Geology Reports⌕ Search
Home/Archive/USGS

USGS · 70022904

New site coefficients and site classification system used in recent building seismic code provisions

R. Dobry·R. D. Borcherdt·C.B. Crouse·I.M. Idriss·W. B. Joyner·G. R. Martin·M.S. Power·E.E. Rinne·R.B. Seed
View original source ↗Export metadata ↓

Abstract

Recent code provisions for buildings and other structures (1994 and 1997 NEHRP Provisions, 1997 UBC ) have adopted new site amplification factors and a new procedure for site classification. Two amplitude-dependent site amplification factors are specified: F a for short periods and F v for longer periods. Previous codes included only a long period factor S and did not provide for a short period amplification factor. The new site classification system is based on definitions of five site classes in terms of a representative average shear wave velocity to a depth of 30 m (V¯ s ). This definition permits sites to be classified unambiguously. When the shear wave velocity is not available, other soil properties such as standard penetration resistance or undrained shear strength can be used. The new site classes denoted by letters A - E, replace site classes in previous codes denoted by S1 - S4. Site classes A and B correspond to hard rock and rock, Site Class C corresponds to soft rock and very stiff / very dense soil, and Site Classes D and E correspond to stiff soil and soft soil. A sixth site class, F, is defined for soils requiring site-specific evaluations. Both F a and F v are functions of the site class, and also of the level of seismic hazard on rock, defined by parameters such as A a and A v ( 1994 NEHRP Provisions ), S s and S l ( 1997 NEHRP Provisions ) or Z ( 1997 UBC ). The values of F a and F v decrease as the seismic hazard on rock increases due to soil nonlinearity. The greatest impact of the new factors F a and F v as compared with the old S factors occurs in areas of low-to-medium seismic hazard. This paper summarizes the new site provisions, explains the basis for them, and discusses ongoing studies of site amplification in recent earthquakes that may influence future code developments.

Explore related subjects

Earthquake SpectraArticle

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R. Dobry, R. D. Borcherdt, C.B. Crouse, I.M. Idriss, W. B. Joyner, G. R. Martin, M.S. Power, E.E. Rinne, R.B. Seed. 2000-02-01. New site coefficients and site classification system used in recent building seismic code provisions. https://doi.org/10.1193/1.1586082

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Accounting for biases in the analysis of building damage data for the 2023 M7.8 Türkiye/Syria earthquake sequence

In the aftermath of a large earthquake, several practical constraints affect the systematic collection of data for assessing building damage. The available data are therefore typically incomplete, frequently missing key information such as the type of construction, age and geographic location. Moreover, the observations often favour certain locations and damage grades. In the absence of robust methods, using such data directly for characterising the building stock or conducting fragility assessments can introduce systematic bias. Using the 2023 M7.8 Türkiye/Syria earthquake sequence as a case study, we propose a statistical model that enables joint inference over the inventory and fragility of the building stock while explicitly accounting for sources of data error and missing information. The results show higher-than-expected vulnerability amongst several building types, particularly mid- and high-rise reinforced concrete buildings, which performed extremely poorly during the 2023 earthquake sequence. The proposed Bayesian framework provides rigorous uncertainty quantification that can be propagated to future applications.

Earthquake Spectra↗
USGS2026

Development of liquefaction-targeted design basis in U.S. seismic provisions

Seismic design criteria for new buildings in the United States have historically focused on life safety performance objectives through minimizing the potential for structural collapse. Development of design criteria to meet this performance objective has evolved over time, leading to the current, risk-targeted maximum considered earthquake (MCE R ) design basis. Corresponding MCE R seismic design loads incorporate the full range of probabilistic ground motion hazard information available from U.S. Geological Survey National Seismic Hazard Models, as well as a representation of the uncertainty in structural collapse capacity. Despite these considerable advances in structural design criteria, guidelines for geotechnical hazards such as liquefaction-induced damage, which continue to be based on uniform ground-shaking hazard (i.e., MCE ground motions), are not well-connected with risk-based, collapse prevention performance objectives. This study, undertaken as part of Building Seismic Safety Council efforts to update recommended seismic provisions through the National Earthquake Hazards Reduction Program, presents probabilistic, liquefaction-targeted design objectives and corresponding ground motion parameters, with a focus on improving consistency in first-level screening criteria for liquefaction hazard assessment. This study identifies a potential maximum acceptable annualized probability of liquefaction triggering ( P L,max ) of 2.5% in 50 years, above which liquefaction consequences and potential mitigation measures would be considered. The P L,max -based design basis is calibrated to effective probabilistic liquefaction hazard levels obtained in practice using current MCE peak ground accelerations, and could be implemented via a new liquefaction-targeted maximum considered earthquake (MCE L ) peak ground acceleration ( PGA L ). The proposed PGA L is derived from probabilistic liquefaction hazard curves and includes uncertainties inherent to liquefaction hazard modeling. The potential design effects of the proposed PGA L are demonstrated via comparison with current MCE PGA levels, effects on first-level liquefaction screening analyses, and improvements in the consistency of P L,max levels across the United States, and for a wide range of site conditions.

conterminous United States↗
USGS2026

2025 USGS National Seismic Hazard Model for Puerto Rico and the U.S. Virgin Islands: Overview of model and hazard results

The U.S. Geological Survey recently updated the National Seismic Hazard Model (NSHM) for Puerto Rico and the U.S. Virgin Islands (PRVI). The first version of the PRVI NSHM was released in 2003, and therefore this 2025 update includes over 20 years of new geologic, geophysical, and engineering data, methods, and models. Updates follow similar efforts performed in the recent 2023 50-state NSHM. However, this is the first NSHM in which we: (1) apply an inversion methodology to subduction interface fault sources in the earthquake rupture forecast (ERF) model; (2) develop scaled backbone median ground-motion models and independent aleatory variability models that are applied in the ground-motion characterization (GMC) model; and (3) calculate epistemic uncertainty related to alternative scenarios in the ERF and GMC models for all grid points in the study region. Long-term time-independent mean hazard calculations were performed for peak ground acceleration and 5%-damped pseudospectral acceleration at 21 spectral periods from 0.01- to 10.0-s, for eight National Earthquake Hazards Reduction Program site conditions ranging from V S30 = 150 to 1500 m/s, and for 2%, 5%, and 10% in 50-year probabilities of exceedance (return periods of 2475, 975, and 475 years, respectively). Epistemic uncertainty, in the form of selected percentiles, is also provided for a suite of test sites and all grid points in the study region for limited periods, site conditions, and probabilities of exceedance. Selected results, including comparisons with the 2003 PRVI NSHM, are shown and discussed for selected periods, site conditions, and probabilities of exceedance. When comparing the 2025 PRVI NSHM with the 2003 PRVI NSHM, hazard is generally higher at shorter periods and lower at longer periods, as a result of updates in both ERF and GMC models. The 2025 PRVI NSHM is applicable for return periods greater than ∼475 or less than ∼10,000 years.

Puerto Rico, U.S. Virgin Islands↗