Geology Reports⌕ Search

USGS · ofr7456

Stratigraphy and nahcolite resources of the saline facies of the Green River Formation, Rio Blanco County, Colorado

Abstract

Based on a study of 10 drill cores, a sequence of oil shale and associated nahcolite, nearly 2,000 feet thick, in the lacustrine Green River Formation (Eocene) in the Piceance Creek basin, Rio Blanco County, Colo., was divided in ascending order into zones 1 to 13, B-groove, Mahogany zone (with lower, middle, and upper parts), and A-groove at the top. The odd-numbered zones and the Mahogany zone are mappable subsurface units of relatively thick oil shale and are distinguished from the even-numbered zones and A- and B-grooves which are thinner units of oil shale of lower grade. Large amounts of nahcolite found in zones 5 to 12 occur in (1) coarse-grained crystalline aggregates scattered through oil shale, (2) laterally continuous units of fine-grained crystals disseminated in oil shale, (3) brown microcrystalline beds, and (4) white coarse-grained beds that grade laterally into halitic rocks toward basin center. The original .upper limit of the nahcolite and halitic rocks is not yet completely known, but the present top is marked by a dissolution surface. Above this surface the rocks, extending from zones 11 or 12 upward into the Mahogany zone, form a water-saturated 'leached zone,' a geohydrologic unit in which large amounts of water-soluble minerals probably mostly nahcolite, and halite, were removed by ground-water dissolution. Rocks in the leached zone, mostly oil shale, are commonly broken and fractured and contain crystal cavities and solution breccias. Several solution breccias can be traced laterally into unleached beds of nahcolite and halite. Although evidence of salines is found in rocks above A-groove, the original saline facies that includes most of the bedded deposits extends from zone 5 upward into A-groove. Potentially ruinable beds of white nahcolite as much as 12 feet thick are found at depths of 1,560 or more feet below the surface. Some thicker beds of high-grade nahcolite are believed to be too close to the dissolution surface for safe room-and-pillar mining. Probably the most economical method of mining nahcolite would be as a coproduct of a shale-oil industry. Removal of nahcolite prior to retorting increases significantly the grade of oil shale by as much as 1.6 times, Several zones are more than 300 feet thick and average 30 or more weight percent nahcolite. Resources of nahcolite per square mile range as high as 489 million short tons. The total nahcolite resource in the basin is conservatively estimated at 32 billion short tons, which makes it the secondlargest deposit of sodium carbonate known .in the world.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

John R. Dyni. 1974. Stratigraphy and nahcolite resources of the saline facies of the Green River Formation, Rio Blanco County, Colorado. https://doi.org/10.3133/ofr7456

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

ECCOE Landsat quarterly calibration and validation report—Quarter 2, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 2 (April–June), 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov.

Open-File Report↗

ECCOE Landsat quarterly calibration and validation report—Quarter 1, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 1 (January–March) of 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov . One specific activity that the ECCOE Landsat Cal/Val Team closely monitored was a Landsat 8 Thermal Infrared Sensor encoder alerts anomaly. On March 18, 2026, the Thermal Infrared Sensor instrument’s mechanism control electronics board reset, driving several parameters to default power-on values. Subsequent telemetry and analysis determined that no persistent hardware misconfiguration was present and no radiometric or geometric degradation was observed.

Open-File Report↗

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗