Geology Reports⌕ Search
Home/Archive/USGS

USGS · 70187506

Evaluation of laser ablation double-focusing SC-ICPMS for “common” lead isotopic measurements in silicate glasses and mineral

Aaron J. Pietruszka·Leonid A. Neymark
View original source ↗Export metadata ↓

Abstract

An analytical method for the in situ measurement of “common” Pb isotope ratios in silicate glasses and minerals using a 193-nm excimer laser ablation (LA) system with a double-focusing single-collector (SC)-ICPMS is presented and evaluated as a possible alternative to multiple-collector (MC)-ICPMS. This LA-SC-ICPMS technique employs fast-scanning ion deflectors to sequentially place a series of flat-topped isotope peaks into a single ion-counting detector at a fixed accelerating voltage and magnetic field strength. Reference materials (including NIST, MPI-DING, and USGS glasses) are used to identify two analytical artifacts on the Pb isotope ratios (expressed here as heavier/lighter isotopes) when corrected for mass bias relative to NIST SRM610. The first artifact is characterized by anomalously low Pb isotope ratios (~0.1%/AMU) when SRM610 is analyzed in raster mode as an unknown at small spot sizes (<25 µm), which may indicate that (1) SRM610 is isotopically heterogeneous on a small length scale and/or (2) there is a non-spectral matrix effect on the Pb isotope ratios related to differences in spot size. The second artifact is characterized by anomalously high Pb isotope ratios (<0.1%/AMU) for NIST SRM612 (in raster mode) and some Fe-rich glass reference materials (BCR-2G, GOR132-G, and T1-G). These offsets are thought to be caused by one or more non-spectral matrix effects related to differences in the ablation behavior, composition, or physical properties of these reference materials compared to the bracketing SRM610 standard. The precision (±2SD) of our LA-SC-ICPMS Pb isotopic measurements is similar to ( 207 Pb/ 206 Pb and 208 Pb/ 206 Pb, or 20X Pb/ 206 Pb) or better than ( 206 Pb/ 204 Pb, 207 Pb/ 204 Pb, and 208 Pb/ 204 Pb, or 20X Pb/ 204 Pb) a series of published studies that used a different type of SC-ICPMS and obtained a factor of ~3-4 higher sensitivity for Pb. An increase in the sensitivity of our LA-SC-ICPMS would likely improve the precision of the 20X Pb/ 206 Pb and 20X Pb/ 204P b ratios for low-Pb materials (<5 ppm), possibly making the technique broadly similar to LA-MC-ICPMS (particularly compared to methods that rely upon at least one ion-counting detector). Further improvement in the precision of the 20X Pb/ 206 Pb and 20X Pb/ 204 Pb ratios for high-Pb materials (>5 ppm) by LA-SC-ICPMS is unlikely, and in this case, LA-MC-ICPMS remains the preferable analytical technique.

Explore related subjects

Journal of Analytical Atomic SpectrometryArticle

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Aaron J. Pietruszka, Leonid A. Neymark. 2017. Evaluation of laser ablation double-focusing SC-ICPMS for “common” lead isotopic measurements in silicate glasses and mineral. https://doi.org/10.1039/c7ja00005g

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2025

Accuracy and precision of U–Pb zircon geochronology at high spatial resolution (7–20 μm spots) by laser ablation-ICP-single-collector-sector-field-mass spectrometry

Use of small spots (≤20µm) for laser ablation-inductively coupled plasma-mass spectrometry (LA-ICP-MS) U-Pb zircon geochronology is of increasing interest in the Earth sciences because the temporal record of geologic processes is often preserved on a fine-scale within zircon grains. However the systematic biases and external sources of uncertainity of U-Pb ages is poorly defined when measured on small spots by LA-ICP-single-collector-sector-field (SF)-MS instrumentation. This study addresses the accuracy and precision for small spots and specifically the extent to which short ablation times limit Pb/U Down-Hole Fractionation (DHF), which largely controls the accuracy of the U-Pb ages. Six zircon reference materials (91500, FC-1, R33, Temora 2, Plešovice and Fish Canyon Tuff) were measured on spot sizes of 20, 15, 10 and 7 µm diameter. Laser fluence was increased from 3 to 6 J/cm2 with decreasing spot size to compensate partially for decreasing U and Pb signals. 91500 zircon was the calibration reference material. Raw count rate data were processed using Iolite version 3.63 software with the U-Pb Common Approach data reduction scheme and smoothed cubic spline DHF correction model. Samples were ablated for 30 seconds and results processed for the first 28, 15, 10 and 7 seconds of ablation (masking the initial 2 seconds) in order to assess the accuracy and precision of U-Pb ages as a function of ablation time. Measured 206Pb/238U ratios for the six zircon reference materials increase steadily with ablation time, reflecting DHF, but exhibit somewhat different patterns of increase for different zircons, producing the major source of uncertainty for the U-Pb ages. A secondary source of uncertainty is differences between the 206Pb/238U (normalized to their accepted values) for different zircons near the start of ablation, which may reflect matrix-dependent instrumental mass bias in the ICP. Nonetheless, processing data from only the first 10 to 15 seconds of ablation (50 to 75 laser pulses) restricts the extent of DHF and time-resolved Pb/U variations between different zircons to a sufficient degree to give concordant U-Pb ages on 20 to 7 µm spots that are accurate and precise to better than 1.4% using LA-ICP-single-collector-SF-MS instrumentation.

Journal of Analytical Atomic Spectrometry↗
USGS2018

High-precision 41K/39K measurements by MC-ICP-MS indicate terrestrial variability of δ41K

Potassium is a major component in continental crust, the fourth-most abundant cation in seawater, and a key element in biological processes. Until recently, difficulties with existing analytical techniques hindered our ability to identify natural isotopic variability of potassium isotopes in terrestrial materials. However, measurement precision has greatly improved and a range of K isotopic compositions has now been demonstrated in natural samples. In this study, we present a new technique for high-precision measurement of K isotopic ratios using high-resolution, cold plasma multi-collector mass spectrometry. We apply this technique to demonstrate natural variability in the ratio of 41 K to 39 K in a diverse group of geological and biological samples, including silicate and evaporite minerals, seawater, and plant and animal tissues. The total range in 41 K/ 39 K ratios is ca. 2.6‰, with a long-term external reproducibility of 0.17‰ (2, N=108). Seawater and seawater-derived evaporite minerals are systematically enriched in 41 K compared to silicate minerals by ca. 0.6‰, a result consistent with recent findings1, 2. Although our average bulk-silicate Earth value (-0.54‰) is indistinguishable from previously published values, we find systematic δ 41 K variability in some high-temperature sample suites, particularly those with evidence for the presence of fluids. The δ 41 K values of biological samples span a range of ca. 1.2‰ between terrestrial mammals, plants, and marine organisms. Implications of terrestrial K isotope variability for the atomic weight of K and K-based geochronology are discussed. Our results indicate that high-precision measurements of stable K isotopes, made using commercially available mass spectrometers, can provide unique insights into the chemistry of potassium in geological and biological systems.

Journal of Analytical Atomic Spectrometry↗
USGS2016

ChemCam activities and discoveries during the nominal mission of the Mars Science Laboratory in Gale crater, Mars

At Gale crater, Mars, ChemCam acquired its first laser-induced breakdown spectroscopy (LIBS) target on Sol 13 of the landed portion of the mission (a Sol is a Mars day). Up to Sol 800, more than 188 000 LIBS spectra were acquired on more than 5800 points distributed over about 650 individual targets. We present a comprehensive review of ChemCam scientific accomplishments during that period, together with a focus on the lessons learned from the first use of LIBS in space. For data processing, we describe new tools that had to be developed to account for the uniqueness of Mars data. With regard to chemistry, we present a summary of the composition range measured on Mars for major-element oxides (SiO 2 , TiO 2 , Al 2 O 3 , FeO T , MgO, CaO, Na 2 O, K 2 O) based on various multivariate models, with associated precisions. ChemCam also observed H, and the non-metallic elements C, O, P, and S, which are usually difficult to quantify with LIBS. F and Cl are observed through their molecular lines. We discuss the most relevant LIBS lines for detection of minor and trace elements (Li, Rb, Sr, Ba, Cr, Mn, Ni, and Zn). These results were obtained thanks to comprehensive ground reference datasets, which are set to mimic the expected mineralogy and chemistry on Mars. With regard to the first use of LIBS in space, we analyze and quantify, often for the first time, each of the advantages of using stand-off LIBS in space: no sample preparation, analysis within its petrological context, dust removal, sub-millimeter scale investigation, multi-point analysis, the ability to carry out statistical surveys and whole-rock analyses, and rapid data acquisition. We conclude with a discussion of ChemCam performance to survey the geochemistry of Mars, and its valuable support of decisions about selecting where and whether to make observations with more time and resource-intensive tools in the rover's instrument suite. In the end, we present a bird's-eye view of the many scientific results: discovery of felsic Noachian crust, first observation of hydrated soil, discovery of manganese-rich coatings and fracture fills indicating strong oxidation potential in Mars' early atmosphere, characterization of soils by grain size, and wide scale mapping of sedimentary strata, conglomerates, and diagenetic materials.

Journal of Analytical Atomic Spectrometry↗