Geology Reports⌕ Search

USGS · ofr72218

Clay deposits of the Connecticut River Valley, Connecticut: a special problem in land management

Abstract

When man first settled the United States, two natural features favored settlement; flat land that was easy to build on and to farm, and a nearby river that could act as a source of water, transportation, and power. The Connecticut River Valley from Middletown, Ct. north past the Connecticut-Massachusetts state line satisfied these two needs, and was favored by many early Americans in New England. This area remains an area of rapid urbanization, partly because of the broad flat lowlands. The subdued topography of this area is due in large part to deposition of fine-grained materials into glacial Lake Hitchcock. This lake was formed during the Wisconsinan age when southward drainage in the Triassic valley of Connecticut was dammed by glacial drift in the area of Rocky Hill, Connecticut. Lake Hitchcock grew to and beyond St. Johnsbury, Vt. with much of the lake being filled with cyclical lake-bottom deposits during the 2,290 to 2,350 years of its life. Aside from the relative flatness inherent in the deposition of fine-grained lake-bottom deposits, these deposits present very few characteristics that are favorable for urbanization. Favorable characteristics are possible sources of clay for manufacturing and possible sources for waste storage sites. Unfavorable characteristics include low water yields resulting in poor urban water-supply sources, and very low flows in streams during dry periods; low percolation rates resulting In drainage and septic problems; and low or uneven bearing strength which create problems in construction. Fine-grained lake-bottom deposits have been mapped for six quadrangles in the Connecticut Valley lowlands; the quadrangles of Windsor Locks, Broad Brook, Hartford North, Manchester, Hartford South, and Glastonbury (all located in Connecticut). All the maps were prepared from existing information including well and test hole data on file at the Water Resources Division in Hartford, surficial geologic quadrangle maps, and bedrock contour maps. The maps also reflect geologic interpretations of the history of glacial Lake Hitchcock. The Hartford North maps were prepared as test maps to determine if the project was feasible. They were prepared using the previously described information plus additional subsurface data obtained from engineering firms and the State Highway Department. During preparation of the maps, an arcuate-shaped, ice-contact deposit composed of coarse sand and gravel was delineated in the Broad Brook and Windsor Locks quadrangles. This feature marks the location of a zone of stagnant ice In front of and marginal to active ice to the north. Two types of maps were prepared for the area in study; Thickness of the Principal Clay Deposit, and Thickness of Material Overlying the Principal Clay Deposit. The term "principal clay deposit" refers to the fine-grained lake-bottom deposits of Glacial Lake Hitchcock. These maps define the distribution of the deposit, and show the thickness of the deposit in 50 foot intervals and the thickness of the material overlying the deposit In 20 foot intervals. The maps indicate that much of the area is underlain with substantial thicknesses of finegrained lake-bottom deposits (50 feet thick or greater), and that much of the deposit is within 20 feet of the surface. The maps included in this report can be used for land-use planning. Uses include location of favorable sites for specific uses such as landfills, utility corridors, heavy construction, etc; location of problem areas for specific land uses; identification of possible problems for specific areas; design and construction cost estimates; and prospecting for exploitable clay deposits. It Is suggested that, for effective planning, these maps be used together or in conjunction with other maps such as maps showing surface materials, depth to bedrock, depth to water table, and flood prone areas.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 41.625° to 42° latitude; -72.75° to -72.5° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

William H. Langer. 1972. Clay deposits of the Connecticut River Valley, Connecticut: a special problem in land management. https://doi.org/10.3133/ofr72218

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

ECCOE Landsat quarterly calibration and validation report—Quarter 2, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 2 (April–June), 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov.

Open-File Report↗

ECCOE Landsat quarterly calibration and validation report—Quarter 1, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 1 (January–March) of 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov . One specific activity that the ECCOE Landsat Cal/Val Team closely monitored was a Landsat 8 Thermal Infrared Sensor encoder alerts anomaly. On March 18, 2026, the Thermal Infrared Sensor instrument’s mechanism control electronics board reset, driving several parameters to default power-on values. Subsequent telemetry and analysis determined that no persistent hardware misconfiguration was present and no radiometric or geometric degradation was observed.

Open-File Report↗

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗