Geology Reports⌕ Search

USGS · 70263400

Status and performance of the ShakeAlert® earthquake early warning system: 2019-2023

Abstract

The U.S. Geological Survey (USGS)‐operated ShakeAlert® system is the United States West Coast earthquake early warning system ( Given et al. , 2018 ). In this study we detail ShakeAlert’s performance during some of the largest events seen by the system thus far. Statewide public alerting using ShakeAlert messages was authorized in California in October 2019. Over the next few years, public alerts were expanded into Oregon and then into Washington ( U.S. Geological Survey, 2024 ). ShakeAlert source results are routinely compared to the USGS Comprehensive Catalog (ComCat; Guy et al. , 2015 ; U.S. Geological Survey, Earthquake Hazards Program, 2017 ), which contains the earthquake location and magnitude determined using complete waveform data. M 4.5 and larger is the threshold used for public alerting and was deliberately set below the level where damage is likely to compensate for cases where the system underestimates the magnitude. Between 17 October 2019 and 1 September 2023, the ShakeAlert system created 95 events with maximum magnitude estimates of M ≥4.5, the public alerting threshold. 94 of the 95 events were due to real earthquakes. Seven were categorized “false” per ShakeAlert’s internal definition that there was no matching catalog event within 100 km and 30 s of origin time; however, all but one of these were real earthquakes that were poorly located, primarily because they were at the edges of the seismic network. Three detected events were labeled “missed” because they were very poorly located (>100 km location error). In addition, the system did not produce solutions for four ComCat events M ≥4.5 ( U.S. Geological Survey, Earthquake Hazards Program, 2017 ), which were all at the edge of the alerting and network boundaries. The ShakeAlert system has accurately detected the majority of earthquakes that have occurred within the operational region since completing the public rollout, and alerts from the system have been delivered to millions of cell phone users throughout the West Coast.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 32.534156° to 49.002357° latitude; -124.731746° to -114.134768° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

A.I. Lux, Deborah Smith, M. Böse, Jeffrey J. McGuire, Jessie K. Saunders, Minh Huynh, I. Stubailo, Jennifer R Andrews, G. Lotto, B. Crowell, S. Crane, R. M. Allen, Douglas D. Given, R. Hartog, T. Heaton, A. Husker, J. Marty, Leland O'Driscoll, Harold J. Tobin, Sara K. McBride, D. Toomey. 2024-08-16. Status and performance of the ShakeAlert® earthquake early warning system: 2019-2023. https://doi.org/10.1785/0120230259

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related USGS reports

ETAS-positive: Extracting unbiased epidemic-type aftershock models from incomplete earthquake catalogs

Earthquake catalogs are inherently incomplete, and short-term fluctuations in catalog completeness can strongly bias estimates of seismicity parameters. Here, we extend the positive statistics framework recently introduced for estimating Gutenberg–Richter a and b values to the Epidemic-Type Aftershock Sequence (ETAS) model. The approach focuses on complete magnitude–time intervals defined by pairs of earthquakes in which the second event is larger than the first. Comprehensive synthetic tests demonstrate that the proposed ETAS + method retrieves nearly unbiased parameter estimates even from highly incomplete catalogs, whereas parameters obtained using classical estimation approaches are strongly biased. Application to Southern California reveals a similar trend, with the productivity scaling parameter α approaching the b value, consistent with self-similar earthquake triggering within estimation uncertainties. Owing to its robustness against catalog incompleteness and computational efficiency, the ETAS + method provides a powerful new tool for seismicity analysis and earthquake forecasting.

California↗

Efficient physics‐informed ground‐motion simulations with reduced‐order models: CyberShake implications and high‐resolution site terms for southern San Andreas fault earthquakes

Recent advances in Probabilistic Seismic Hazard Analysis (PSHA) leverage physics‐based ground‐motion simulations to estimate seismic hazard, such as the CyberShake project. However, computational costs quickly escalate when performing PSHA for numerous faults or sites and can become prohibitively expensive. To reduce computational demands, CyberShake uses reciprocity and interpolates physics‐informed corrections from simulations conducted at fewer locations, but the accuracy of these interpolations remains poorly quantified. To quantify the interpolation accuracy, we derive high‐resolution, frequency‐dependent site terms for southern California and compare them with interpolated site terms using the CyberShake approach. We accomplish this by performing a set of earthquake point‐source simulations distributed along the nonplanar fault geometry for the southern San Andreas fault (SSAF) extending from Bombay Beach to Lake Hughes. Using SeisSol, we simulate three minutes of viscoelastic seismic wave propagation for these sources and store the horizontal‐component Green’s functions for 480,000 sites. We then use a scientific machine learning approach based on interpolated proper orthogonal decomposition to construct an accurate reduced‐order model of the Green’s functions to efficiently predict effective amplitude spectra (EAS) for finite‐source rupture models of SSAF earthquakes. Using minimum curvature interpolation with tension, as used in CyberShake, we compare the interpolated site terms against our high‐resolution site terms. We identify local discrepancies with EAS differing by up to a factor of approximately three. Furthermore, we identify locations where unexpectedly high or low ground motions are missed when using the interpolated dataset for these earthquakes. We estimate that our approach may be used within CyberShake to reduce the time‐to‐solution by a factor of 336 for the entire earthquake rupture forecast. Our analysis of physics‐based site terms provides more insight into the seismic hazard due to SSAF ruptures and guides future developments by combining high‐performance computing and reduced‐order modeling techniques for PSHA.

California↗