Geology Reports⌕ Search

USGS · 70029592

Progression of methanogenic degradation of crude oil in the subsurface

Abstract

Our results show that subsurface crude-oil degradation rates at a long-term research site were strongly influenced by small-scale variations in hydrologic conditions. The site is a shallow glacial outwash aquifer located near Bemidji in northern Minnesota that became contaminated when oil spilled from a broken pipeline in August 1979. In the study area, separate-phase oil forms a subsurface oil body extending from land surface to about 1 m (3.3 ft) below the 6–8-m (20–26 ft)-deep water table. Oil saturation in the sediments ranges from 10–20% in the vadose zone to 30–70% near the water table. At depths below 2 m (6.6 ft), degradation of the separate-phase crude oil occurs under methanogenic conditions. The sequence of methanogenic alkane degradation depletes the longer chain n-alkanes before the shorter chain n-alkanes, which is opposite to the better known aerobic sequence. The rates of degradation vary significantly with location in the subsurface. Oil-coated soils within 1.5 m (5 ft) of land surface have experienced little degradation where soil water saturation is less than 20%. Oil located 2–8 m (6.6–26 ft) below land surface in areas of higher recharge has been substantially degraded. The best explanation for the association between recharge and enhanced degradation seems to be increased downward transport of microbial growth nutrients to the oil body. This is supported by observations of greater microbial numbers at higher elevations in the oil body and significant decreases with depth in nutrient concentrations, especially phosphorus. Our results suggest that environmental effects may cause widely diverging degradation rates in the same spill, calling into question dating methods based on degradation state.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

B.A. Bekins, F. D. Hostettler, W.N. Herkelrath, G. N. Delin, E. Warren, H.I. Essaid. 2005. Progression of methanogenic degradation of crude oil in the subsurface. https://doi.org/10.1306/eg.11160404036

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Hypothetical CO2 leakage into, and hydrological plume management within, an underground source of drinking water at a proposed CO2 storage facility, Kemper County, Mississippi, USA

A large Geologic Carbon Sequestration (GCS) hub has been proposed in Kemper County, Mississippi. The target injection interval consists of numerous Cretaceous-aged deep saline aquifers overlain by a competent and extensive regional sealing layer. Above the seal, the deepest Underground Source of Drinking Water (USDW) at the site is the Eutaw aquifer of the Eutaw Group and McShan Formation, undifferentiated. To assess potential risks of leakage from the deep sequestration reservoir, a model of a portion of the Cretaceous Eutaw Group was constructed in this study. Simulations tested various permeabilities, hypothetical leakage rates, and plume mitigation strategies utilizing existing wells. Results suggest that, under the influence of regional groundwater flow fields, leaking CO 2 would effectively bypass the existing wells, and to influence this migration would require very large water extraction rates. Therefore, to ensure plume detection, monitoring for leakage at the injection wells themselves is very important.

Mississippi↗

Modeling geologic sequestration of carbon dioxide in a deep saline carbonate reservoir with TOUGH2–ChemPlugin, a new tool for reactive transport modeling

This paper outlines the development and demonstration of a new tool, TOUGH2–ChemPlugin (T2CPI) for predicting rock–water–CO 2 interaction following injection of supercritical CO 2 into a heterogeneous carbonate system. Specifically, modeling capabilities of TOUGH2, which examines multiphase flow and supercritical CO 2 behavior, were combined with the geochemical modeling capabilities of The Geochemist’s Workbench ® (GWB), using ChemPlugin TM . ChemPlugin is a self-linking re-entrant software object that, when coupled to a transport simulator, retains the flow and transport capabilities of the simulator but enables incorporation of reactive chemistry via GWB. To test and assess the capabilities of T2CPI, results from T2CPI simulations were compared to those of TOUGHREACT, using the same carbonate reservoir parameters (based on the Dollar Bay Formation of the South Florida Basin). Overall, results of simulations from TOUGHREACT and T2CPI were very similar for nearly all evaluated parameters. Dissimilarities between the two programs included qualitative differences in how TOUGHREACT and T2CPI predicted calcite dissolution and the subsequent spatial pattern of the porosity gain caused by how each handles evaporation of water near the injection point. The TOUGHREACT program is a proven, widely used tool for evaluating CO 2 –brine–rock interaction following supercritical CO 2 injection. The T2CPI tool offers similar capabilities and strengths of TOUGHREACT, with the ability to read in and use databases for a wide range of activity coefficient types. This program also has abilities to use a wide range of kinetic constraints, define those kinetic constraints with scripts or compiled libraries, account for colloidal transport, and/or account for a wide range of surface sorption models.

Florida↗

Groundwater salinity and the effects of produced water disposal in the Lost Hills-Belridge oilfields, Kern County, California

Increased oil and gas production in many areas has led to concerns over the effects these activities may be having on nearby groundwater quality. In this study we determine the lateral and vertical extent of groundwater with less than 10,000 milligrams per liter (mg/l) total dissolved solids (TDS) near the Lost Hills-Belridge oilfields in northwestern Kern County, California and document evidence of impacts by produced water disposal within the Tulare aquifer and overlying alluvium—the primary protected aquifers in the area. The depth at which groundwater salinity surpasses 10,000 mg/l ranges from 150 m (500 ft [ft]) in the northwestern part of the study area to 490 to 550 m (1,600-1,800 ft) in the south and east respectively as determined by geophysical log analysis and lab analysis of produced water samples. Comparison of logs from replacement wells with logs from their older counterparts shows relatively higher resistivity intervals representing the vadose zone or fresher groundwater being replaced by intervals with much lower resistivity due to infiltration of brines from surface disposal ponds and injection of brines into disposal wells. The effect of the surface ponds is confined to the alluvial aquifer—the underlying Tulare aquifer is largely protected by a regional clay layer at the base of the alluvium. Sand layers affected by injection of produced waters in nearby disposal wells often exhibit log resistivity profiles that change from high resistivity in their upper parts to low resistivity near the base due to stratification by gravity segregation of the denser brines within each affected sand. The effects of produced water injection are mainly evident within the Tulare Formation and can be noted as far as 550 m (1,800 ft) from the main group of disposal wells located along the east flank of South Belridge.

California↗