Geology Reports⌕ Search

USGS · 70164480

Occurrence, distribution, and transport of nutrients in Eastern Iowa Rivers

Abstract

Eleven streams in the Wapsipinicon, Cedar, Iowa, and Skunk River basins in eastern Iowa were sampled monthly from March 1996 through September 1998 to assess the occurrence, distribution, and transport of nitrogen, phosphorus, and suspended sediment as part of the U.S. Geological Survey's National Water-Quality Assessment Program. At least one form of dissolved nitrogen and phosphorus was detected in every sample collected. Nitrate accounted for 92 percent of the dissolved nitrogen. About 22 percent of the samples contained nitrate that exceeded the U.S. Environmental Protection Agency's Maximum Contaminant Level of 10 milligrams per liter (mg/L) as nitrogen in drinking water. The median concentration of total nitrogen for surface water in the study area was 7.2 mg/L. Dissolved phosphorus was predominately in the form of orthophosphate. The median total phosphorus concentration for the study area was 0.22 mg/L. About 75 percent of the total phosphorus concentrations exceeded the U.S. Environmental Protection Agency recommended total phosphorus concentration of 0.10 mg/L or less to minimize algal growth in streams not discharging directly into lakes or impoundments. Median suspended-sediment concentration for the study area was 82 mg/L. Nitrogen, phosphorus, and suspended-sediment concentrations varied annually and seasonally. Nitrogen, phosphorus, and suspended-sediment concentrations increased each year of the study due to increased precipitation and runoff. Concentrations were typically higher in the spring after fertilizer application and runoff. In winter, nitrogen concentrations typically increased when there was little instream assimilation by aquatic plants and algae. Nitrogen and phosphorus concentrations decreased in late summer when there was less runoff and instream assimilation of nitrogen and phosphorus by aquatic plants and algae was high. Suspended-sediment concentrations were highest in early summer during runoff and lowest in January when there was ice cover with very little overland flow contributing to rivers and streams. Streams draining small- to medium-sized watersheds that have uniform land use and geology had significantly (p < 0.05) higher total dissolved-nitrogen concentrations (median, 8.2 mg/L) than did samples from large rivers (median, 6.2 mg/L) that drain basins with mixed land use and geology. Samples from large rivers typically had significantly (p< 0.05) higher total phosphorus and suspended-sediment concentrations than did samples from small rivers and streams. Concentrations varied between drainage basins due to land use and physiography. Basins that are located in areas with a higher percentage of row-crop agriculture typically had samples with higher nitrogen concentrations than did basins with less row-crop agriculture. In addition, basins that drain the Southern Iowa Drift Plain and the Des Moines Lobe typically had samples with higher total phosphorus and suspended-sediment concentrations than did basins that drain other landform regions. Total nitrogen and total phosphorus loads were typically proportional to the size of the drainage basin. Total nitrogen loads increased each year from 1996 through 1998 in conjunction with increased concentrations and runoff. However, total phosphorus loads in the Skunk River Basin decreased in 1997 due to less runoff. Total phosphorus loads followed the same pattern as total nitrogen loads with increases in 1998. Total nitrogen and total phosphorus loads varied seasonally and the highest loads typically occurred in early spring and summer after fertilizer application and runoff. Loads were lowest in January and September when there was little runoff to transport nitrogen and phosphorus to the rivers and streams. Total nitrogen loads contributed to the Mississippi River from the Eastern Iowa Basins during 1996, 1997, and 1998 were 97,000, 120,000, and 230,000 metric tons respectively. Total phosphorus loads contributed to the Mississippi River from the Eastern Iowa Basins during 1996, 1997, and 1998 were 6,900, 4,600, and 8,800 metric tons, respectively. The highest nitrogen and phosphorus yields typically occurred in streams draining small watersheds that were dominated by a single land use and geology. Sampling sites located in drainage basins with higher row-crop percentage typically had higher nitrogen and phosphorus yields. Sites that were located in the Des Moines Lobe and the Southern Iowa Drift Plain typically had higher phosphorus yields probably due to more erodible soils and steeper slopes.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.375501° to 43.50055° latitude; -96.638621° to -90.140061° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Kent Becher. 2001. Occurrence, distribution, and transport of nutrients in Eastern Iowa Rivers. https://pubs.usgs.gov/publication/70164480

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Authoritative knowledge infrastructure for GeoAI: Implications for scientific spatial data providers

Geospatial Artificial Intelligence (GeoAI) increasingly relies on automated analysis of authoritative geospatial data, exposing limitations in data infrastructures originally designed for simple dissemination rather than for knowledge-driven use. From the perspective of scientific spatial data providers, the challenge is enabling GeoAI responsibly while retaining semantic clarity, provenance, reproducibility, and governance. This short paper (i) examines how GeoAI exposed limitations within existing geospatial data infrastructures, and (ii) identifies provider-side requirements for an authoritative knowledge infrastructure. Drawing on GIScience, scientific workflow, and operational AI literature, the paper outlines implications for national mapping organizations that seek to support advanced analytics without jeopardizing scientific rigor or stewardship responsibilities.

Conference Paper↗

Springs of the Catskill Mountains: A conduit flow system in predominantly siliciclastic strata

The Catskill Mountains of New York state are composed of thick sequences of interbedded mudstone, sandstone, and siltstone that are intercalated with thin beds of paludal limestone and calcareous mudstone. Sandstones often contain rip-up clasts of calcareous material at their bases and contain minor amounts of carbonate cement throughout their mass. This minor amount of calcareous material weathers out to produce thin zones of solutional porosity and permeability integrated within perched aquifers that feed perennial hillslope springs. Solutional features are evident within thin carbonate lenses and along fractures in sandstones, occasionally resulting in explorable cave-sized conduits. This study focuses on the behavior of bedrock springs and seeps in the headwaters of the Neversink River basin above the Neversink Reservoir. Bedrock springs are numerous throughout the Catskill Mountains and serve to provide baseflow to the headwater streams that tends to be more persistent during dry times than other baseflow sources. We observed dissolution-influenced conduits within the bedrock, and suffosional conduits within unconsolidated materials. Continuous water temperature at six springs was monitored at hourly intervals from May to October 2022 to investigate the thermal response of groundwater to daily and seasonal changes in air temperature along with event-based meteorological events. Temperature monitoring was augmented at some springs with time-lapse photography to evaluate persistence of flow. The thermal responses of springs to precipitation events were highly variable across sites, with some springs exhibiting flashy responses indicating a strong connection to the surface, while other springs showed muted or no thermal response to events. The seasonal thermal response also varied across sites having lag times of 23-48 days between peak air temperature and peak spring water temperature. The water temperatures and geochemical compositions of these bedrock springs support a conceptual model of multiple residence times, showing both event and seasonal groundwater storage within the conduit flow system that feeds the springs of the Catskill Mountains.

New York↗

Stability changes after weak layer collapse: Insights from an unexpected dataset

While conducting avalanche mitigation or traveling through the backcountry, avalanche professionals sometimes experience a "whumpf": a collapse-mode crack accompanied by surface cracking that does not produce an avalanche. These whumpfs are a clear warning sign of instability in the surrounding terrain. But assessing the collapsed slope itself, if it is steep enough to avalanche, carries much more uncertainty. Can slopes that whumpf and are steep enough to slide still avalanche? The answer to this question supports avalanche mitigators and ski guides in assessing whether to open such slopes. Previous research on collapsed slopes is limited to one study conducted before tests that estimate crack propagation propensity, such as the Propagation Saw Test (PST), were developed. This work showed that weak layer shear strength decreased immediately after collapsing and then increased over time. However, no research has examined crack propagation propensity after a whumpf. Studying propagation propensity is key for assessing how whumpfs immediately affect slope stability. To improve our understanding of changes in propagation propensity following weak layer collapse, we conducted PSTs on a test slope in the hours and days after an unexpected collapse occurred on a layer of surface hoar. Two PSTs at our study site three days prior to this collapse provided an estimate of weak layer propagation propensity. PST cut lengths decreased immediately following the collapse, suggesting that the collapse increased the propagation propensity. However, over the next 4-5 hours, PST cut lengths steadily increased at our site, likely due to ongoing sintering and strengthening in the collapsed weak layer. By the end of day two, we were no longer able to initiate propagation, suggesting substantial stabilization of the weak layer. Our results support prior findings and observations suggesting that slopes may remain capable of producing avalanches immediately after a collapse but likely stabilize over the next day or two. Although this research does not provide answers about precisely when a slope becomes stable after a collapse, it does highlight uncertainties in our understanding and interpretation of the stability of slopes that have whumped.

Montana↗