Summary of the hydrogeology of the Valley and Ridge, Blue Ridge, and Piedmont Physiographic Provinces in the eastern United States

Lindsay A. Swain; Thomas O. Mesko; Este F. Hollyday

doi:10.3133/pp1422a

Home/Archive/USGS

USGS · pp1422A

Summary of the hydrogeology of the Valley and Ridge, Blue Ridge, and Piedmont Physiographic Provinces in the eastern United States

Lindsay A. Swain·Thomas O. Mesko·Este F. Hollyday

View original source ↗Read source document ↗Export metadata ↓

Abstract

The Appalachian Valley and Piedmont Regional Aquifer-System Analysis study (1988-1993) analyzed rock types in the 142,000-square-mile study area, identified hydrogeologic terranes, determined transmissivity distributions, determined the contribution of ground water to streamflow, modeled ground-water flow, described water quality, and identified areas suitable for the potential development of municipal and industrial ground-water supplies. Ground-water use in the Valley and Ridge, the Blue Ridge, and the Piedmont Physiographic Provinces exceeds 1.7 billion gallons per day. Thirty-three rock types in the study area were analyzed, and the rock types with similar water-yielding characteristics were combined and mapped as 10 hydrogeologic terranes. Based on well records, the interquartile ranges of estimated transmissivities are between 180 to 17,000 feet squared per day (ft 2 /d) for five hydrologic terranes in the Valley and Ridge; between 9 to 350 ft 2 /d for two terranes in the Blue Ridge; and between 9 to 1,400 ft 2 /d for three terranes in the Piedmont Physiographic Province. Based on streamflow records, the interquartile ranges of estimated transmissivities for all three physiographic provinces are between 290 and 2,900 ft 2 /d. The mean ground-water contribution to streams from 157 drainage basins ranges from 32 to 94 percent of mean streamflow with a median of 67 percent. In three small areas in two of the physiographic provinces, more than 54 percent of ground-water flow was modeled as shallow and local. Although ground-water chemical composition in the three physiographic provinces is distinctly different, the water generally is not highly mineralized, with a median dissolved-solids concentration of 164 milligrams per liter, and is mostly calcium, magnesium, and bicarbonate. Based on aquifer properties and current pumpage, areas favorable for the development of municipal and industrial ground-water supplies are underlain by alluvium of glacial origin near the northeastern part of the study area, by clay-free carbonate rocks primarily in the Valley and Ridge Physiographic Province, and by siliciclastic rocks in the three northernmost Mesozoic basins.

Explore related subjects

Professional Paper Report

Source-reported bounding extent: 32.84267363195431° to 41.902277040963696° latitude; -87.73681640625° to -73.916015625° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Lindsay A. Swain, Thomas O. Mesko, Este F. Hollyday. 2004. Summary of the hydrogeology of the Valley and Ridge, Blue Ridge, and Piedmont Physiographic Provinces in the eastern United States. https://doi.org/10.3133/pp1422a

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Resurvey of the Marble Canyon and Bridge Canyon dam sites in Grand Canyon National Park—Changes in sediment storage and evidence supporting the occurrence of bedrock incision through the mid-20th century

The Bureau of Reclamation developed an extensive plan for a network of dams, water tunnels, and hydropower plants in and around Grand Canyon, Arizona, in the 1940s through 1960s. The two largest of these planned dams were the Marble Canyon and Bridge Canyon Dams on the Colorado River. Though these dams were ultimately never built, Reclamation conducted extensive topographic, bathymetric, and subsurface exploration work at the sites proposed for these dams in the 1940s and 1950s. Resurveys of these dam sites were conducted between 1998 and 2021 to determine the changes in sediment storage at these dam sites caused by the upstream construction and operation of Glen Canyon Dam and by the recession of Lake Mead, the reservoir impounded by Hoover Dam. The resurveys of the Marble Canyon dam sites indicate that the post-1950s changes in sediment storage at these dam sites are broadly consistent with flux-based estimates of voluminous sand erosion from Marble Canyon since the 1963 closure of Glen Canyon Dam. These resurveys also suggest that the pre-dam longitudinal variation in sediment thickness over bedrock played a key role in determining the locations of the sand erosion induced by Glen Canyon Dam; more sand eroded from locations where more sand was present in the 1950s. The resurvey of the Bridge Canyon dam sites indicates that the Colorado River’s incision of the Lake Mead delta is regulated both by bed-sediment grain size and downstream hydraulic controls. Finally, analyses of bed-sediment thickness and sedimentological data at the dam sites, and observations of bed scour and gravel transport, suggest that sufficient bedrock was exposed to allow bedrock incision during commonly recurring pre-dam snowmelt floods that entrained small boulders into transport.

Arizona↗

USGS2026

The eruptive behavior of distributed volcanism forming low shield edifices—A case study of Sentinel-Arlington volcanic field, U.S.A.

Distributed volcanic fields are present in various tectonic settings worldwide, and their characteristics reflect differing influences from magmatic and tectonic processes. In the southwestern United States alone, there are 37 Quaternary distributed volcanic fields. After the primary period of extensional tectonics in the southern Basin and Range 15–5 million years ago, the Sentinel-Arlington volcanic field developed in southwestern Arizona between 4 and 1 million years ago. The Sentinel-Arlington volcanic field consists primarily of low relief shield volcanoes, a type of distributed volcanism with poorly understood temporal evolution. The Sentinel-Arlington volcanic field is less than 200 kilometers (km) from the Colorado Plateau, Gulf of California, and southern San Andreas Fault system. This work identifies and examines controls on the emplacement of the Sentinel-Arlington volcanic field by documenting shallow and surficial structures as well as eruption characteristics and style through time. The Sentinel-Arlington volcanic field consists of 21 volcanoes with a total of 33 vents over an area of about 770 square kilometers (km 2 ). The prominence of low relief shield volcanoes may be explained by ascent of basaltic magmas through thin Basin and Range crust, without much crustal contamination, and low viscosities common to mafic compositions. Typical eruption characteristics involve the construction of low relief shield volcanoes followed by Strombolian fissure eruptions at the summits or near-summit medial areas that produce scoria lapilli, which may weld to form agglomerate. The total lifetime erupted volume of about 4.3 cubic kilometers (km 3 ) represents an average eruptive flux of approximately 2x10 -3 km 3 per thousand years (k.y.). This erupted volume is low relative to Neogene basaltic intraplate distributed volcanic fields worldwide, which typically range from 10 -3 to 1 km 3 k.y. -1 . Sentinel-Arlington volcanic field eruptions were likely triggered by intermittent rejuvenation of transient magmatic zones that exist in thinned crust. Instantaneous flux from point sources feeding the lava flows is estimated to be on the order of 10 -1 to 10 cubic meters per second.

Arizona↗

USGS2026

Capitalization of positional (Lower/Middle/Upper) and temporal (Early/Middle/Late) adjectives in the names of formal chronostratigraphic and geochronologic units of the Phanerozoic

Many authors are understandably confused about the capitalization of the words “lower,” “middle,” “upper,” “early,” and “late.” Where these words are used simply as descriptive adjectives, they should be in lowercase; where they form the first word of a formal chronostratigraphic or geochronologic unit name, they should be in uppercase.

Professional Paper↗