Geology ReportsSearch

USGS · 70233067

Accuracy and consistency comparisons of land use and land cover maps made from high-altitude photographs and Landsat multispectral imagery

Abstract

Accuracy analyses for land use and land cover maps of the 74712-km 2 Central Atlantic Regional Ecological Test Site were performed for a 1-percent sample of the area. Researchers compared Level II land use and land cover maps produced at three scales, 1:24000, 1:100000, and 1:250000 from high-altitude photographs, with point data obtained in the field. The same procedures were employed to determine the accuracy of the Level I land use and land cover produced at 1:250 000 scale from high-altitude photographs and color composite Landsat imagery. The accuracy of the Level II maps was 85 percent at 1:24 000, 77 percent at 1:100 000, and 73 percent at 1:250 000. The accuracy of the Level I 1:250000 maps produced from high-altitude photographs was 77 percent and for those produced from Landsat multispectral imagery was 70 percent. The accuracy of the Level I land use maps produced using Landsat imagery is approximately that of the Level I land use maps produced from high-altitude photography with the exception of urban and built-up land. No built-up land was identified from Landsat imagery in the non-urban areas.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Katherine Fitzpatrick-Lins. 1978. Accuracy and consistency comparisons of land use and land cover maps made from high-altitude photographs and Landsat multispectral imagery. https://pubs.usgs.gov/publication/70233067

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Natural radioactivity in geothermal waters, Alhambra Hot Springs and nearby areas, Jefferson County, Montana

Radioactive hot springs issue from a fault zone in crystalline rock of the Boulder batholith at Alhambra, Jefferson County, in southwestern Montana. The discharge contains high concentrations of radon, and the gross alpha activity and the concentration of adium-226 exceed maximum levels recommended by the Environmental Protection Agency for drinking water. Part of the discharge is diverted for space heating, bathing, and domestic use. The radioactive thermal waters at measured temperatures of about 60°C are of the sodium bicarbonate type and saturated with respect to calcium carbonate. Radium-226 in the rock and on fractured surfaces or coprecipitated with calcium carbonate probably is the principal source of radon that is dissolved in the thermal water and discharged with other gases from some wells and springs. Local surface water and shallow ground water are of the calcium bicarbonate type and exhibit low background activity. The temperature, percent sodium, and radioactivity of mixed waters adjacent to the fault zone increase with depth. Samples from most of the major hot springs in southwestern Montana have been analyzed for gross alpha and beta activity. The high level of radioactivity at Alhambra appears to be related to leaching of radioactive material from siliceous veins by ascending thermal waters and is not a normal characteristic of hot springs issuing from fractured crystalline rock in Montana.

Montana

Porphyry-type metallization and alteration at La Florida de Nacozari, Sonora, Mexico

Pervasive secondary biotite-rich mineral assemblages, characteristic of potassic alteration found in the cores of most commercial porphyry copper systems, are associated spatially with a conspicuous color and a geochemical anomaly at La Florida de Nacozari, Sonora. These composite biotite-magnetite assemblages, with or without actinolite, quartz, rutile, sphene, chalcopyrite, and pyrite assemblages, are primarily the result of early dispersed biotitic (EDB) alteration of andesite. The bulk of the near-surface copper in the area, however, was introduced later by the veins that cut the EDB-altered andesite. These late veins are distinguished by a quartz-calcite-chlorite±laumontite±chalcopyrite assemblage, and the chalcopyrite in these veins may reflect upward remobilization of deep EDB copper by fluids associated with the emplacement of nearby coarse-grained granite. Fluid-inclusion relations in the late veins suggest that their fluids were nonboiling and relatively dilute.

Sonora

Morphology of chasma walls, Mars

The landforms developed on the walls of the Valles Marineris system of chasmas are of three major types, which are locally transitional. The most common type is composed of steep spurs and gullies. The dominant process in the formation or modification of this type appears to be the downslope movement of. material under the influence of gravity, resulting in the accumulation of extensive talus deposits. The type is morphologically similar to high, steep terrestrial scarps in desert or alpine environments. The second morphologic type consists of walls dissected by tributary canyons with characteristic V-shaped cross profiles and blunt canyon heads that locally contain lobate deposits. The tributary canyons may be relict features of the time, when the existence of running water was possible on the surface of Mars. The third morphologic type consists of landslide scars forming broad curved or straight recessed sections of chasma wall. This type is accompanied by landslide deposits that form hummocky floors at the base of the recessed sections. The landslides developed at the expense of other wall morphologies. Chains of rimless depressions and craters that parallel the main structural trends of the chasmas are best interpreted as collapse holes. The origin of the chasmas on Mars is conjectural and may have been structural (grabens), but, on the basis of morphologic studies of their walls, it is suggested that most of the present wall configuration is the result of erosional scarp retreat, where erosion follows preestablished structural planes of weakness.

Journal of Research of the U.S. Geological Survey