Geology Reports⌕ Search
Home/Archive/USGS

USGS · 70025222

Lead in the Getchell-Turquoise ridge Carlin-type gold deposits from the perspective of potential igneous and sedimentary rock sources in Northern Nevada: Implications for fluid and metal sources

R. M. Tosdal·J. S. Cline·C.M. Fanning·J. L. Wooden
View original source ↗Export metadata ↓

Abstract

Lead isotope compositions of bulk mineral samples (fluorite, orpiment, and realgar) determined using conventional techniques and of ore-stage arsenian pyrite using the Sensitive High Resolution Ion-Microprobe (SHRIMP) in the Getchell and Turquoise Ridge Carlin - type gold deposits (Osgood Mountains) require contribution from two different Pb sources . One Pb source dominates the ore stage. It has a limited Pb isotope range characterized by 208 Pb/ 206 Pb values of 2.000 to 2.005 and 207 Pb/ 206 Pb values of 0.8031 to 0.8075, as recorded by 10-μm-diameter spot SHRIMP analyses of ore-stage arsenian pyrite. These values approximately correspond to 206 Pb/ 204 Pb of 19.3 to 19.6, 207 Pb/ 204 Pb of 15.65 to 15.75, and 208 Pb/ 204 Pb of 39.2 to 39.5. This Pb source is isotopically similar to that in average Neoproterozoic and Cambrian elastic rocks but not to any potential magmatic sources . Whether those clastic rocks provided Pb to the ore fluid cannot be unequivocally proven because their Pb isotope compositions over the same range as in ore-stage arsenian pyrite are similar to those of Ordovician to Devonian siliciclastic and calcareous rocks. The Pb source in the calcareous rocks most likely is largely detrital minerals, since that detritus was derived from the same sources as the detritus in the Neoproterozoic and Cambrian clastic rocks. The second Pb source is characterized by a large range of 206 Pb/ 204 Pb values (18-34) with a limited range of 208 Pb/ 204 Pb values (38.1-39.5), indicating low but variable Th/U and high and variable U/Pb values. The second Pb source dominates late and postore-stage minerals but is also found in preore sulfide minerals. These Pb isotope characteristics typify Ordovician to Devonian siliciclastic and calcareous rocks around the Carlin trend in northeast Nevada . Petrologically similar rocks host the Getchell and Turquoise Ridge deposits . Lead from the second source was either contributed from the host sedimentary rock sequences or brought into the hydrothermal system by oxidized ground water as the system collapsed. Late ore- and postore-stage sulfide minerals (pyrite, orpiment, and stibnite) from the Betze-Post and Meikle deposits in the Carlin trend and from the Jerritt Canyon mining district have Pb isotope characteristics similar to those determined in Getchell and Turquoise Ridge . This observation suggests that the Pb isotope compositions of their ore fluids may be similar to those at Getchell and Turquoise Ridge . Two models can explain the Pb isotope compositions of the ore-stage arsenian pyrite versus the late ore or postore sulfide minerals. In either model, Pb from the Ordovician to Devonian siliciclastic and calcareous rock source enters the hydrothermal system late in the ore stage but not to any extent during the main stage of ore deposition. In one model, ore-stage Pb was derived from a source with Pb isotope compositions similar to those of the Neoproterozoic and Cambrian clastic sequence, transported as part of the ore fluid and then deposited in the ore-stage arsenian pyrite and fluorite. The second model is based on the observation that the Pb isotope characteristics of the ore-stage minerals also are found in some Ordovician to Devonian calcareous and siliciclastic rocks. Hence, ore-stage Pb could have been derived locally and simply concentrated during the ore stage. Critical to the second model is the removal of all high 206 Pb/ 204 Pb (>20) material during alteration. It Also requires the retention of only the low 206 Pb/ 204 Pb component of the Ordovician to Devonian sedimentary rocks. This critical step is possible only if the high 206 Pb/ 204 Pb values are contained in readily dissolvable mineral phases, whereas the low 206 Pb/ 204 Pb values are found only in refractory minerals that released Pb during a final alteration stage just prior deposition of auriferous arsenian pyrite. Distinguishing between Pb transported with the ore fluid or inherited from the site of mineral deposition is not straightforward; however, it is simpler to explain the Pb isotope compositions of ore-stage arsenian pyrite and fluorite in two different but spatially related Carlin - type deposits ( Getchell and Turquoise Ridge ) with different host rocks by input of Pb with the ore fluid . Once the limited Pb in the hydrothermal fluid was exhausted by incorporation in ore-stage arsenian pyrite or other ore-stage minerals, Pb from the second source , the Ordovician to Devonian sedimentary rock sequences, became available for incorporation in some but not all of the late-stage sulfide minerals.

Explore related subjects

Economic GeologyArticle
90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.91351257612758° to 42.00032514831621° latitude; -119.981689453125° to -114.027099609375° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R. M. Tosdal, J. S. Cline, C.M. Fanning, J. L. Wooden. 2003. Lead in the Getchell-Turquoise ridge Carlin-type gold deposits from the perspective of potential igneous and sedimentary rock sources in Northern Nevada: Implications for fluid and metal sources. https://doi.org/10.2113/gsecongeo.98.6.1189

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Origin of the Pd/Pt ratio of the J-M Reef, Stillwater Complex, Montana, USA

The J-M reef of the Stillwater Complex is characterized by a high Pd/Pt ratio (mean ~3.8 with a standard error of 0.03) with a homogeneous geospatial distribution at the deposit scale. In this contribution, we demonstrate that the Pd/Pt ratio of the reef is the product of equilibration of an immiscible sulfide liquid with a silicate melt rich in Pd relative to Pt. Despite the high tenors of the J-M reef sulfides (avg 2,700 ppm Pt and 770 ppm Pt), numerical modeling shows that the parental melts did not have extraordinary Pd and Pt concentrations. Instead, the initial composition of a plausible parental silicate melt can have Pd and Pt contents well within the expected range of a normal, mantle-derived partial melt (i.e., ~10–20 ppb for both Pd and Pt with Pd/Pt of ~1). The relative differences in the partitioning behavior of Pt and Pd between sulfide liquid and silicate melt are unlikely to produce a consistent Pd/Pt ratio across a wide range of silicate melt to sulfide liquid mass ratios (i.e., R factors). Instead, the pre-emplacement fractionation of Pt alloy from S-undersaturated silicate magma accounts for the homogeneous and high Pd/Pt ratio of the J-M reef. We show that batch equilibration of sulfide liquid with silicate melt can produce the high Pd/Pt ratios of the reef if the partition coefficients between sulfide liquid and silicate melt for Pd and Pt are extremely high (>10 6 ). In an alternative model, Pd enrichment could be achieved by sulfide upgrading in resident footwall mush even if the partition coefficients between sulfide liquid and silicate melt are relatively small (between 10 4 and 10 6 ) because the instantaneous mass ratio of silicate melt to sulfide liquid is small (R ≈ 100–700), so the partitioning behavior of Pt and Pd has little impact on the composition of sulfide liquid.

Montana↗
USGS2025

Depth of magma crystallization and fluid exsolution beneath the porphyry-skarn Cu deposits at Santa Rita and Hanover-Fierro, New Mexico, USA

The depth level at which porphyry Cu–forming magmas fractionated and exsolved mineralizing fluids is actively debated. In the classic model, extensive magma fractionation occurs in large, upper crustal magma chambers, and concomitant fluid exsolution leads to forceful expulsion of residual magmas in the form of porphyry dikes, stocks, and breccia pipes, which subsequently serve as pathways for the mineralizing fluids. In contrast, some recent studies highlighting the role of deep crustal magma fractionation in the production of fertile magmas essentially deny the existence of upper crustal magma chambers at the time of mineralization. To address this, we conducted a detailed thermobarometric investigation of 13 intermediate to felsic, porphyritic intrusive rocks related to porphyry-skarn Cu mineralization at Santa Rita and Hanover-Fierro, New Mexico, United States, representing two premineralization magmas (61–60 Ma), seven synmineralization magmas (60–58 Ma), and four late- to postmineralization magmas (58–57 Ma). For each sample, the pressure of last magma crystallization before final magma ascent to the current exposure level was reconstructed based on Al-in-hornblende barometry of small hornblende inclusions trapped within quartz phenocrysts and through titanium-in-quartz (TitaniQ) thermobarometry of the host quartz phenocrysts themselves. Since quartz is one of the last crystallizing magmatic minerals, and no significant phenocryst growth could have occurred in small dikes and stocks after final magma emplacement, quartz phenocrysts and their contained hornblende inclusions record the depth of last magma crystallization before final magma ascent. When present, hornblende phenocrysts and hornblende inclusions within other major phenocrysts were also analyzed. Both quartz and hornblende barometers return consistent average pressures of 3.2 ± 0.4 kbar for the entire suite of pre- to postmineralization magmas, corresponding to depths of 11 to 14 km. The synmineralization magmas return even more consistent average pressures of 3.1 ± 0.2 kbar, corresponding to a depth of 12 ± 1 km. The volume of the mineralizing porphyry dikes and stocks at the emplacement level is far too small to have provided all the fluids and metals required to form the observed ore deposits. Therefore, the majority of the ore-forming fluids must have originated from the magmas that crystallized at 12 ± 1 km depth. The ore deposits, conversely, formed at ~5-km paleodepth. This implies that most of the mineralizing fluids traveled an average vertical distance of ~7 km from their magmatic source to the eventual site of ore precipitation. The relatively unaltered nature and low veining degree of deeper parts of mineralized porphyry dikes and stocks suggest that the fluid transport through these intrusive bodies occurred mostly at near-solidus conditions by means of fluid percolation along grain boundaries. In summary, our results suggest that (1) a large, upper crustal pluton exists ~7 km beneath the Santa Rita and Hanover-Fierro deposits; (2) abundant phenocryst crystallization occurred at this depth level; and (3) this pluton was the main source for the exsolution of ore-forming fluids. However, the investigated rocks have elevated whole-rock Sr/Y ratios, indicating magma fractionation at deep crustal levels. As a result, our preferred model is a combination of the two end-member models introduced above, with most magma fractionation having occurred in the deep crust and with residual, intermediate to felsic melts having ascended and accumulated at 11 to 14 km paleodepth, where they continued to crystallize with comparatively little crystal-liquid separation, before some of these magmas ascended further to shallow levels and quenched to porphyries.

New Mexico↗
USGS2025

Assimilation of reduced carbon triggers platinum alloy saturation in mafic and ultramafic magmas

It is generally observed that magmatic sulfide ores have higher ratios of Pd/Pt than the mantle-like values of their parental magmas. This discrepancy has defied simple explanation because the partitioning behavior of both elements between sulfide and silicate liquids is very similar. Assimilation of sulfur- and carbon-rich country rocks by mafic and ultramafic magmas is considered a critical, if not essential, step in the formation of magmatic base metal sulfide deposits. Although there is general consensus that the assimilation of external sulfur and carbon promotes sulfide saturation, the effect of carbon assimilation on the solubilities of platinum-group elements in natural S-bearing silicate melt has been overlooked. In this study, we investigate the variations of platinum and palladium solubilities during assimilation of graphite and methane through thermodynamic modeling, in comparison with data from an array of highly distinctive magmatic sulfide ore systems representing ages from Archean to Paleozoic, melt compositions from komatiite to basalt, and magmatic settings including lavas, hypabyssal intrusions, plutonic continental arc roots, and plutonic layered intrusions, namely: Raglan, Norilsk-Talnakh, Lac des Iles, and the J-M Reef of the Stillwater Complex. We model assimilation-fractional crystallization processes to estimate the reduction of oxygen fugacity ( ⁠fO2⁠ ) of the melt due to incorporation of graphite and methane. The simulations show that although Pd remains highly soluble during the progressive assimilation of reduced carbon, Pt solubility decreases significantly as the silicate melt becomes increasingly reduced. With less than 8 % of sediment assimilation, Pt alloy may saturate and then deviate from sulfide-undersaturated silicate melts, concomitantly increasing the Pd/Pt value of the remaining melts of the Raglan and Norilsk-Talnakh systems. For the Lac des Iles and Stillwater systems, a higher extent of assimilation is needed to reach Pt saturation because of the relatively carbon-poor nature of the lower crustal rocks. The assimilation of methane volatiles is shown to be more effective than graphite assimilation, and it provides a pathway to Pt alloy fractionation in the absence of detectable amounts of bulk host-rock assimilation. High Pd/Pt values have been documented in many world-class magmatic sulfide deposits whose parental magmas have demonstrably experienced crustal contamination. Our model suggests that although anomalous Pd/Pt values may be explained by other mechanisms such as incongruent melting of preexisting sulfide or differences in the diffusivities of the metals within achieving equilibration, the assimilation of graphite or methane may play an important role in the global occurrence of magmatic sulfide ores with elevated Pd/Pt values.

Economic Geology↗