Geology ReportsSearch

USGS · ofr20161134

Centimeter-scale surface deformation caused by the 2011 Mineral, Virginia, earthquake sequence at the Carter farm site—Subsidiary structures with a quaternary history

Abstract

Centimeter-scale ground-surface deformation was produced by the August 23, 2011, magnitude (M) 5.8 earthquake that occurred in Mineral, Virginia. Ground-surface deformation also resulted from the earthquake aftershock sequence. This deformation occurred along a linear northeast-trend near Pendleton, Virginia. It is approximately 10 kilometers (km) northeast of the M5.8 epicenter and near the northeastern periphery of the epicentral area as defined by aftershocks. The ground-surface deformation extends over a distance of approximately 1.4 km and consists of parallel, small-scale (a few centimeters (cm) in amplitude) linear ridges and swales. Individual ridge and swale features are discontinuous and vary in length across a zone that ranges from about 20 meters (m) to less than 5 m in width. At one location, three fence posts and adjoining rails were vertically misaligned. Approximately 5 cm of uplift on one post provides a maximum estimate of vertical change from pre-earthquake conditions along the ridge and swale features. There was no change in the alignment of fence posts, indicating that deformation was entirely vertical. A broad monoclinal flexure with approximately 1 m of relief was identified by transit survey across surface deformation at the Carter farm site. There, surface deformation overlies the Carter farm fault, which is a zone of brittle faulting and fracturing along quartz veins, striking N40°E and dipping approximately 75°SE. Brecciation and shearing along this fault is interpreted as Quaternary in age because it disrupts the modern B-soil horizon. However, deformation is confined to saprolitized schist of the Ordovician Quantico Formation and the lowermost portion of overlying residuum, and is absent in the uppermost residuum and colluvial layer at the ground surface. Because there is a lack of surface shearing and very low relief, landslide processes were not a causative mechanism for the surface deformation. Two possible tectonic models and one non-tectonic model are considered: (1) tectonic, monoclinal flexuring along the Carter farm fault, probably aseismic, (2) tectonic, monoclinal flexuring related to a shallow (1–3 km) cluster of aftershocks (M2 to M3) that occurred approximately 1 to 1.5 km to the east of Carter farm, and (3) non-tectonic, differential response to seismic shaking between more-rigid quartz veins and soft residuum-saprolite under vertical motions that were created by Rayleigh surface waves radiating away from the August 23, 2011, hypocenter and propagating along strike of the Carter farm fault. These processes are not considered mutually exclusive, and all three support brittle deformation on the Carter farm fault during the Quaternary. In addition, abandoned stream valleys and active stream piracy are consistent with long-term uplift in vicinity of the Carter farm fault.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 37.941667° to 38.008333° latitude; -77.970278° to -77.814444° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Richard W. Harrison, J. Stephen Schindler, Milan J. Pavich, J. Wright Horton, Mark W. Carter. 2016-08-25. Centimeter-scale surface deformation caused by the 2011 Mineral, Virginia, earthquake sequence at the Carter farm site—Subsidiary structures with a quaternary history. https://doi.org/10.3133/ofr20161134

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Special Contributing Area Loading Program user’s manual

Information on the Special Contributing Area Loading Program execution and functions are presented in this user’s manual. An appendix presents a potential improvement for the user to consider. The hydrologic routing simulation method to model flow through multiple reservoirs, or sewer system components, is described. The use of Special Contributing Areas is described to run a successful simulation, which includes user input of hydrologic time series of flow components and the necessary formats. Upon completion of a successful Special Contributing Area Loading Program simulation, the program outputs hydrologic time series and a descriptive text file containing the model results for each defined sub-unit, or Special Contributing Area. The output time series contain flows through, and overflows from, the three reservoirs in the series, and the text file contains input and output path locations.

Open-File Report

Estimating aftershock risk for entry into earthquake-damaged buildings

We present a simple method to estimate the risk of experiencing strong shaking from aftershocks during entry into earthquake-damaged buildings. We compute wait times until the probability of strong ground shaking from aftershocks reaches a predefined risk threshold; for example, a 0.4 percent probability of experiencing Modified Mercalli Intensity 7 or greater shaking during the planned building entry. We also develop a relation between aftershock probability and the probability of strong shaking, so that users can reference the U.S. Geological Survey aftershock forecast during an ongoing aftershock sequence to determine if the risk threshold has been met. We apply our method to active continental regions (for example, the Western United States), stable continental regions (for example, the Central and Eastern United States), and subduction zones (for example, Cascadia or Alaska).

Open-File Report

End-user needs for remote sensing wetlands of the Prairie Pothole Region of North America

The Prairie Pothole Region (PPR) of North America comprises globally important grassland and wetland ecosystems critical for numerous populations of migratory birds. Due to the importance of this region for migratory birds, and particularly waterfowl, and the threats of habitat loss due to intensifying agriculture, there is a mature and diverse system of conservation organizations, agencies, and partnerships that spends hundreds of millions of dollars annually on habitat conservation to support migratory bird populations. Remote sensing can be a powerful tool for observing and evaluating global change at large scales as well as expanding inferences from field studies to the broader landscape with statistical models. However, development and utilization of these tools has lagged behind their demand for several reasons, including concerns over spatial and temporal resolution and accuracy of products; perception of a misalignment with decision-maker needs; technological barriers such as skill sets of conservation professionals, computing resources, data access, and usability. In this report, we summarize the needs of conservation professionals and scientists who use or want to use remote sensing data products to inform science about wetland change and conservation of wetlands in the PPR. We assembled this information through several methods leading up to, during, and following a January 2026 PPR Wetland Remote Sensing Workshop. The workshop included United States and Canadian scientists, conservation professionals, and policy experts. Our goal was to bring together end-users and remote sensing product developers jointly to explore reducing the lag between product development and utilization of products to inform science and conservation. Specifically, we aimed to identify gaps in wetland remote sensing that limit effective monitoring, management, and conservation in the PPR, and to develop a framework that outlines pathways to address these gaps by fostering collaboration, improving communication networks, encouraging discussion, and building on existing and ongoing efforts. This report summarizes our participants’ descriptions of end-user needs and the outcomes of the workshop.

Prairie Pothole region