Geology ReportsSearch

USGS · 70268726

Quantifying the success of stormwater control measure networks using effective imperviousness

Abstract

The deleterious effects of directly-connected impervious surfaces on urban streams have been widely recognized. To deal with these effects, the use of stormwater control measures that aim to disconnect impervious surfaces and prevent stormwater from reaching the stream has surged. However, we lack widespread use of consistent metrics that describe how effective these stormwater control measures are for mitigating the effects of untreated stormwater. Using total impervious area neglects the effect of stormwater control measures whereas directly-connected impervious area assumes that stormwater control measures perform perfectly. Comparing the success of stormwater control measures across many watersheds and cities will require use of consistent metrics of effective imperviousness, describing actual performance of stormwater control measures in reducing impervious areas hydraulically connected to the stream. This work applies two published approaches to quantify effective imperviousness, one that measures the frequency of downstream flow disturbances and another that computes parameters from a paired rainfall-runoff regression analysis. We apply these approaches in two settings: 1) two watersheds with new low impact development in Clarksburg, Maryland, USA and 2) five watersheds with stormwater retrofits in Melbourne, Australia. These methods gave largely similar results, with differences in effective imperviousness ranging from 1%-9%. Using these approaches in Clarksburg, the effective imperviousness for the treatment watersheds was 6–12%, whereas the total imperviousness was 33–44% and the directly-connected imperviousness was 0%. In Clarksburg, effective imperviousness better described stream hydrologic and biotic outcomes compared to either total imperviousness or directly-connected imperviousness. In Melbourne, effective imperviousness was a better metric for hydrologic and water quality changes that are likely to provide ecological benefits. In both cases, new development and retrofits, we demonstrate the utility of effective imperviousness metrics for predicting stream outcomes and how these metrics may be used to understand the success of stormwater control measure using a consistent metric.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Aditi S. Bhaskar, Charles C. Stillwell, Matthew J. Burns, Kristina G. Hopkins, Christopher J. Walsh. 2025-06-30. Quantifying the success of stormwater control measure networks using effective imperviousness. https://doi.org/10.1371/journal.pwat.0000335

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Hydrogeology, groundwater salinity distributions, and assessment of the effect of oil-production activities on groundwater in the Midway Valley area, western Kern County, San Joaquin Valley, California

This study seeks to determine the effects of oil field produced water disposal operations and well mechanical integrity issues on groundwater quality in oil fields in the southwest San Joaquin Valley, California. Whereas previous studies used groundwater wells to study shallow aquifers outside the oil fields, this study demonstrates that future approaches may use oil well geophysical logs to map groundwater head gradients, create salinity profiles and document changes in salinity over time in oil field areas with sparse groundwater well data and at depths greater than 330 m. We also incorporate an analysis of well histories to determine potential effects of compromised wellbore seals on changes in aquifer quality that cannot be explained by water disposal practices. Water quality in the aquifers is naturally brackish across most of the area, with better quality groundwater occurring in the eastern part. Geophysical logs are used to determine salinity variations within aquifers including the depth at which TDS exceeds 10,000 mg/L. This depth ranges from 366 m in the northwest to approximately 1,500 m in the southeast. Oil well porosity logs are used to determine water table elevations. These logs indicate the water table slopes south-southeast, showing the predominant groundwater flow direction is from oil field disposal areas toward better quality groundwater east of the oil fields. Geophysical logs show formation resistivity near some disposal facilities has decreased over time, indicating the salinity of the aquifer has increased due to disposal of saline produced water in injection wells and ponds. Oil well history analysis suggests that increased salinity over time in water-saturated sand intervals >1.5 km from disposal facilities may be caused by mechanical failures and/or incomplete borehole seals in poorly constructed or abandoned wellbores prevalent throughout the study area—particularly wells drilled prior to 1930.

California

Groundwater quality near an oil field in a stream-dominated recharge setting, California, USA

Alluvial valley aquifers are important sources of water supply in many areas but effects of co-located oil and gas development on these resources have not been widely reported, especially in settings where recharge is dominated by stream infiltration. Interpreting the presence of geochemical indicators in the context of hydrology, geology, and other factors provides a more complete understanding of the relations between groundwater and sources of oil-field fluids and aids in identifying risks associated with oil and gas development. Groundwater and Salinas River water samples were collected in an alluvial valley near the San Ardo Oil Field in Monterey County, California and analyzed for a wide range of dissolved chemical, gas, and isotopic constituents to determine if oil-field fluids (water and gas from oil-producing and non-producing zones) have mixed with fresh groundwater used for supply. Hydraulic gradients, age-dating tracers, and other geochemical indicators show that recharge from the Salinas River has the potential to dilute oil-field fluids that might migrate or seep into the aquifer. Groundwater and Salinas River water collected downgradient of the San Ardo Oil Field showed little or no evidence of mixing with oil-field fluids. Some samples within the oil field contained trace amounts of hydrocarbons or elevated temperatures, indicating that any potential effects from oil-field activities are minor or have been diluted by recharge from the Salinas River. The two samples with the most geochemical evidence of potential mixing with oil-field fluids (SP-18 and GW-17) were collected west of or along the Los Lobos fault, where naturally occurring hydrocarbons are near the land surface. Those samples are also near active or inactive oil-field wells, and so anthropogenic activities and pathways cannot be ruled out as a cause of trace detections of hydrocarbons and elevated temperatures in the aquifer.

California

Harmonization of aggregated freshwater biotic data to support continental and global assessment

Biodiversity loss and conservation are increasingly coming into focus in global policy fora, requiring information and assessments at wider spatial and temporal scales than previously considered. However, the monitoring framework required to support such data collection and assessment is lacking in many countries and is not harmonized across countries, hampering these efforts. Aggregation of existing freshwater data offers a solution to the problem of assessing status and trends of ecosystems and biodiversity at large spatial scales in the absence of nationally coordinated monitoring efforts. Analysis of aggregated data from different sources, collected using different protocols and with varying levels of metadata and supporting data, can be challenging and requires decisions regarding data comparability. In this paper, we identify the challenges inherent in harmonizing aggregated freshwater data for analysis, including general concerns related to research goals, spatial and temporal scale, sample selection, sampling effort, and site integrity. We also discuss the challenges related to measured parameters, sampled habitats, sample collection and processing methods, and data integrity for phytoplankton, benthic algae, macrophytes, zooplankton, benthic macroinvertebrates, fish, and supporting variables such as water and sediment chemistry. We provide a workflow to evaluate each of these challenges and make decisions about how best to work with the data. Finally, we review a case study from a large-scale analysis of freshwater data from the circumpolar Arctic region that exemplifies the encountered challenges and the chosen solutions. Through the description of the case study, we provide practical solutions to support aggregation and analysis of existing freshwater data. As global conversations about biodiversity status and trends continue, the demand for large-scale analyses of data from different sources will only grow. In the absence of globally harmonized monitoring, we are faced with the need to ensure comparability of data, making expert judgements where needed to support sound conclusions.

PLOS Water