Geology Reports⌕ Search

USGS · 70164501

Quality of water in alluvial aquifers in eastern Iowa

Abstract

The goal of the U.S. Geological Survey (USGS) National Water-Quality Assessment (NAWQA) Program is to assess the status and trends in the quality of the Nation's surface and ground water, and to better understand the natural and human factors affecting water quality. The Eastern Iowa Basins study unit encompasses an area of about 50,500 square kilometers (19,500 square miles) in eastern Iowa and southern Minnesota and is one of 59 study units in the NAWQA program. Land-use studies are an important component of the NAWQA program, and are designed to assess the concentration and distribution of water-quality constituents in recently recharged ground water associated with the most significant land use and hydrogeologic settings within a study unit. The focus of the land-use study in the Eastern Iowa Basins study unit is agricultural and urban land uses and alluvial aquifers. Agriculture is the dominant land use in the study unit. Urban areas, although not extensive, represent important potential source areas of contaminants associated with residential, commercial, and industrial activities. Alluvial aquifers are present throughout much of the study unit, and constitute a major ground-water supply that is susceptible to contamination from land-use activities. Ground-water samples were collected from monitoring wells at 31 agricultural and 30 urban sites in the Eastern Iowa Basins study unit during June-August 1997 to evaluate the effects of land use and hydrogeology on the water quality of alluvial aquifers. Calcium, magnesium, and bicarbonate were the dominant ions in most samples and were likely derived from solution of carbonate minerals (calcite and dolomite) present in alluvial detrital deposits. Tritium-based ages indicate ground water was most likely recharged after the 1950's at all but one sampling site. Agricultural and urban land-use areas have remained relatively stable in the study area since the 1950's, therefore the effects of current land use should be reflected in ground water sampled during this study. Sodium and chloride concentrations were significantly higher in samples from urban areas, where roads are more numerous and road salts may be more frequently applied, than in agricultural areas. Nitrate was detected in 94 percent of samples from agricultural areas and 77 percent of samples from urban areas. Nitrate concentrations were significantly higher in agricultural areas than in urban areas and exceeded the U.S. Environmental Protection Agency maximum contaminant level for drinking water (10 milligrams per liter as N) in 39 percent of samples from agricultural areas. Nitrate concentrations in samples from urban areas did not exceed the maximum contaminant level. Greater usage of fertilizers in agricultural areas most likely contributes to higher nitrate concentrations in samples from those areas. Pesticides were detected in 84 percent of samples from agricultural areas and 70 percent from urban areas. Atrazine and metolachlor were the most frequently detected pesticides in samples from agricultural areas; atrazine and prometon were the most frequently detected pesticides in samples from urban areas. None of the pesticide concentrations exceeded U.S. Environmental Protection Agency maximum contaminant levels or lifetime health advisories for drinking water. Pesticide degradates were detected in 94 percent of samples from agricultural areas and 53 percent from urban areas. Metolachlor ethane sulfonic acid and deethylatrazine were the most frequently detected metabolites in samples from agricultural areas; metolachlor ethane sulfonic acid and alachlor ethane sulfonic acid were the most frequently detected degradates in samples from urban areas. Total degradate concentrations were significantly higher in samples from agricultural areas than in samples from urban areas. Total pesticide concentrations (parent compounds) tended to be higher in samples from agricultural areas; however, this difference was not statistically significant. Degradates constituted the major portion of the total residue concentration in the alluvial aquifer. Volatile organic compounds were detected in 40 percent of samples from urban areas and 10 percent from agricultural areas. Methyl tert-butyl ether was the most commonly detected volatile organic compound and was present in 23 percent of samples from urban areas. Elevated concentrations (greater than 30 micrograms per liter) of methyl tert-butyl ether and BTEX compounds (benzene, toluene, ethylbenzene, and xylene) in two samples from urban areas suggest the possible presence of point-source gasoline leaks or spills. Factors other than land use may contribute to observed differences in water quality between and within agricultural and urban areas. Nitrate, atrazine, deethylatrazine, and deisopropylatrazine concentrations were significantly higher in shallow wells with sample intervals nearer the water table and in wells with thinner cumulative clay thickness above the sample intervals, suggesting that longer flow paths allow for greater residence time and increase opportunities for sorbtion, degradation, and dispersion which may contribute to decreases in nutrient and pesticide concentrations with depth. Nitrogen speciation was influenced by redox conditions. Nitrate concentrations were significantly higher in ground water with dissolved-oxygen concentrations in excess of 0.5 milligrams per liter. Ammonia concentrations were higher in ground water with dissolved-oxygen concentrations of 0.5 milligrams per liter or less, however, this relation was not statistically significant. The amount of available organic matter may limit denitrification rates. Elevated nitrate concentrations (greater than 2.0 mg/L) were significantly related to lower dissolved organic carbon concentrations in water samples from both agricultural and urban areas. A similar relation between nitrate concentrations (in water) and organic carbon concentrations (in aquifer material) also was observed but was not statistically significant.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.375501° to 43.50055° latitude; -96.638621° to -90.140061° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Mark E. Savoca, Eric M. Sadorf, S. Michael Linhart, Kimberlee K. Barnes. 2001. Quality of water in alluvial aquifers in eastern Iowa. https://pubs.usgs.gov/publication/70164501

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Authoritative knowledge infrastructure for GeoAI: Implications for scientific spatial data providers

Geospatial Artificial Intelligence (GeoAI) increasingly relies on automated analysis of authoritative geospatial data, exposing limitations in data infrastructures originally designed for simple dissemination rather than for knowledge-driven use. From the perspective of scientific spatial data providers, the challenge is enabling GeoAI responsibly while retaining semantic clarity, provenance, reproducibility, and governance. This short paper (i) examines how GeoAI exposed limitations within existing geospatial data infrastructures, and (ii) identifies provider-side requirements for an authoritative knowledge infrastructure. Drawing on GIScience, scientific workflow, and operational AI literature, the paper outlines implications for national mapping organizations that seek to support advanced analytics without jeopardizing scientific rigor or stewardship responsibilities.

Conference Paper↗

Springs of the Catskill Mountains: A conduit flow system in predominantly siliciclastic strata

The Catskill Mountains of New York state are composed of thick sequences of interbedded mudstone, sandstone, and siltstone that are intercalated with thin beds of paludal limestone and calcareous mudstone. Sandstones often contain rip-up clasts of calcareous material at their bases and contain minor amounts of carbonate cement throughout their mass. This minor amount of calcareous material weathers out to produce thin zones of solutional porosity and permeability integrated within perched aquifers that feed perennial hillslope springs. Solutional features are evident within thin carbonate lenses and along fractures in sandstones, occasionally resulting in explorable cave-sized conduits. This study focuses on the behavior of bedrock springs and seeps in the headwaters of the Neversink River basin above the Neversink Reservoir. Bedrock springs are numerous throughout the Catskill Mountains and serve to provide baseflow to the headwater streams that tends to be more persistent during dry times than other baseflow sources. We observed dissolution-influenced conduits within the bedrock, and suffosional conduits within unconsolidated materials. Continuous water temperature at six springs was monitored at hourly intervals from May to October 2022 to investigate the thermal response of groundwater to daily and seasonal changes in air temperature along with event-based meteorological events. Temperature monitoring was augmented at some springs with time-lapse photography to evaluate persistence of flow. The thermal responses of springs to precipitation events were highly variable across sites, with some springs exhibiting flashy responses indicating a strong connection to the surface, while other springs showed muted or no thermal response to events. The seasonal thermal response also varied across sites having lag times of 23-48 days between peak air temperature and peak spring water temperature. The water temperatures and geochemical compositions of these bedrock springs support a conceptual model of multiple residence times, showing both event and seasonal groundwater storage within the conduit flow system that feeds the springs of the Catskill Mountains.

New York↗

Stability changes after weak layer collapse: Insights from an unexpected dataset

While conducting avalanche mitigation or traveling through the backcountry, avalanche professionals sometimes experience a "whumpf": a collapse-mode crack accompanied by surface cracking that does not produce an avalanche. These whumpfs are a clear warning sign of instability in the surrounding terrain. But assessing the collapsed slope itself, if it is steep enough to avalanche, carries much more uncertainty. Can slopes that whumpf and are steep enough to slide still avalanche? The answer to this question supports avalanche mitigators and ski guides in assessing whether to open such slopes. Previous research on collapsed slopes is limited to one study conducted before tests that estimate crack propagation propensity, such as the Propagation Saw Test (PST), were developed. This work showed that weak layer shear strength decreased immediately after collapsing and then increased over time. However, no research has examined crack propagation propensity after a whumpf. Studying propagation propensity is key for assessing how whumpfs immediately affect slope stability. To improve our understanding of changes in propagation propensity following weak layer collapse, we conducted PSTs on a test slope in the hours and days after an unexpected collapse occurred on a layer of surface hoar. Two PSTs at our study site three days prior to this collapse provided an estimate of weak layer propagation propensity. PST cut lengths decreased immediately following the collapse, suggesting that the collapse increased the propagation propensity. However, over the next 4-5 hours, PST cut lengths steadily increased at our site, likely due to ongoing sintering and strengthening in the collapsed weak layer. By the end of day two, we were no longer able to initiate propagation, suggesting substantial stabilization of the weak layer. Our results support prior findings and observations suggesting that slopes may remain capable of producing avalanches immediately after a collapse but likely stabilize over the next day or two. Although this research does not provide answers about precisely when a slope becomes stable after a collapse, it does highlight uncertainties in our understanding and interpretation of the stability of slopes that have whumped.

Montana↗