Geology Reports⌕ Search

USGS · 70019342

Directional topographic site response at Tarzana observed in aftershocks of the 1994 Northridge, California, earthquake: Implications for mainshock motions

Abstract

The Northridge earthquake caused 1.78 g acceleration in the east-west direction at a site in Tarzana, California, located about 6 km south of the mainshock epicenter. The accelerograph was located atop a hill about 15-m high, 500-m long, and 130-m wide, striking about N78°E. During the aftershock sequence, a temporary array of 21 three-component geophones was deployed in six radial lines centered on the accelerograph, with an average sensor spacing of 35 m. Station C00 was located about 2 m from the accelerograph. We inverted aftershock spectra to obtain average relative site response at each station as a function of direction of ground motion. We identified a 3.2-Hz resonance that is a transverse oscillation of the hill (a directional topographic effect). The top/base amplification ratio at 3.2 Hz is about 4.5 for horizontal ground motions oriented approximately perpendicular to the long axis of the hill and about 2 for motions parallel to the hill. This resonance is seen most strongly within 50 m of C00. Other resonant frequencies were also observed. A strong lateral variation in attenuation, probably associated with a fault, caused substantially lower motion at frequencies above 6 Hz at the east end of the hill. There may be some additional scattered waves associated with the fault zone and seen at both the base and top of the hill, causing particle motions (not spectral ratios) at the top of the hill to be rotated about 20° away from the direction transverse to the hill. The resonant frequency, but not the amplitude, of our observed topographic resonance agrees well with theory, even for such a low hill. Comparisons of our observations with theoretical results indicate that the 3D shape of the hill and its internal structure are important factors affecting its response. The strong transverse resonance of the hill does not account for the large east-west mainshock motions. Assuming linear soil response, mainshock east-west motions at the Tarzana accelerograph were amplified by a factor of about 2 or less compared with sites at the base of the hill. Probable variations in surficial shear-wave velocity do not account for the observed differences among mainshock acceleration observed at Tarzana and at two different sites within 2 km of Tarzana.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 34.06972475691634° to 34.264026473152875° latitude; -118.46145629882811° to -117.89566040039062° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

P. Spudich, M. Hellweg, W.H.K. Lee. 1996-02-01. Directional topographic site response at Tarzana observed in aftershocks of the 1994 Northridge, California, earthquake: Implications for mainshock motions. https://doi.org/10.1785/bssa08601bs193

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Re-evaluation of shaking, dynamic strain, and the source of the 1886 Charleston, South Carolina, earthquake

As the largest historical event in the eastern United States, the 1886 Charleston, South Carolina, earthquake, plays a prominent role in our nation’s seismological and human history and an outsized role in our probabilistic ground‐motion hazard estimates, affecting building codes, insurance rates, and geophysical monitoring. Thus, constraining the characteristics of the 1886 earthquake source, as well as the nature of its shaking distribution and impacts to the extent possible, is essential. Given its vintage, however, societal, geological, and geophysical datasets are limited compared with those used in modern seismological analyses. Because of these limitations, some characteristics of the rupture model are fundamentally nonunique. Still, by re‐evaluating all available data, I can constrain several key aspects of this earthquake. I show that several interpretations in recent analyses are inconsistent regarding the inferred source; shaking; ground failure; and, particularly, railway impacts. Importantly, I have shown that although dynamic strain caused the ground failure that led to track deformation, without the intermediate liquefaction step, dynamic strain alone was unlikely to be the source of rail deformation, contrary to earlier studies. Had earlier pronouncements that dynamic strain is a real concern for bending railways held true, there would be serious ramifications for railway engineering as well as for other above‐ and below‐ground linear infrastructure.

South Carolina↗

ETAS-positive: Extracting unbiased epidemic-type aftershock models from incomplete earthquake catalogs

Earthquake catalogs are inherently incomplete, and short-term fluctuations in catalog completeness can strongly bias estimates of seismicity parameters. Here, we extend the positive statistics framework recently introduced for estimating Gutenberg–Richter a and b values to the Epidemic-Type Aftershock Sequence (ETAS) model. The approach focuses on complete magnitude–time intervals defined by pairs of earthquakes in which the second event is larger than the first. Comprehensive synthetic tests demonstrate that the proposed ETAS + method retrieves nearly unbiased parameter estimates even from highly incomplete catalogs, whereas parameters obtained using classical estimation approaches are strongly biased. Application to Southern California reveals a similar trend, with the productivity scaling parameter α approaching the b value, consistent with self-similar earthquake triggering within estimation uncertainties. Owing to its robustness against catalog incompleteness and computational efficiency, the ETAS + method provides a powerful new tool for seismicity analysis and earthquake forecasting.

California↗