Geology Reports⌕ Search
Home/Archive/USGS

USGS · 70226794

Peru-Chile Trench sediments and sea-floor spreading

David W. Scholl·Mark N. Christensen·Roland E. von Huene·Michael S. Marlow
View original source ↗Export metadata ↓

Abstract

The hypotheses of sea-floor spreading and plate tectonics require the removal of sediment from oceanic trenches either by crustal underthrusting or by folding against the base of a continental or insular margin. Accordingly, over a period of time the volume of sediment removed by way of spreading must be equal to the difference between the observable volume of undeformed terrigenous deposits in a trench and the volume contributed to it by continental erosion. To assess possible sediment loss from the central Chilean segment (23°–44° S.) of the Peru-Chile Trench, we have compared the volume of terrigenous deposits overlying the land, the continental margin, and filling the trench with that expected from continental denudation. Our data indicate that an episode of sediment removal occurred at the base of the margin and adjacent deep-sea floor in Late Cretaceous and perhaps earlymost Tertiary time and may imply spreading. Nearly 100 × 10 3 km 3 of deposits of Tertiary age, chiefly Eocene to Pliocene, have accumulated on the margin, and perhaps an additional 5 × 10 3 km 3 in the trench. This amount of offshore sediment could be supplied by fairly low rates (3 cm/10 3 yrs) of Tertiary erosion. However, many uncertainties in our denudation-sedimentation budget make it impossible to determine whether or not sediment reaching the base of the margin was removed tectonically in Tertiary time. Between 27° and 44° S., the trench contains nearly 70 × 10 s km 3 of turbidite deposits that we believe accumulated during late Cenozoic periods of glacially lowered sea level. The volume of turbidites in the trench is virtually equal to that expected from continental erosion, which is estimated to have probably been no greater than 5 cm/10 3 yr for the arid region between 27° and 31°, and 50 cm/10 3 yr for the humid and partially glaciated region from 36° to 42°. During this time of rapid erosion and trench filling, magnetic data indicate that convergence of lithospheric plates was taking place below the trench at a rate between 5 and 10 cm/yr. If turbidite deposits were swept from the trench at these rates, then continental denudation must have been exceedingly rapid: 20–40 cm/10 3 yr for the arid zone, and 110–165 cm/10 3 yr for the partially glaciated region. If more conventional estimates of erosion are valid, then either (1) late Cenozoic underthrusting has not taken place (or at a rate much slower than that implied by geophysical data), or (2) underthrusting at the prescribed rates has not involved the removal of a significant volume of sediment from the trench.

Explore related subjects

Bulletin of the Geological Society of AmericaArticle
90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: -43.35713822211053° to -23.32208001137843° latitude; -75.76171875° to -70.3125° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

David W. Scholl, Mark N. Christensen, Roland E. von Huene, Michael S. Marlow. 1970. Peru-Chile Trench sediments and sea-floor spreading. https://doi.org/10.1130/0016-7606(1970)81%5B1339%3Aptsass%5D2.0.co%3B2

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2010

Uncertainties in slip-rate estimates for the Mission Creek strand of the southern San Andreas fault at Biskra Palms Oasis, southern California

This study focuses on uncertainties in estimates of the geologic slip rate along the Mission Creek strand of the southern San Andreas fault where it offsets an alluvial fan (T2) at Biskra Palms Oasis in southern California. We provide new estimates of the amount of fault offset of the T2 fan based on trench excavations and new cosmogenic 10 Be age determinations from the tops of 12 boulders on the fan surface. We present three alternative fan offset models: a minimum, a maximum, and a preferred offset of 660 m, 980 m, and 770 m, respectively. We assign an age of between 45 and 54 ka to the T2 fan from the 10 Be data, which is significantly older than previously reported but is consistent with both the degree of soil development associated with this surface, and with ages from U-series geochronology on pedogenic carbonate from T2, described in a companion paper by Fletcher et al. (this volume). These new constraints suggest a range of slip rates between ∼12 and 22 mm/yr with a preferred estimate of ∼14–17 mm/yr for the Mission Creek strand of the southern San Andreas fault. Previous studies suggested that the geologic and geodetic slip-rate estimates at Biskra Palms differed. We find, however, that considerable uncertainty affects both the geologic and geodetic slip-rate estimates, such that if a real discrepancy between these rates exists for the southern San Andreas fault at Biskra Palms, it cannot be demonstrated with available data.

California↗
USGS1995

Stratigraphic and structural synthesis of a Miocene extensional terrane, southeast California and west-central Arizona

Detailed stratigraphy and isotopic dating of stratigraphic sections in the Colorado River extensional corridor support a regional correlation of highly faulted Tertiary stratigraphic sequences and provide a chronologic framework for interpreting the evolution of low-angle normal (detachment) faults. On the basis of this correlation, we define six tilting domains in the upper plate of the Whipple, Chemehuevi, and Rawhide detachment faults and identify three discrete episodes of detachment faulting that began in the early Miocene and ended in middle Miocene time. Episodes of rapid detachment faulting are indicated by extreme tilting of upper-plate fault blocks and overlying Miocene sequences, fanning dips of basinal deposits, and angular unconformities that represent short time gaps in the accumulation of syntectonic sequences. During the first episode of detachment faulting at about 20 Ma, the upper plate segmented to form the domains. Basin subsidence and extreme tilting of upper-plate fault blocks and syntectonic deposits characterized the eastern Topock, Crossman, Aubrey, Parker Dam, and Buckskin-Rawhide domains, whereas the western Mopah domain was the site of abundant volcanic activity but no basins or tilting. A second episode of extension at about 18 Ma produced extreme tilts in the Buckskin-Rawhide domain but upper-plate blocks in the Mopah domain tilted moderately. A third regionwide faulting episode between 14 and 12 Ma was due to localized uplift of middle and lower crust and eventual exposure of the detachment faults and their footwalls. The upper-plate fault blocks responded passively to localized slip on the detachment faults. Rapid extension began on the Whipple-Chemehuevi detachment fault at 20 Ma and had shifted southward to the Buckskin-Rawhide detachment fault by 18 Ma; volcanic activity also shifted southward to the Buckskin-Rawhide domain at this time. The southward shift of rapid extension and volcanism probably represents buildup and release of strain at localized sites in the lower plate. Otherwise, stratigraphic and structural relations indicate that the locations of upper-plate basins, faulting and tilting of upper-plate blocks, and position of the breakaway zone remained stable throughout the major phases of extension.

Arizona, California↗
USGS1971

Basin and range structure: A system of horsts and grabens produced by deep-seated extension

Basin and Range structure can be interpreted as a system of horsts and grabens produced by the fragmentation of a crustal slab above a plastically extending substratum. According to this view, the extension of the substratum causes the basal part of the slab to be pulled apart along narrow, systematically spaced zones which in turn cause the downdropping of complex horizontal prisms (grabens) in the brittle upper crust. The grabens form valleys at the surface; the intervening areas are horsts, or tilted horsts. Not all geologists have agreed, however, that Basin and Range structure consists of a system of horsts and grabens. Instead, the structure is commonly considered to consist of tilted blocks in which the upslope part of an individual block forms a mountain and the downslope part a valley. Recent detailed studies, including geophysical work, suggest that the horst and graben model may be more generally applicable. Many of the valleys in the Great Basin are bounded on both sides by faults that drop the valley block down; these faults are exposed at the surface or can be inferred from steep gravity gradients indicative of steep faulted subsurface bedrock slopes. Some areas that were thought to represent a typical series of tilted blocks may be a series of highly asymmetrical grabens in which one side of a valley is marked by a master fault and the other side by valleyward tilt. With present knowledge, most, or perhaps all, of the major valleys in the Great Basin can plausibly be considered to be grabens, and most or all of the mountains can be considered to be horsts or tilted horsts. The grabens, and the underlying inferred deep zones of extension that cause them, are systematically distributed in the Great Basin. They are generally north-trending features spaced 15 to 20 mi apart. Locally, the pattern is more complex, and individual grabens divide and trend away from each other at acute or high angles. In a few places, the pattern may even be roughly polygonal. The distribution pattern of the grabens and the related deep zones of extension resemble crack patterns in small-scale tensional systems, and both patterns may be mechanically related. By analogy with the small-scale systems, the areas of generally north-trending and parallel grabens require east-west extension, whereas the areas with a possible polygonal pattern of grabens must extend radially. The geometry of block faulting related to Basin and Range structure requires sizable east-west extension, estimated at about 1.5 mi on the average for each major valley and at about 30 to 60 mi across the entire Great Basin. Most of this extension has taken place in the last 17 m.y., or perhaps even in the last 7 to 11 m.y., indicating a rate of extension in the range of 0.3 to 1.5 cm/yr.

Arizona, California, Idaho, Nevada, Oregon, Utah↗