Geology ReportsSearch

USGS · 70058014

Integration of stable carbon isotope, microbial community, dissolved hydrogen gas, and 2 H H 2 O tracer data to assess bioaugmentation for chlorinated ethene degradation in fractured rocks

Abstract

An in situ bioaugmentation (BA) experiment was conducted to understand processes controlling microbial dechlorination of trichloroethene (TCE) in groundwater at the Naval Air Warfare Center (NAWC), West Trenton, NJ. In the BA experiment, an electron donor (emulsified vegetable oil and sodium lactate) and a chloro-respiring microbial consortium were injected into a well in fractured mudstone of Triassic age. Water enriched in 2 H was also injected as a tracer of the BA solution, to monitor advective transport processes. The changes in concentration and the δ 13 C of TCE, cis-dichloroethene (cis-DCE), and vinyl chloride (VC); the δ 2 H of water; changes in the abundance of the microbial communities; and the concentration of dissolved H2 gas compared to pre- test conditions, provided multiple lines of evidence that enhanced biodegradation occurred in the injection well and in two downgradient wells. For those wells where the biodegradation was stimulated intensively, the sum of the molar chlorinated ethene (CE) concentrations in post-BA water was higher than that of the sum of the pre-BA background molar CE concentrations. The concentration ratios of TCE/(cis-DCE + VC) indicated that the increase in molar CE concentration may result from additional TCE mobilized from the rock matrix in response to the oil injection or due to desorption/diffusion. The stable carbon isotope mass-balance calculations show that the weighted average 13 C isotope of the CEs was enriched for around a year compared to the background value in a two year monitoring period, an effective indication that dechlorination of VC was occurring. Insights gained from this study can be applied to efforts to use BA in other fractured rock systems. The study demonstrates that a BA approach can substantially enhance in situ bioremediation not only in fractures connected to the injection well, but also in the rock matrix around the well due to processes such as diffusion and desorption. Because the effect of the BA was intensive only in wells where an amendment was distributed during injection, it is necessary to adequately distribute the amendments throughout the fractured rock to achieve substantial bioremediation. The slowdown in BA effect after a year is due to some extend to the decrease abundant of appropriate microbes, but more likely the decreased concentration of electron donor.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.209396° to 40.283997° latitude; -74.838496° to -74.725712° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Kinga M. Revesz, Barbara Sherwood Lollar, Julie D. Kirshtein, Claire R. Tiedeman, Thomas E. Imbrigiotta, Daniel J. Goode, Allen M. Shapiro, Mary A. Voytek, Pierre J. Lancombe, Eurybiades Busenberg. 2014. Integration of stable carbon isotope, microbial community, dissolved hydrogen gas, and 2 H H 2 O tracer data to assess bioaugmentation for chlorinated ethene degradation in fractured rocks. https://doi.org/10.1016/j.jconhyd.2013.10.004

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Distinguishing natural from mining-related metal sources by including streambank groundwater data in a stream mass loading study

Distinguishing stream metal loading caused by mine features from that caused by natural background sources remains challenging, yet this distinction is essential for making effective remedial decisions at many legacy mine sites. We combine a stream tracer injection and synoptic sampling study with data from shallow near-stream groundwater wells to estimate left-bank versus right-bank metal loading contributions at the 100-m spatial scale. The study was performed in the East Mancos River, a mountain headwater stream in Colorado, USA. The dominant source of elevated stream metal concentrations could be either groundwater infiltration through right-bank Doyle Mine waste piles or natural acid rock drainage from hydrothermally altered bedrock located mainly on the left bank. For the five metals of concern (Cu, Al, Zn, Cd, and Mn), we find that 15 % of the load contributed by diffuse groundwater inputs in the section potentially influenced by Doyle mine waste originates from the right bank. This right-bank potential mine contribution equates to only 3 % of the total watershed instream load for these metals. Furthermore, apparent 3 H/ 3 He groundwater ages in segments contributing most of the right-bank metal loading are sufficiently old (9–12 yr) to suggest that infiltration through the waste piles, located only 140–180 m from the stream, is unlikely. Estimated potential Doyle mine loading contributions can therefore be considered maximum values. Study results thus indicate that Doyle mine waste piles are a minor source of metal loading under low-flow conditions, and streambank groundwater data can provide valuable additional information in stream mass loading studies.

Colorado

Per- and polyfluoroalkyl substances (PFAS) mass flux and mass balance at an aqueous film-forming foam release site in semiarid eastern New Mexico, USA

Passive flux meters (PFMs) directly measure groundwater chemistry mass flux and Darcy flux, providing insight into contaminant source-zone architecture and transport properties. This study uses PFMs to characterize PFAS flux in groundwater at a semiarid site with a thick (greater than 90-m) unsaturated zone where groundwater has been contaminated with per - and polyfluoroalkyl substances (PFAS) related to the use of aqueous film-forming foam (AFFF) for fire training and fire suppression. PFAS mass discharge (PFAS mass flux integrated over a control plane) in groundwater downgradient from several PFAS release areas is calculated using PFM results. In groundwater downgradient from fire-training areas, total PFAS mass discharge (summed across 14 compounds) was estimated to be between 6.0 and 31 g per day in 2020 and between 5.9 and 23 g per day in 2021. Site-specific documentation, generic information on AFFF properties, and literature values of PFAS concentration in AFFF are used to estimate site-specific PFAS-application rates at fire-training areas. These PFAS-application rates are compared to groundwater PFAS-discharge rates. Results suggest that transformation processes (exact pathways unknown) have led to increased discharge of measured PFAS in groundwater relative to initial AFFF formulations. The mass balance approach has broad applicability as a high-level approach that can provide insight into PFAS transport at AFFF sites.

New Mexico

Concentration-discharge relations and transient metal loads reveal spatiotemporal variability in solute-generation mechanisms in a mine-affected watershed

Concentration-discharge (CQ) relations are commonly used to understand geochemical and hydrologic controls on the generation of solutes in watersheds. Despite the widespread application of CQ relations, this technique has been infrequently applied to acid mine drainage (AMD) sites, but the CQ framework may allow mechanistic understanding of remedial outcomes such as impoundment of water within underground mines. Results of CQ analyses and changes in metal loads in an AMD affected watershed in Colorado, USA indicate that dissolved loads increased at many individual locations following water impoundment within mine workings. Although increased loads were observed at most individual locations, these increases were offset by a large decrease in loading from the largest mine. A loading analysis that included data from an instream monitoring location showed a statistically significant decrease in Fe and Zn after bulkhead emplacement, indicating a net positive effect of bulkheads. Streams generally displayed dilution CQ patterns whereas mines and springs showed either flushing or chemostatic patterns prior to bulkheading, which transitioned to chemostatic patterns following bulkheading, indicating a transition from dynamic to equilibrium geochemical processes. Saturation indices for sulfide and secondary minerals indicated that mines and springs were near equilibrium for phases including schwertmannite, fluorite, and gypsum. Saturation indices vary through time for mines suggesting progressive leaching of sulfide minerals as the mass of available minerals in the mine workings decreases. Together, these diverse analyses provide an integrated understanding of the variability in solute generating processes in this watershed and may inform remediation plans for similarly affected sites by indicating the nature of mineralogic controls on water quality.

Colorado