Geology ReportsSearch

USGS · 70199565

Artificial recharge through a thick, heterogeneous unsaturated zone

Abstract

Thick, heterogeneous unsaturated zones away from large streams in desert areas have not previously been considered suitable for artificial recharge from ponds. To test the potential for recharge in these settings, 1.3 x 10 6 m 3 of water was infiltrated through a 0.36-ha pond along Oro Grande Wash near Victorville, California, between October 2002 and January 2006. The pond overlies a regional pumping depression 117 m below land surface and is located where thickness and permeability of unsaturated deposits allowed infiltration and saturated alluvial deposits were sufficiently permeable to allow recovery of water. Because large changes in water levels caused by nearby pumping would obscure arrival of water at the water table, downward movement of water was measured using sensors in the unsaturated zone. The downward rate of water movement was initially as high as 6 m/d and decreased with depth to 0.07 m/d; the initial time to reach the water table was 3 years. After the unsaturated zone was wetted, water reached the water table in 1 year. Soluble salts and nitrate moved readily with the infiltrated water, whereas arsenic and chromium were less mobile. Numerical simulations done using the computer program TOUGH2 duplicated the downward rate of water movement, accumulation of water on perched zones, and its arrival at the water table. Assuming 10 3 106 m3 of recharge annually for 20 years, a regional ground water flow model predicted water level rises of 30 m beneath the ponds, and rises exceeding 3m in most wells serving the nearby urban area.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

John A. Izbicki, Alan L. Flint, Christina L. Stamos. 2008-01-09. Artificial recharge through a thick, heterogeneous unsaturated zone. https://doi.org/10.1111/j.1745-6584.2007.00406.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Computing flow-field distortion coefficients from well-construction and formation properties

Direct measurements of groundwater velocity made with borehole flowmeters in screened wells must be compensated for the effects of flow-field distortion (also known as borehole acceleration). A theoretical equation developed by Drost et al. (1968) and simple inputs describing hydraulic properties of well construction and geologic formation were programmed into an Excel workbook to facilitate computation by groundwater-flowmeter users. Tables describing the physical and hydraulic properties for well constructions and gravel pack media are provided with an example to facilitate use of the workbook. Groundwater flowlines converge or diverge as they pass from a geologic formation, through a gravel pack and well screen. The extent of flowline convergence or divergence and the value of the flow-field distortion coefficient is related to the relative changes in hydraulic conductivity of the well screen, gravel pack, and geologic formation. Convergence or divergence is accompanied by acceleration or deceleration of groundwater. Direct measurements of groundwater velocity at the center of the monitoring well can be adjusted to provide a more accurate estimate of velocity in the formation by applying a correction for flow-field distortion. Variables required to compute the flow-field distortion coefficient include the hydraulic conductivity of the gravel pack, well screen, and the geologic formation surrounding the well screen; the borehole radius, and the inside radius and outside radius of the well screen.

Groundwater

Deep groundwater total dissolved solids mapping in the Dakota Group, Williston Basin, USA

Growing concern about the quantity of available freshwater around the world has led to interest in surveying groundwater total dissolved solids (TDS) below water well depths. Deep TDS has not been systematically mapped, and there is much to learn about the distribution and controls on deeper groundwater. In sedimentary basins across the United States, groundwater resources often overlie hydrocarbon resources, providing an opportunity to use borehole geophysical data collected for hydrocarbons to characterize groundwater and pore space resources. This study adapts a recently developed subsurface geostatistical and geophysical modeling approach to continuously map groundwater TDS, porosity, and temperature in the Dakota Group of the Williston Basin—an undercharacterized regional aquifer system overlying deeper hydrocarbon reservoirs. Groundwater TDS in the Dakota Group ranges from approximately 4800 to 26,900 mg/L. TDS patterns are stratified with higher TDS in the lower and upper Dakota Group, and relatively lower TDS in the middle Dakota Group. The lower TDS in the middle zone may represent a preferential regional flow path for lower-TDS meteoric recharge from the west. The alternating pattern of TDS may also be evidence of higher-TDS inflows into the Dakota Group from underlying and potentially from overlying aquifers. Porosity is lower near the center of the Williston Basin and tends to be higher to the east, which may be related to grain size distributions. The new regional TDS and porosity modeling serves as a quantitative reference for water users and provides supporting evidence for hypotheses on Dakota Group recharge.

Montana, North Dakota, South Dakota