study area from the U.S. Geological Survey Quaternary Fault and Fold Database. Results demonstrate that faults with high slip tendency and dilation tendency are common in the Great Basin region. The areas containing many high slip tendency and dilation tendency fault segments are associated with high strain rates. These areas also host a relatively high proportion of the known hydrothermal systems. This indicates that faults with high slip tendency and dilation tendency in areas with high strain-rate are potentially most prospective for hosting hydrothermal systems. The database published in coordination with this report contains the slip tendency and dilation tendency results data, including the fault geometry and stress data used to calculate these quantities, for both the Great Basin study area and the smaller INGENIOUS study area.

Arizona, California, Idaho, Nevada, Oregon, Utah, ↗

A spatial analysis of the groundwater emergence flood hazard in Long Island, New York, and coastal areas surrounding Long Island Sound in New York, Connecticut, and Rhode Island

Long Island, New York, and nearby coastal areas surrounding Long Island Sound are densely populated and, like other coastal areas, are susceptible to flooding from several potential sources, including stormwater from precipitation events, tidal flooding and storm surge, and groundwater emergence flooding. Groundwater emergence fooding refers to the intersection of a rising water table with land surface or critical infrastructure. Many studies of flood drivers either neglect or only briefly discuss how shallow groundwater conditions may contribute to or exacerbate flood conditions. As a part of a comprehensive study of compound flood hazards in the coastal areas of Long Island and Long Island Sound, a spatial analysis was completed by the U.S. Geological Survey, in cooperation with the Environmental Protection Agency’s Long Island Sound Partnership, formerly called the Long Island Sound Study, using available regional datasets to characterize the potential hazard for groundwater emergence flooding. The approximately 3,100 square mile study area was subdivided into 11,407 grid cells that were 900 meters by 900 meters (approximately 3,000 feet by 3,000 feet), for the purpose of integrating the spatial datasets to calculate and map the groundwater emergence flood hazard. The depth to the water table, hydrologic soil groups, and National Land Cover Database were harmonized to the common grid. A groundwater emergence flood hazard score was calculated for each grid cell for current average conditions following a set of rules accounting for the depth to the water table and the percentage of area within each cell with slow infiltrating soils. A scenario with a higher sea-level position was also calculated for the Long Island part of the study area. The calculated groundwater emergence flood hazard score was reviewed in conjunction with the National Land Cover Database to identify developed areas and associated infrastructure that may be at risk of potential groundwater emergence flooding. Study results indicate that the groundwater emergence flood hazard is highest in coastal areas and near surface water where the water table is close to ground surface. Inland areas away from surface waterbodies are not likely to be exposed to groundwater emergence flooding. For Long Island, in the scenario with higher sea-level position, a greater groundwater emergence flood hazard is calculated for some locations closer to the coast and where land is submerged. Away from the coast and surface-water drainage, the groundwater emergence flood hazard is similar between the current average sea-level condition and the higher sea-level position scenario.

Connecticut, New York, Rhode Island↗