Geology ReportsSearch

USGS · 70204090

The complex spatial distribution of trichloroethene and the probability of NAPL occurrence in the rock matrix of a mudstone aquifer

Abstract

Methanol extractions for chloroethene analyses are conducted on rock samples from seven closely spaced coreholes in a mudstone aquifer that was subject to releases of the nonaqueous phase liquid (NAPL) form of trichloroethene (TCE) between the 1950's and 1990's. Although TCE concentration in the rock matrix over the length of coreholes is dictated by proximity to subhorizontal bedding planefractures, elevated TCE concentrations in the rock matrix are not continuous along the most permeable bedding plane fractures. A complex configuration of subvertical and subhorizontal fractures appears to be responsible for the TCE distribution from prior TCE releases at land surface. Phase partitioning calculations of TCE in the rock matrix show that most TCE is adsorbed to solid surfaces because of the large fraction of organic carbon ( f oc ) in the mudstone. Large TCE content in some cores indicate the likely presence of the NAPL form of TCE in the rock matrix. Using average values of porosity ( n ) and f oc in phase partitioning calculations identifies a number of locations of possible NAPL occurrence in the rock matrix. Samples of mudstone analyzed for n and f oc show variability in these properties over several orders of magnitude. Accounting for this variability in phase partitioning calculations identifies a probability of NAPL occurrence, P NAPL . The spatial variability of P NAPL along coreholes identifies a configuration that may be attributed to a TCE source zone that has evolved after emplacement due to NAPL dissolution, adsorption, and matrix diffusion.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.26757447962916° to 40.272715386988686° latitude; -74.8144268989563° to -74.80850458145142° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Allen M. Shapiro, Daniel J. Goode, Thomas E. Imbrigiotta, Michelle M. Lorah, Claire R. Tiedeman. 2019. The complex spatial distribution of trichloroethene and the probability of NAPL occurrence in the rock matrix of a mudstone aquifer. https://doi.org/10.1016/j.jconhyd.2019.04.001

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Distinguishing natural from mining-related metal sources by including streambank groundwater data in a stream mass loading study

Distinguishing stream metal loading caused by mine features from that caused by natural background sources remains challenging, yet this distinction is essential for making effective remedial decisions at many legacy mine sites. We combine a stream tracer injection and synoptic sampling study with data from shallow near-stream groundwater wells to estimate left-bank versus right-bank metal loading contributions at the 100-m spatial scale. The study was performed in the East Mancos River, a mountain headwater stream in Colorado, USA. The dominant source of elevated stream metal concentrations could be either groundwater infiltration through right-bank Doyle Mine waste piles or natural acid rock drainage from hydrothermally altered bedrock located mainly on the left bank. For the five metals of concern (Cu, Al, Zn, Cd, and Mn), we find that 15 % of the load contributed by diffuse groundwater inputs in the section potentially influenced by Doyle mine waste originates from the right bank. This right-bank potential mine contribution equates to only 3 % of the total watershed instream load for these metals. Furthermore, apparent 3 H/ 3 He groundwater ages in segments contributing most of the right-bank metal loading are sufficiently old (9–12 yr) to suggest that infiltration through the waste piles, located only 140–180 m from the stream, is unlikely. Estimated potential Doyle mine loading contributions can therefore be considered maximum values. Study results thus indicate that Doyle mine waste piles are a minor source of metal loading under low-flow conditions, and streambank groundwater data can provide valuable additional information in stream mass loading studies.

Colorado

Per- and polyfluoroalkyl substances (PFAS) mass flux and mass balance at an aqueous film-forming foam release site in semiarid eastern New Mexico, USA

Passive flux meters (PFMs) directly measure groundwater chemistry mass flux and Darcy flux, providing insight into contaminant source-zone architecture and transport properties. This study uses PFMs to characterize PFAS flux in groundwater at a semiarid site with a thick (greater than 90-m) unsaturated zone where groundwater has been contaminated with per - and polyfluoroalkyl substances (PFAS) related to the use of aqueous film-forming foam (AFFF) for fire training and fire suppression. PFAS mass discharge (PFAS mass flux integrated over a control plane) in groundwater downgradient from several PFAS release areas is calculated using PFM results. In groundwater downgradient from fire-training areas, total PFAS mass discharge (summed across 14 compounds) was estimated to be between 6.0 and 31 g per day in 2020 and between 5.9 and 23 g per day in 2021. Site-specific documentation, generic information on AFFF properties, and literature values of PFAS concentration in AFFF are used to estimate site-specific PFAS-application rates at fire-training areas. These PFAS-application rates are compared to groundwater PFAS-discharge rates. Results suggest that transformation processes (exact pathways unknown) have led to increased discharge of measured PFAS in groundwater relative to initial AFFF formulations. The mass balance approach has broad applicability as a high-level approach that can provide insight into PFAS transport at AFFF sites.

New Mexico

Concentration-discharge relations and transient metal loads reveal spatiotemporal variability in solute-generation mechanisms in a mine-affected watershed

Concentration-discharge (CQ) relations are commonly used to understand geochemical and hydrologic controls on the generation of solutes in watersheds. Despite the widespread application of CQ relations, this technique has been infrequently applied to acid mine drainage (AMD) sites, but the CQ framework may allow mechanistic understanding of remedial outcomes such as impoundment of water within underground mines. Results of CQ analyses and changes in metal loads in an AMD affected watershed in Colorado, USA indicate that dissolved loads increased at many individual locations following water impoundment within mine workings. Although increased loads were observed at most individual locations, these increases were offset by a large decrease in loading from the largest mine. A loading analysis that included data from an instream monitoring location showed a statistically significant decrease in Fe and Zn after bulkhead emplacement, indicating a net positive effect of bulkheads. Streams generally displayed dilution CQ patterns whereas mines and springs showed either flushing or chemostatic patterns prior to bulkheading, which transitioned to chemostatic patterns following bulkheading, indicating a transition from dynamic to equilibrium geochemical processes. Saturation indices for sulfide and secondary minerals indicated that mines and springs were near equilibrium for phases including schwertmannite, fluorite, and gypsum. Saturation indices vary through time for mines suggesting progressive leaching of sulfide minerals as the mass of available minerals in the mine workings decreases. Together, these diverse analyses provide an integrated understanding of the variability in solute generating processes in this watershed and may inform remediation plans for similarly affected sites by indicating the nature of mineralogic controls on water quality.

Colorado