Preliminary bedrock geologic map of the Port Henry quadrangle, Essex County, New York, and Addison County, Vermont

Abstract

Introduction The bedrock geology of the 7.5-minute Port Henry quadrangle consists of deformed and metamorphosed Mesoproterozoic gneisses of the Adirondack Highlands unconformably overlain by weakly deformed lower Paleozoic sedimentary rocks of the Champlain Valley. The Mesoproterozoic rocks occur on the eastern edge of the Adirondack Highlands and represent an extension of the Grenville Province of Laurentia. Mesoproterozoic paragneiss, marble, and amphibolite hosted the emplacement of an anorthosite-mangerite-charnockite-granite (AMCG) suite, now exposed mostly as orthogneiss, at approximately 1.18–1.15 Ga (giga-annum). In the Port Henry quadrangle, the AMCG metaigneous rocks (Yhg, Ygb, Yanw) intruded older, mostly metasedimentary rocks of the Grenville Complex during the middle to late Shawinigan orogeny (~1,160–1,150 Ma [mega-annum]). All rocks were subsequently metamorphosed to upper amphibolite to granulite facies conditions during the 1,080–1,050 Ma Ottawan orogeny. New mapping reveals four periods of deformation: (1) D1 produced rarely preserved isoclinal folds in the paragneiss and marble and predates AMCG magmatism. (2) Subsequent D2 deformation produced the dominant gneissic fabric preserved in the rock, recumbent folding, and deformed all the Proterozoic units in the map area. Syn- to late-D2 felsic magmatism resulted in the regionally extensive Lyon Mountain Granite Gneiss, which hosts numerous magnetite ore bodies. (3) Mylonitic extensional shear zones and core complex formation marked the beginning of D3 deformation. Protracted D3 deformation resulted in F3 upright folding, dome and basin formation, pegmatite intrusion, reactivation of the S2 foliation, partial melting, metamorphism, metasomatism, iron-ore remobilization, and intrusion of magnetite-bearing pegmatite both as layer-parallel sills and crosscutting dikes. (4) D4 created northeast- and northwest-trending local high-grade ductile shear zones and boudinage, northwest-trending regional kilometer (km)-wide ductile shear zones, and crosscutting granitic pegmatite dikes. The development of the late-stage regional shear zones (D4) was likely due to the continuation of extensional doming and uplift from upper amphibolite facies conditions at the end of the Ottawan orogeny. The majority of iron-ore deposits in the Port Henry and adjacent Witherbee quadrangles are in the hanging wall of these extensional shear zones. In the Port Henry quadrangle, the km-wide Cheney Mountain shear zone is the result of D4 deformation. Kilometer-scale lineaments readily observed in lidar data are Ediacaran mafic dikes and Phanerozoic brittle faults. The Paleozoic rocks are part of the Early Cambrian to Late Ordovician carbonate bank on the ancient margin of Laurentia. The approximately 1-km-thick Cambrian to Ordovician stratigraphy records a transition from synrift clastics to passive-margin peritidal carbonate buildups to gradually deeper-water subtidal- to shelf-carbonates during foreland basin development associated with the Taconic orogeny. The Paleozoic rocks are weakly folded and block faulted. Large areas of the Champlain Valley are covered by undifferentiated glacial deposits, some of which contain mapped landslides. The map also shows waste rock piles and tailings from historical mining operations. This study was undertaken to improve our understanding of the bedrock geology in the Adirondack Highlands, establish a modern framework for 1:24,000-scale bedrock geologic mapping in the Adirondacks, provide a context for historical iron mines in the eastern Adirondacks, and update the stratigraphy of the Champlain Valley in New York and Vermont. This Open-File Report includes a bedrock geologic map; a description of map units; a correlation of map units; and a geographic information system database that includes bedrock geologic units, faults, outcrops, and structural geologic information.