Use of a watershed model to characterize the fate and transport of fluometuron, a soil-applied cotton herbicide, in surface water

R.H. Coupe

doi:10.1080/03067310701627819

Home/Archive/USGS

USGS · 70031528

Use of a watershed model to characterize the fate and transport of fluometuron, a soil-applied cotton herbicide, in surface water

R.H. Coupe

View original source ↗Export metadata ↓

Abstract

The Soil and Water Assessment Tool (SWAT) was used to characterize the fate and transport of fluometuron (a herbicide used on cotton) in the Bogue Phalia Basin in northwestern Mississippi, USA. SWAT is a basin-scale watershed model, able to simulate hydrological, chemical, and sediment transport processes. After adjustments to a few parameters (specifically the SURLAG variable, the runoff curve number, Manning's N for overland flow, soil available water capacity, and the base-flow alpha factor) the SWAT model fit the observed streamflow well (the Coefficient of Efficiency and R2 were greater than 60). The results from comparing observed fluometuron concentrations with simulated concentrations were reasonable. The simulated concentrations (which were daily averages) followed the pattern of observed concentrations (instantaneous values) closely, but could be off in magnitude at times. Further calibration might have improved the fit, but given the uncertainties in the input data, it was not clear that any improvement would be due to a better understanding of the input variables. ?? 2007 Taylor & Francis.

Explore related subjects

International Journal of Environmental Analytical Chemistry Article

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

R.H. Coupe. 2007. Use of a watershed model to characterize the fate and transport of fluometuron, a soil-applied cotton herbicide, in surface water. https://doi.org/10.1080/03067310701627819

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2007

Development and evaluation of a gas chromatographic method for the determination of triazine herbicides in natural water samples

A multi-residue method is described for the determination o triazine herbicides in natural water samples. The technique uses solvent extraction followed by gas chromatographic separation and detection employing nitrogen-selective devices. Seven compounds can be determined simultaneously at a nominal detection limit of 0.1 μg/L in a 1-litre sample. Three different natural water samples were used for error analysis via evaluation of recovery efficiencies and estimation of overall method precision. As an alternative to liquid-liquid partition (solvent extraction) for removal of compounds of interest from water, solid-phase extraction (SPE) techniques employing chromatographic grade silicas with chemically modified surfaces have been examined. SPE is found to provide rapid and efficient concentration with quantitative recovery of some triazine herbicides from natural water samples. Concentration factors of 500 to 1000 times are obtained readily by the SPE technique.

International Journal of Environmental Analytical ↗

USGS2007

Input, flux, and persistence of six select pesticides in San Francisco Bay

Temporal patterns of pesticide inputs to San Francisco Bay were identified and correlated with timing of application and transport mechanism. Fluxes were calculated from measured concentrations and estimated flow. Persistence of the pesticides under typical riverine or estuarine conditions were estimated from laboratory experiments. Simazine was detected most frequently and had the highest flux into the Bay, which could be explained by its continuous use and long half-life. In comparison, diazinon was detected at lower concentrations and had a lower flux which corresponded to its lower use and shorter half-life. The order-of-magnitude lower fluxes of carbofuran and methidathion corresponded to their lower use and expected hydrolysis. Molinate was detected at the highest concentration but its flux was lower than expected, considering its very high use and persistence in the laboratory experiments. Additional loss of molinate is likely to occur from volatilization and photodegradation on the rice fields. Although thiobencarb had the second highest use, it had the lowest flux of the six pesticides, which can be attributed to its loss via hydrolysis, photodegradation, volatilization, and sorption to sediments. Fluxes into San Francisco Bay were equal to or greater than those reported for other estuaries, except for the Gulf of Mexico.

California↗

USGS2006

A laboratory and field evaluation of a portable immunoassay test for triazine herbicides in environmental water samples

The usefulness and sensitivity, of a portable immunoassay test for the semiquantitative field screening of water samples was evaluated by means of laboratory and field studies. Laboratory results indicated that the tests were useful for the determination of atrazine concentrations of 0.1 to 1.5 μg/L. At a concentration of 1 μg/L, the relative standard deviation in the difference between the regression line and the actual result was about 40 percent. The immunoassay was less sensitive and produced similar errors for other triazine herbicides. After standardization, the test results were relatively insensitive to ionic content and variations in pH (range, 4 to 10), mildly sensitive to temperature changes, and quite sensitive to the timing of the final incubation step, variances in timing can be a significant source of error. Almost all of the immunoassays predicted a higher atrazine concentration in water samples when compared to results of gas chromatography. If these tests are used as a semiquantitative screening tool, this tendency for overprediction does not diminish the tests' usefulness. Generally, the tests seem to be a valuable method for screening water samples for triazine herbicides.

International Journal of Environmental Analytical ↗