Geology Reports⌕ Search

USGS · 70047852

Probabilistic estimates of surface coseismic slip and afterslip for Hayward fault earthquakes

Abstract

We examine the partition of long‐term geologic slip on the Hayward fault into interseismic creep, coseismic slip, and afterslip. Using Monte Carlo simulations, we compute expected coseismic slip and afterslip at three alinement array sites for Hayward fault earthquakes with nominal moment magnitudes ranging from about 6.5 to 7.1. We consider how interseismic creep might affect the coseismic slip distribution as well as the variability in locations of large and small slip patches and the magnitude of an earthquake for a given rupture area. We calibrate the estimates to be consistent with the ratio of interseismic creep rate at the alinement array sites to the geologic slip rate for the Hayward fault. We find that the coseismic slip at the surface is expected to comprise only a small fraction of the long‐term geologic slip. The median values of coseismic slip are less than 0.2 m in nearly all cases as a result of the influence of interseismic creep and afterslip. However, afterslip makes a substantial contribution to the long‐term geologic slip and may be responsible for up to 0.5–1.5 m (median plus one standard deviation [S.D.]) of additional slip following an earthquake rupture. Thus, utility and transportation infrastructure could be severely impacted by afterslip in the hours and days following a large earthquake on the Hayward fault that generated little coseismic slip. Inherent spatial variability in earthquake slip combined with the uncertainty in how interseismic creep affects coseismic slip results in large uncertainties in these slip estimates.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 0.0008333333333333334° to 0.0008333333333333334° latitude; -0.01611111111111111° to -0.01611111111111111° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Brad T. Aagaard, James J. Lienkaemper, David P. Schwartz. 2012-06-05. Probabilistic estimates of surface coseismic slip and afterslip for Hayward fault earthquakes. https://doi.org/10.1785/0120110200

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Re-evaluation of shaking, dynamic strain, and the source of the 1886 Charleston, South Carolina, earthquake

As the largest historical event in the eastern United States, the 1886 Charleston, South Carolina, earthquake, plays a prominent role in our nation’s seismological and human history and an outsized role in our probabilistic ground‐motion hazard estimates, affecting building codes, insurance rates, and geophysical monitoring. Thus, constraining the characteristics of the 1886 earthquake source, as well as the nature of its shaking distribution and impacts to the extent possible, is essential. Given its vintage, however, societal, geological, and geophysical datasets are limited compared with those used in modern seismological analyses. Because of these limitations, some characteristics of the rupture model are fundamentally nonunique. Still, by re‐evaluating all available data, I can constrain several key aspects of this earthquake. I show that several interpretations in recent analyses are inconsistent regarding the inferred source; shaking; ground failure; and, particularly, railway impacts. Importantly, I have shown that although dynamic strain caused the ground failure that led to track deformation, without the intermediate liquefaction step, dynamic strain alone was unlikely to be the source of rail deformation, contrary to earlier studies. Had earlier pronouncements that dynamic strain is a real concern for bending railways held true, there would be serious ramifications for railway engineering as well as for other above‐ and below‐ground linear infrastructure.

South Carolina↗

ETAS-positive: Extracting unbiased epidemic-type aftershock models from incomplete earthquake catalogs

Earthquake catalogs are inherently incomplete, and short-term fluctuations in catalog completeness can strongly bias estimates of seismicity parameters. Here, we extend the positive statistics framework recently introduced for estimating Gutenberg–Richter a and b values to the Epidemic-Type Aftershock Sequence (ETAS) model. The approach focuses on complete magnitude–time intervals defined by pairs of earthquakes in which the second event is larger than the first. Comprehensive synthetic tests demonstrate that the proposed ETAS + method retrieves nearly unbiased parameter estimates even from highly incomplete catalogs, whereas parameters obtained using classical estimation approaches are strongly biased. Application to Southern California reveals a similar trend, with the productivity scaling parameter α approaching the b value, consistent with self-similar earthquake triggering within estimation uncertainties. Owing to its robustness against catalog incompleteness and computational efficiency, the ETAS + method provides a powerful new tool for seismicity analysis and earthquake forecasting.

California↗