Geology ReportsSearch

USGS · 70203756

Xenon hydrate as an analogue of methane hydrate in geologic systems out of thermodynamic equilibrium

Abstract

Methane hydrate occurs naturally under pressure and temperature conditions that are not straightforward to replicate experimentally. Xenon has emerged as an attractive laboratory alternative to methane for studying hydrate formation and dissociation in multiphase systems, given that it forms hydrates under milder conditions. However, building reliable analogies between the two hydrates requires systematic comparisons, which are currently lacking. We address this gap by developing a theoretical and computational model of gas hydrates under equilibrium and nonequilibrium conditions. We first compare equilibrium phase behaviors of the Xe·H 2 O and CH 4 ·H 2 O systems by calculating their isobaric phase diagram, and then study the nonequilibrium kinetics of interfacial hydrate growth using a phase field model. Our results show that Xe·H 2 O is a good experimental analog to CH 4 ·H 2 O, but there are key differences to consider. In particular, the aqueous solubility of xenon is altered by the presence of hydrate, similar to what is observed for methane; but xenon is consistently less soluble than methane. Xenon hydrate has a wider nonstoichiometry region, which could lead to a thicker hydrate layer at the gas‐liquid interface when grown under similar kinetic forcing conditions. For both systems, our numerical calculations reveal that hydrate nonstoichiometry coupled with hydrate formation dynamics leads to a compositional gradient across the hydrate layer, where the stoichiometric ratio increases from the gas‐facing side to the liquid‐facing side. Our analysis suggests that accurate composition measurements could be used to infer the kinetic history of hydrate formation in natural settings where gas is abundant.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Xiaojing Fu, William F. Waite, Luis Cueto-Felgueroso, Ruben Juanes. 2019-05-29. Xenon hydrate as an analogue of methane hydrate in geologic systems out of thermodynamic equilibrium. https://doi.org/10.1029/2019gc008250

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Hydrothermal manganese-oxide mineralization of a carbonate ooze, Samoan hotspot region, South Pacific Ocean

Low-temperature hydrothermal manganese oxides occur throughout the global oceans. However, the hydrothermal replacement of a carbonate ooze by manganese oxides is described here for the first time. The 24 samples dredged from three locations around the Territory of American Samoa in the South Pacific Ocean include six samples with remnant carbonate and volcaniclastic sediments, which we refer to as “low Mn,” and 18 samples in which the mineralization is pervasive and has replaced most original sediment, termed “high Mn.” The 18 high-Mn samples exhibit a mean Mn content of 51 wt.%. Higher Li and Mn contents and lower Fe contents in the high-Mn samples indicate a hydrothermal origin and distinguish these samples from hydrogenetic ferromanganese crusts. Mn-oxide layers are up to 90 mm thick, some with columns to 44 mm long and 10 mm wide, the magnitude of which has not been described previously. Samples are composed of birnessite and 10 Å phyllomanganate minerals. Textures of the thickest Mn layers indicate mineralization below the seabed from ascending fluids during multiple hydrothermal pulses. Mineralization took place by complete to partial replacement and cementation of foraminiferal sediments intermixed with volcaniclastic sediments in varying amounts. Our results highlight the production of carbonate sediment-hosted hydrothermal Mn oxides from multiple hydrothermal sources within the Samoan volcanic chain. The potential extensive distribution on the regional scale of this newly described mineralization process and unique element enrichments raise questions about its broader distribution globally and potential importance to hydrothermal processes, element mass balance, and seabed mineral resources.

Geochemistry, Geophysics, Geosystems

Regional variations in sea ice and primary productivity in the Bering Sea during Marine Isotope Stage 11

Marine Isotope Stage (MIS) 11 (424-374 ka) has long been an analog for Holocene climate, because it is the most recent interglacial period with similar orbital conditions. However, there is significant global and regional variability in the climate response to MIS 11 warmth. Here, we review sediment core records from across the Bering Sea to investigate changes in paleoceanographic conditions during Marine Isotope Stages 12-10. Sea ice was present over much of the Bering Sea during MIS 11, but today, none of the sites investigated are ever ice-covered. This suggests that sea ice regimes in the Bering Sea during MIS 11 were different to those of the Holocene. There are also regional differences in the response of sea ice to MIS 11 warming. At the Umnak Plateau, Southeastern Bering Sea, sea ice concentrations decline during deglaciation, but they remain high at the slope sites until Peak MIS 11. Sea ice re-advances over the Umnak Plateau during peak interglacial warmth, at the same time that it declines over the slope sites. Late MIS 11 is characterized by high concentrations of seasonal sea ice at the Umnak Plateau, whilst sea ice at the slope sites fluctuates between consolidated and unconsolidated ice cover. This east-west dichotomy may be explained by changes in the behavior of the Aleutian Low. Productivity increases dramatically during deglaciation due to increased upwelling and sea level rise bringing fresh nutrients into the oceans. This is characterized by increased diatom productivity, increased terrestrial carbon deposition, and laminations at all sites.

Alaska

Constraining sources of mid-Pleistocene to present explosive volcanism in the Gulf of Alaska using machine learning and compositional data analysis

The long-term eruptive record of a region helps better elucidate magmatic processes at depth as well as volcanic hazards at the surface. Typically, reconstructing such records is done using proximal tephrostratigraphy and linking individual tephras to source volcanoes. These records, however, can only be accurately constructed if they are both well preserved and correctly linked to source volcanoes—not a trivial task, especially in areas such as Alaska that have experienced numerous glaciation events since the Pleistocene. This ultimately necessitates another way of assessing the long-term volcanic record such that these histories may be better discerned. Here we present data from 70 marine core tephras from the Gulf of Alaska, which have a virtually uninterrupted depositional record going back through the mid-Pleistocene. We utilize compositional data analysis techniques to quantify 37 eruptions over the span of eight cores, machine learning classification and conformal prediction algorithms to assign the most probable volcanic source(s) to each eruption, and multivariate distance-based metrics when machine learning classification algorithms are inappropriate. We find that the Mount Katmai magmatic system is the most probable volcanic source for analyzed tephras and that large volcanic centers such as Mount Katmai, Fisher Caldera, and Emmons Lake volcanic center have produced nearly invariant incompatible trace element ratio magmas, allowing for them to be confidently identified in long-term tephra records. This highlights the utility of trace elements for tephra studies, especially when paired with compositional data analysis, multivariate statistical tests, and petrologically informed discriminants.

Alaska