Geology Reports⌕ Search

USGS · 70019684

Shallow seismic reflection profiles and geological structure in the Benton Hills, southeast Missouri

Abstract

During late May and early June of 1993, we conducted two shallow, high-resolution seismic reflection surveys (Mini-Sosie method) across the southern escarpment of the Benton Hills segment of Crowleys Ridge. The reflection profiles imaged numerous post-late Cretaceous faults and folds. We believe these faults may represent a significant earthquake source zone. The stratigraphy of the Benton Hills consists of a thin, less than about 130 m, sequence of mostly unconsolidated Cretaceous, Tertiary and Quaternary sediments which unconformably overlie a much thicker section of Paleozoic carbonate rocks. The survey did not resolve reflectors within the upper 75-100 ms of two-way travel time (about 60-100 m), which would include all of the Tertiary and Quaternary and most of the Cretaceous. However, the Paleozoic-Cretaceous unconformity (Pz) produced an excellent reflection, and, locally a shallower reflector within the Cretaceous (K) was resolved. No coherent reflections below about 200 ms of two-way travel time were identified. Numerous faults and folds, which clearly offset the Paleozoic-Cretaceous unconformity reflector, were imaged on both seismic reflection profiles. Many structures imaged by the reflection data are coincident with the surface mapped locations of faults within the Cretaceous and Tertiary succession. Two locations show important structures that are clearly complex fault zones. The English Hill fault zone, striking N30??-35??E, is present along Line 1 and is important because earlier workers indicated it has Pleistocene Loess faulted against Eocene sands. The Commerce fault zone striking N50??E, overlies a major regional basement geophysical lineament, and is present on both seismic lines at the southern margin of the escarpment. The fault zones imaged by these surveys are 30 km from the area of intense microseismicity in the New Madrid seismic zone (NMSZ). If these are northeast and north-northeast oriented fault zones like those at Thebes Gap they are favorably oriented in the modern stress field to be reactivated as right-lateral strike slip faults. Currently, earthquake hazards assessments are most dependent upon historical seismicity, and there are little geological data available to evaluate the earthquake potential of fault zones outside of the NMSZ. We anticipate that future studies will provide evidence that seismicity has migrated between fault zones well beyond the middle Mississippi Valley. The potential earthquake hazards represented by faults outside the NMSZ may be significant.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 35.601883720748646° to 38.063615458112764° latitude; -91.69869689609834° to -88.8422515835983° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

J. R. Palmer, D. Hoffman, W. J. Stephenson, J. K. Odum, R. A. Williams. 1997. Shallow seismic reflection profiles and geological structure in the Benton Hills, southeast Missouri. https://doi.org/10.1016/s0013-7952(97)00004-5

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Sackung at Bald Eagle ridge, central Colorado: An updated interpretation of ridge-spreading movement, structures, and mechanisms from 50 years (1975–2025) of U.S. Geological Survey research

Slow gravitational failures of mountain peaks and ridges are poorly understood. Herein, we report on 50 years of studies at a slowly spreading castellate ridge in the Sawatch Range in central Colorado. The orientations of geomorphic-structural features indicate that the fractured Precambrian granitic rock underlying the ridge has extended and spread northwestward toward the formerly glacier-covered Busk Creek valley. Results from surveying, field-based geomorphic-structural mapping using lidar, rock mass quality measurements, a passive seismic survey, and satellite radar provide a major update to research started by U.S. Geological Survey researchers in the 1970s and 1980s. New insights include a recognition that the entire ridge has slowly moved by concurrent sliding along an inferred northwest dipping, compound basal-slip surface (or zone), and through the formation of multiple grabens by normal faulting and flexural toppling along sets of pre-existing fractures that dip moderately (∼45°) to the southeast. We were unable to distinguish the presence of a sudden and strong contrast in seismic velocity across the inferred slip surface. Movement during the 50-year study period has been episodic and gradually decreasing, in correspondence with decreasing cumulative annual precipitation and increasing mean annual air temperatures. The fastest moving area, just upslope from the glacier trimline, had an average horizontal velocity of 3 – 4 mm/yr. Evidence suggests that movement started as a paraglacial response mechanism, but because of the site’s proximity to the Rio Grande Rift, we cannot exclude earthquake shaking as a mechanism for initiation or enhancement of slope movement. An estimate of longer-term horizontal movement from the exposed basal-slip surface at the uphill side of the ridgetop graben is ∼1.1 mm/yr for the 13 – 14 ky post-glacial period. Broad implications of our work are that: (1) long-term measurements (decades or longer) of slope movement can add insights into how sackungen form and evolve through time; (2) the identification of thrust faults and toes in zones of compression near valley bottoms can be crucial for interpreting sackung failure mechanisms, and (3) the use of passive-seismic techniques to identify the depth to a slip surface may not be successful in granitic terrain dominated by planar fractures and subtle changes in rock-mass characteristics.

Colorado↗

From landslide susceptibility to risk assessment in the conterminous U.S.

Understanding the spatial distribution of landslide prone-areas and what consequences they may have is important for risk management and land-use planning. In the United States, although landslides occur in every state, a comprehensive landslide risk assessment is still missing. Existing efforts, such as the Federal Emergency Management Agency (FEMA)’s National Risk Index, rely on aggregated products and coarse cartographic units, limiting their geomorphological and practical accuracy. In this study, we present a methodological advance for landslide risk assessment across large areas with incomplete and sparse data. We apply our procedures to the conterminous United States by integrating geomorphologically meaningful partitions and spatial and temporal probability data-driven models. Landslide susceptibility is estimated using a Generalized Additive Mixed Model incorporating a bias capture/correction scheme to account for inventory inaccuracies (reference Area Under the Curve = 0.75). The exceedance probabilities of landslide occurrence are defined for three temporal scenarios (2, 5, and 10 year). Then, we explore the associated potential economic consequences for human settlements and agricultural areas. The findings indicate that the spatial variability of risk is primarily controlled by exposure rather than by susceptibility/hazard alone. The mean risk increases by ∼170% from the 2-year to the 10-year scenario. Beyond its quantitative outcomes, this study offers a blueprint for continental or sub-continental scale landslide risk assessments, demonstrating both the opportunities and current limitations.

Engineering Geology↗

Global patterns of coseismic landslide runout mobility differ from aseismic landslide trends

Coseismic landslides significantly contribute to human and economic losses during and immediately following earthquakes, yet very little data on the runout of such landslides exist. While well-established behavior of aseismic (e.g., hydrologically triggered) landslide runout mobility suggests strong correlation between landslide size and mobility, limited studies of coseismic landslide runout find conflicting mobility trends. We present a global dataset of runout lengths produced from a new automated method for estimating landslide runout, developed and validated using 1726 manually mapped landslides from five unique earthquakes. We then apply the automated runout tool to 23 global earthquake-induced landslide inventories, producing a compiled database of 73,665 measured and estimated runout lengths of coseismic landslides to assess mobility trends. We find a significant divergence between well-established aseismic mobility trends and that of coseismic landslides, with far greater scatter and more complex mobility patterns in earthquake-triggered landslides. As a function of landslide size, we observe global coseismic landslide mobility patterns are bilinear, becoming increasingly less mobile with increasing size above some threshold. This discordance between aseismic and coseismic landslide mobility may be a function of landslide type, kinematics, hydrology, and or setting that systematically differ between triggering mechanisms and should be explored in more depth to develop predictive models of these unique runout patterns. These results suggest hazard and risk models for coseismic landslides may significantly under-predict or over-predict impacts, depending on the size of triggered landslides.

Engineering Geology↗