Geology ReportsSearch

USGS · 70020973

How good are estimates of transmissivity from slug tests in fractured rock?

Abstract

Slug tests in fractured rock usually are interpreted with models that assume homogeneous formation properties, even though hydraulic properties of fractures can vary by many orders of magnitude over the length of boreholes. To investigate the impact of heterogeneity on the interpretation of slug tests in fractured rock, slug tests were conducted over large intervals of boreholes in crystalline rock in central New Hampshire, and interpreted using a homogeneous model. The results of the slug tests were then compared with estimates of transmissivity from fluid-injection tests conducted over shorter intervals in the same boreholes. The fluid-injection tests showed transmissivity to vary more than six orders of magnitude over the length of the boreholes; however, the sum of the transmissivities from the fluid-injection tests were within an order of magnitude of the transmissivity estimated from the slug tests. Although the two estimates of transmissivity were within an order of magnitude of each other, the water level responses during the slug tests did not exactly match the responses predicted by the homogeneous model. To investigate the effect of heterogeneity on water level responses during slug tests, a Laplace-transform solution was developed for slug tests conducted in boreholes containing multiple fractures with hydraulic properties that vary over the length of the borehole. A comparison of this solution with the homogeneous model shows no difference between the shape of water level responses in a homogeneous formation and a (layered) heterogeneous formation. Furthermore, the transmissivity estimated using a homogeneous model is within an order of magnitude of the prescribed transmissivity in the heterogeneous model. Thus, differences between responses predicted from a homogeneous model and measured water levels during slug tests can be attributed to phenomena such as nonradial flow in the vicinity of the borehole, and not heterogeneous hydraulic properties over the length of the borehole. The experimental results of this investigation show that even when conditions such as nonradial flow are present in the vicinity of the borehole, interpretations of slug tests using a homogeneous model provided order-of-magnitude estimates of transmissivity in the crystalline rock terrane under consideration.Slug tests in fractured rock are usually interpreted with models that assume homogeneous formation properties, although hydraulic properties of fractures can vary by many order of magnitude over the length of the boreholes. To investigate the impact of heterogeneity on the interpretation of slug tests in fractured rocks, slug tests were conducted over large intervals of boreholes in crystalline rock in central New Hampshire. Tests results were interpreted using a homogeneous model. A Laplace-transform solution was developed for slug tests conducted in boreholes containing multiple fractures with hydraulic properties. Finally, a comparison was made between this solution and the homogeneous model.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

A.M. Shapiro, P. A. Hsieh. 2005-08-04. How good are estimates of transmissivity from slug tests in fractured rock?. https://doi.org/10.1111/j.1745-6584.1998.tb01063.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Evaluating micrometeorological estimates of groundwater discharge from Great Basin desert playas

Groundwater availability studies in the arid southwestern United States traditionally have assumed that groundwater discharge by evapotranspiration (ETg) from desert playas is a significant component of the groundwater budget. However, desert playa ETg rates are poorly constrained by Bowen Ratio energy budget (BREB) and eddy-covariance (EC) micrometeorological measurement approaches. Best attempts by previous studies to constrain ETg from desert playas have resulted in ETg rates that are within the measurement error of micrometeorological approaches. This study uses numerical models to further constrain desert playa ETg rates that are within the measurement error of BREB and EC approaches, and to evaluate the effect of hydraulic properties and salinity-based groundwater-density contrasts on desert playa ETg rates. Numerical models simulated ETg rates from desert playas in Death Valley, California and Dixie Valley, Nevada. Results indicate that actual ETg rates from desert playas are significantly below the uncertainty thresholds of BREB- and EC-based micrometeorological measurements. Discharge from desert playas likely contributes less than 2 percent of total groundwater discharge from Dixie and Death Valleys, which suggests discharge from desert playas also is negligible in other basins. Simulation results also show that ETg from desert playas primarily is limited by differences in hydraulic properties between alluvial fan and playa sediments and, to a lesser extent, by salinity-based groundwater density contrasts.

Ground Water

A semi-structured MODFLOW-USG model to evaluate local water sources to wells for decision support

In order to better represent the configuration of the stream network and simulate local groundwater-surface water interactions, a version of MODFLOW with refined spacing in the topmost layer was applied to a Lake Michigan Basin (LMB) regional groundwater-flow model developed by the U.S. Geological. Regional MODFLOW models commonly use coarse grids over large areas; this coarse spacing precludes model application to local management issues (e.g., surface-water depletion by wells) without recourse to labor-intensive inset models. Implementation of an unstructured formulation within the MODFLOW framework (MODFLOW-USG) allows application of regional models to address local problems. A “semi-structured” approach (uniform lateral spacing within layers, different lateral spacing among layers) was tested using the LMB regional model. The parent 20-layer model with uniform 5000-foot (1524-m) lateral spacing was converted to 4 layers with 500-foot (152-m) spacing in the top glacial (Quaternary) layer, where surface water features are located, overlying coarser resolution layers representing deeper deposits. This semi-structured version of the LMB model reproduces regional flow conditions, whereas the finer resolution in the top layer improves the accuracy of the simulated response of surface water to shallow wells. One application of the semi-structured LMB model is to provide statistical measures of the correlation between modeled inputs and the simulated amount of water that wells derive from local surface water. The relations identified in this paper serve as the basis for metamodels to predict (with uncertainty) surface-water depletion in response to shallow pumping within and potentially beyond the modeled area, see Fienen et al. (2015a).

Illinois, Indiana, Michigan, Wisconsin

Extending the MODPATH algorithm to rectangular unstructured grids

The recent release of MODFLOW-USG, which allows model grids to have irregular, unstructured connections, requires a modification of the particle-tracking algorithm used by MODPATH. This paper describes a modification of the semi-analytical particle-tracking algorithm used by MODPATH that allows it to be extended to rectangular-based unstructured grids by dividing grid cells with multi-cell face connections into sub-cells. The new method will be incorporated in the next version of MODPATH which is currently under development.

Ground Water