Geology ReportsSearch

USGS · 70200354

Mount St. Helens retrospective: Lessons learned since 1980 and remaining challenges

Abstract

Since awakening from a 123-year repose in 1980, Mount St. Helens has provided an opportunity to study changes in crustal magma storage at an active arc volcano—a process of fundamental importance to eruption forecasting and hazards mitigation. There has been considerable progress, but important questions remain unanswered. Was the 1980 eruption triggered by an injection of magma into an upper crustal reservoir? If so, when? How did magma rise into the edifice without producing detectable seismicity deeper than ∼2.5 km or measurable surface deformation beyond the volcano’s north flank? Would precursory activity have been recognized earlier if current monitoring techniques had been available? Despite substantial improvements in monitoring capability, similar questions remain after the dome-forming eruption of 2004–2008. Did additional magma accumulate in the reservoir between the end of the 1980–1986 eruption and the start of the 2004–2008 eruption? If so, when? What is the significance of a relative lull in seismicity and surface deformation for several years prior to the 2004–2008 eruption onset? How did magma reach the surface without producing seismicity deeper than ∼2 km or measurable deformation more than a few hundred meters from the vent? Has the reservoir been replenished since the eruption ended, and is it now primed for the next eruption? What additional precursors, if any, should be expected? This paper addresses these questions, explores possible answers, and identifies unresolved issues in need of additional study. The 1980–1986 and 2004–2008 eruptions could have resulted from second boiling during crystallization of magma long-resident in an upper crustal reservoir, rather than from injection of fresh magma from below. If reservoir pressurization and magma ascent were slow enough, resulting strain might have been accommodated by viscoelastic deformation, without appreciable seismicity or surface deformation, until rising magma entered a brittle regime within 2–2.5 km of the surface. Given the remarkably gas-poor nature of the 2004–2008 dome lava, future eruptive activity might require a relatively long period of quiescence and reservoir pressurization or a large injection of fresh magma—an event that arguably has not occurred since the Kalama eruptive period (C.E. 1479–1720).

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 46.0833° to 46.3° latitude; -122.35° to -122° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Daniel Dzurisin. 2018-10-05. Mount St. Helens retrospective: Lessons learned since 1980 and remaining challenges. https://doi.org/10.3389/feart.2018.00142

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Pliocene (Piacenzian) planktic foraminiferal biogeography: Insights into how planktic biogeography is linked to climate and socioeconomic impacts on marine ecosystems

The Piacenzian Age (3.60–2.58 Ma) of the Pliocene Epoch was characterized by globally warmer climates, higher sea levels, and atmospheric CO 2 similar to present. Utilizing a robust dataset of 2,101 samples and over 637,000 foraminifer specimens from 77 deep-sea core sites worldwide, we document planktic foraminifer biogeography and biodiversity during the mid-Piacenzian Warm Period (mPWP). Cluster analysis and multidimensional scaling reveal five major bioregions: tropical, warm subtropical, transitional, polar, and a distinct North Atlantic polar bioregion. Each bioregion was dominated by characteristic species with well-established temperature preferences. Analyses demonstrate higher species richness and evenness in low and mid-latitudes, with increased diversity associated with periods of climatic warming and poleward expansion of warm water assemblages. The long-term stability of biogeographic patterns underscores ecological conservatism but also highlights potential vulnerability to rapid anthropogenic climate change. Our findings emphasize the critical role of planktic foraminifers in reconstructing past ocean conditions and offer valuable insights into links between planktic biogeography, climate, and socioeconomic impacts on marine ecosystems. This work advances our understanding of marine ecosystem responses to climate extremes and provides a foundation for future regional and temporal analyses of planktic foraminifer biogeography under global change scenarios.

Frontiers in Earth Science

Estimation of dynamic geologic CO2 storage resources in the Illinois Basin, including effects of brine extraction, anisotropy, and hydrogeologic heterogeneity

Since the vast majority of carbon dioxide (CO 2 ) storage resources in the United States are in deep saline aquifers, optimizing the use of these saline storage resources could be crucial for efficient development of geologic CO 2 storage (GCS) resources and basin- or larger-scale deployment of GCS in the country. Maximum CO 2 injection rates can be enhanced by extracting brine from the CO 2 storage unit. However, disposal of the extracted brine is both a technological and economic challenge. The lowest-cost option would likely be reinjection of the extracted brine into another formation above or below the CO 2 storage unit. Therefore, it is important to estimate brine injectivity as it will constrain the potential to increase CO 2 injectivity at an injection site that has access to multiple geologic storage units where either CO 2 or brine can be injected. Using a simulation-optimization framework, coupled with a non-isothermal, multiphase CO 2 -water-salt equation-of-state module, we developed a computationally efficient method for evaluating optimization of simultaneous CO 2 injection, brine extraction, and brine (re)injection at hypothetical injection sites deployed across a geologic basin. The Illinois basin is ideal for testing our methodology because it contains multiple geologic storage units with seals in between them to isolate injection of CO 2 in one unit from interfering with the injection of either brine or CO 2 in another unit above or below it. In addition, we investigated the relative effects of variation in key geologic parameters as well as two reservoir structures (hydrogeologic heterogeneity/anisotropy and homogeneity/isotropy) on CO 2 injectivities and enhancement of CO 2 injectivity through extracting brine. Results suggest that permeability, depth, and especially thickness of the storage unit could be the most influential parameters determining CO 2 injectivity. They also suggest that only injecting CO 2 into the storage unit with the greatest injectivity, enhancing that unit’s injectivity by extracting brine, and disposing of the produced brine in other suitable units could maximize total CO 2 injectivity in limited regions of the basin. At the majority of simulated injection sites, however, we found that injecting CO 2 into all of the accessible and suitable storage units was more likely to maximize the CO 2 storage resource.

Illinois, Kentucky, Indiana

An exploration of the relative influence of physical models for Omori’s law

Omori’s law states that the rate of aftershocks decays as a function of inverse time. There are multiple physical explanations that we reduce into a nonlinear mixed effects relation of three terms: (1) a Rate/State expression that can account for static/dynamic and viscoelastic triggering caused directly by the mainshock, (2) a fluid diffusion triggering term, and (3) a randomized secondary triggering (cascade) term. We fit free physical-model parameters to an observed aftershock sequence through two nonlinear regression methods to find the relative contributions of physics-based models in an observed aftershock sequence. Results from both methods show that Rate/State models overpredict aftershock rates by ∼0–30%. Secondary aftershocks cause a net negative contribution (seismicity rate reduction that corrects overprediction by other terms) ranging between ∼0 and 30%. All regression solutions yield negative secondary triggering contributions without being guided to do so. A physical explanation for this is that aftershock occurrence relieves stress from the crust, ultimately causing the sequence to extinguish itself. Fluid diffusion triggering contributions range from ∼0 to 20%. Diffusion processes are observed to be shorter in time than the full duration of an aftershock sequence and they are also spatially limited, diminishing their influence. Our results apply to an aftershock decay curve from the 2016 Central Apennines earthquake sequence, meaning that our specific results may not be general. Our primary conclusion is that any one physical model cannot alone fit the observed sequence as well as the combination of three we investigated.

Frontiers in Earth Science