Geology Reports⌕ Search

USGS · 70186733

Coalbed methane potential of the Upper Cretaceous Mesaverde and Meeteetse formations, Wind River Reservation, Wyoming

Abstract

The environments of deposition of the uppermost part of the Cody Shale and the Mesaverde and Meeteetse Formations of Late Cretaceous age were studied on outcrop in the Shotgun Butte area in the north-central part of the Wind River Reservation. A shoreface sandstone occurs in the lower part of the Mesaverde Formation at all localities studied, and is directly overlain by a coaly interval. Repetitive coarsening-upward cycles of mudstone, siltstone, and sandstone occur in the 200 ft interval of the upper part of the Cody Shale below the shoreface sandstone. These Cody sandstones are typically hummocky cross stratified with symmetrical ripples near the top, indicating that they are largely storm surge deposits that were later reworked. Channel-form sandstones from 10 to 20 ft thick, with abundant locally derived clayey clasts, occur in a 75 ft thick interval below the shoreface at one locality. These unusual sandstones are largely confined to a narrow area of the outcrop and grade laterally into more typical storm surge deposits. They may be unusually large storm surge channels created when high-energy flow conditions were localized to a limited area of the shelf. The Mesaverde Formation above the shoreface sandstone is divided into a middle member and the Teapot Sandstone Member. The lower part of the middle member is everywhere coaly. Erosional-based sandstones in this coaly interval are highly variable in thickness and architecture. Thin, single channel sandstone bodies were deposited by moderate to high sinuosity streams, and thick, multistory channel sandstone bodies were deposited by rapidly switching fluvial channel systems that remained relatively stationary for extended periods of time. The architecture of the fluvial channel sandstones in the overlying noncoaly interval appears to be highly variable as well, with complex multistory sandstones occurring at different stratigraphic levels at different localities. This distribution may be explained by long term stability of fluvial channel systems followed by major avulsion events. The Teapot Sandstone Member consists of fairly persistent to lenticular white multistory sandstone units that are as much as 85 ft thick and contain trough cross beds as much as 5 ft high. These sandstone units are interbedded with gray mudstones and carbonaceous shales. Paleosols are preserved at the tops of individual sandstones in the multistory units in some places. It is suggested that these sandstones were deposited largely by low-sinuosity to braided streams. The Meeteetse Formation consists of alternating coal and sandstone-rich intervals. The coal-rich intervals have relatively thin fluvial channel sandstones probably deposited by medium to high sinuosity streams whereas the sand-rich intervals have thick (to 105 ft) multistory fluvial channel sandstones possibly deposited by low-sinousity to braided streams.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R. C. Johnson, A.C. Clark, C.E. Barker, B.L. Crysdale, D.K. Higley, R.J. Szmajter, T.M. Finn. 1993. Coalbed methane potential of the Upper Cretaceous Mesaverde and Meeteetse formations, Wind River Reservation, Wyoming. https://pubs.usgs.gov/publication/70186733

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Authoritative knowledge infrastructure for GeoAI: Implications for scientific spatial data providers

Geospatial Artificial Intelligence (GeoAI) increasingly relies on automated analysis of authoritative geospatial data, exposing limitations in data infrastructures originally designed for simple dissemination rather than for knowledge-driven use. From the perspective of scientific spatial data providers, the challenge is enabling GeoAI responsibly while retaining semantic clarity, provenance, reproducibility, and governance. This short paper (i) examines how GeoAI exposed limitations within existing geospatial data infrastructures, and (ii) identifies provider-side requirements for an authoritative knowledge infrastructure. Drawing on GIScience, scientific workflow, and operational AI literature, the paper outlines implications for national mapping organizations that seek to support advanced analytics without jeopardizing scientific rigor or stewardship responsibilities.

Conference Paper↗

Springs of the Catskill Mountains: A conduit flow system in predominantly siliciclastic strata

The Catskill Mountains of New York state are composed of thick sequences of interbedded mudstone, sandstone, and siltstone that are intercalated with thin beds of paludal limestone and calcareous mudstone. Sandstones often contain rip-up clasts of calcareous material at their bases and contain minor amounts of carbonate cement throughout their mass. This minor amount of calcareous material weathers out to produce thin zones of solutional porosity and permeability integrated within perched aquifers that feed perennial hillslope springs. Solutional features are evident within thin carbonate lenses and along fractures in sandstones, occasionally resulting in explorable cave-sized conduits. This study focuses on the behavior of bedrock springs and seeps in the headwaters of the Neversink River basin above the Neversink Reservoir. Bedrock springs are numerous throughout the Catskill Mountains and serve to provide baseflow to the headwater streams that tends to be more persistent during dry times than other baseflow sources. We observed dissolution-influenced conduits within the bedrock, and suffosional conduits within unconsolidated materials. Continuous water temperature at six springs was monitored at hourly intervals from May to October 2022 to investigate the thermal response of groundwater to daily and seasonal changes in air temperature along with event-based meteorological events. Temperature monitoring was augmented at some springs with time-lapse photography to evaluate persistence of flow. The thermal responses of springs to precipitation events were highly variable across sites, with some springs exhibiting flashy responses indicating a strong connection to the surface, while other springs showed muted or no thermal response to events. The seasonal thermal response also varied across sites having lag times of 23-48 days between peak air temperature and peak spring water temperature. The water temperatures and geochemical compositions of these bedrock springs support a conceptual model of multiple residence times, showing both event and seasonal groundwater storage within the conduit flow system that feeds the springs of the Catskill Mountains.

New York↗

Stability changes after weak layer collapse: Insights from an unexpected dataset

While conducting avalanche mitigation or traveling through the backcountry, avalanche professionals sometimes experience a "whumpf": a collapse-mode crack accompanied by surface cracking that does not produce an avalanche. These whumpfs are a clear warning sign of instability in the surrounding terrain. But assessing the collapsed slope itself, if it is steep enough to avalanche, carries much more uncertainty. Can slopes that whumpf and are steep enough to slide still avalanche? The answer to this question supports avalanche mitigators and ski guides in assessing whether to open such slopes. Previous research on collapsed slopes is limited to one study conducted before tests that estimate crack propagation propensity, such as the Propagation Saw Test (PST), were developed. This work showed that weak layer shear strength decreased immediately after collapsing and then increased over time. However, no research has examined crack propagation propensity after a whumpf. Studying propagation propensity is key for assessing how whumpfs immediately affect slope stability. To improve our understanding of changes in propagation propensity following weak layer collapse, we conducted PSTs on a test slope in the hours and days after an unexpected collapse occurred on a layer of surface hoar. Two PSTs at our study site three days prior to this collapse provided an estimate of weak layer propagation propensity. PST cut lengths decreased immediately following the collapse, suggesting that the collapse increased the propagation propensity. However, over the next 4-5 hours, PST cut lengths steadily increased at our site, likely due to ongoing sintering and strengthening in the collapsed weak layer. By the end of day two, we were no longer able to initiate propagation, suggesting substantial stabilization of the weak layer. Our results support prior findings and observations suggesting that slopes may remain capable of producing avalanches immediately after a collapse but likely stabilize over the next day or two. Although this research does not provide answers about precisely when a slope becomes stable after a collapse, it does highlight uncertainties in our understanding and interpretation of the stability of slopes that have whumped.

Montana↗