Delineation of buried glacial drift aquifers

Abstract

Locating and delineating buried glacial-drift aquifers poses one of the major problems to hydrogeologists working in glacial terrain. To show the vertical and horizontal boundaries of aquifers, most techniques require a multiple set of maps, a fence diagram, or a combination of maps and sections. Calculations of the first two moments, mean and standard deviation, of a discontinuous distribution result in values that represent the center of gravity (mean position) and spread (standard deviation) of all the sand units in a drill hole. Data for the moment method consist of depth to center point and thickness of each sand unit. A 2.600 mi 2 (6,730 km 2 ) area in northwestern Minnesota that, contained 71 test holes drilled to bedrock was used to test the usefulness of the moment method in glacial terrain. Plots of relative position of center of gravity and relative spread (calculated as percentage of total drift thickness) showed three groupings for relative center of gravity (shallow, 0-26 percent, medium, 30-55. and deep 58-72) and three for spread of sand units (narrow, 1-5 percent, medium, 8-19, and wide, 22-38). The resulting vertical-variability pattern map shows the areas of each of the nine combinations of these two factors. Because the vertical-variability map does not show quantity of sand, the map is most informative if the total thickness of sand, 01- percent sand of total drift thickness, is recorded by each hole location on the map. The center of gravity is useful for describing the vertical position of the principal sand in a drill hole because it lies within the principal sand unit in 34 of the 63 holes that contained sand, and it is within 15 percent (based on total drift, thickness) of the principal sand unit in 22 of the remaining 29 holes.