Site response for urban Los Angeles using aftershocks of the Northridge earthquake

S. Hartzell; A. Leeds; A. Frankel; J. Michael

doi:10.1785/bssa08601bs168

Home/Archive/USGS

USGS · 70018750

Site response for urban Los Angeles using aftershocks of the Northridge earthquake

S. Hartzell·A. Leeds·A. Frankel·J. Michael

View original source ↗Export metadata ↓

Abstract

Ground-motion records from aftershocks of the 1994 Northridge earthquake are used to estimate site response in the urban Los Angeles area. Over 1300 shear-wave records from 61 sources and 90 sites are used in a linear inversion for source and site-response spectra. The methodology makes no assumptions about the shape of the source spectrum. To obtain a stable unique inverse, a Q model and geometrical spreading factor are assumed. In addition, the site response at a hard-rock site is constrained to be approximately 1.0 with a kappa of 0.02. The site-response spectra compare favorably with the results of previous and on-going investigations in Los Angeles. A couple of first-order effects are lower site response in the surrounding mountains, dominated by Mesozoic and Tertiary rocks, and higher values in the San Fernando and Los Angeles Basins, containing surficial Pleistocene and Holocene alluvial deposits. Results show good correlation of high site-response spectral values with localized areas of severe damage (Interstate 10 collapse, Sherman Oaks, Northridge, Interstate 5/14 collapse). However, widespread trends in site response across the sedimentary basins are not obvious. The data suggest that site responses are lower near the southern margin of the San Fernando Valley for sources to the north, due to north-dipping sedimentary structures. But the general pattern of site response is characterized by high variability on length scales less than a kilometer. Variations of a factor of 2 in site response are observed over the length scale of 200 m and for the same surficial geologic unit. For some of the alluvial basin sites, surface-wave generation is a significant contributor to elevated site response at lower frequencies, below 2 Hz. The total damage pattern for the Northridge earthquake is influenced by strong source directivity to the north and strong local site effects. The correlation of weak-motion site-response estimates with areas of significant damage demonstrates the value of these field measurements in future urban planning and in the reduction of seismic risk in urban areas.

Explore related subjects

Bulletin of the Seismological Society of America Article

Source-reported bounding extent: 34.06588582938505° to 34.37494950877914° latitude; -118.74982569761517° to -118.22690475554941° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

S. Hartzell, A. Leeds, A. Frankel, J. Michael. 1996-02-01. Site response for urban Los Angeles using aftershocks of the Northridge earthquake. https://doi.org/10.1785/bssa08601bs168

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Efficient physics‐informed ground‐motion simulations with reduced‐order models: CyberShake implications and high‐resolution site terms for southern San Andreas fault earthquakes

Recent advances in Probabilistic Seismic Hazard Analysis (PSHA) leverage physics‐based ground‐motion simulations to estimate seismic hazard, such as the CyberShake project. However, computational costs quickly escalate when performing PSHA for numerous faults or sites and can become prohibitively expensive. To reduce computational demands, CyberShake uses reciprocity and interpolates physics‐informed corrections from simulations conducted at fewer locations, but the accuracy of these interpolations remains poorly quantified. To quantify the interpolation accuracy, we derive high‐resolution, frequency‐dependent site terms for southern California and compare them with interpolated site terms using the CyberShake approach. We accomplish this by performing a set of earthquake point‐source simulations distributed along the nonplanar fault geometry for the southern San Andreas fault (SSAF) extending from Bombay Beach to Lake Hughes. Using SeisSol, we simulate three minutes of viscoelastic seismic wave propagation for these sources and store the horizontal‐component Green’s functions for 480,000 sites. We then use a scientific machine learning approach based on interpolated proper orthogonal decomposition to construct an accurate reduced‐order model of the Green’s functions to efficiently predict effective amplitude spectra (EAS) for finite‐source rupture models of SSAF earthquakes. Using minimum curvature interpolation with tension, as used in CyberShake, we compare the interpolated site terms against our high‐resolution site terms. We identify local discrepancies with EAS differing by up to a factor of approximately three. Furthermore, we identify locations where unexpectedly high or low ground motions are missed when using the interpolated dataset for these earthquakes. We estimate that our approach may be used within CyberShake to reduce the time‐to‐solution by a factor of 336 for the entire earthquake rupture forecast. Our analysis of physics‐based site terms provides more insight into the seismic hazard due to SSAF ruptures and guides future developments by combining high‐performance computing and reduced‐order modeling techniques for PSHA.

California↗

USGS2026

Simulation-based scenario ShakeMaps for large magnitude (MW6.5+) crustal earthquakes on the Seattle, Tacoma, and southern Whidbey Island faults, Washington, USA

Scenario ground‐motion maps based on empirical ground‐motion models (GMMs) provide a rapid and generally reliable means of estimating the amplitude and distribution of earthquake shaking. However, because GMMs are designed for broad applicability, they often rely on simplified representations of Earth structure, which can limit their accuracy in regions with complex source, path, and site effects. This can substantially impact the accuracy of predicted shaking in areas like western Washington State, where deep, interconnected basin structure exerts a strong influence on seismic‐wave propagation. In this study, we present a new suite of simulation‐based scenario ShakeMaps that characterize ground shaking from large‐magnitude ( ⁠ M W 6.5–7.5) earthquakes on the Seattle, Tacoma, and southern Whidbey Island faults. These maps are developed using results from recent 3D wave propagation simulations ( Stone et al. , 2022 , 2023 , 2025 ) that incorporate realistic rupture geometries, variable slip distributions, and a regional 3D seismic velocity model with shallow soils. Broadband ground motions are estimated by combining the low‐frequency (<1 Hz) deterministic seismograms from these studies with high‐frequency (1–10 Hz) stochastic seismograms. Simulated ground motions are corrected to account for the enforced minimum shear‐wave velocity and nonlinear site response. The resulting ShakeMaps represent median ground‐shaking estimates derived from multiple rupture scenarios with varying slip distributions and hypocenter locations for each fault. To extend ShakeMap coverage beyond the simulation domain (i.e., into eastern Washington, northern Oregon, and southwestern British Columbia), we scale GMM‐based ground‐motion estimates using amplification patterns observed in the simulations. These new ShakeMaps reveal the substantial influence of deep basin structure on shaking intensity, underscoring the importance of considering crustal structure complexity in regional hazard assessments for the Pacific Northwest.

Washington↗

USGS2026

Testing characteristic magnitude distributions in modern PSHA models

The characteristic magnitude distribution hypothesis predicts a higher rate of large earthquakes than a Gutenberg–Richter extrapolation of the small‐earthquake rate would imply. Characteristic magnitude distributions have been commonly applied to faults in probabilistic seismic hazard analysis (PSHA), and in modern models they can emerge from the way short‐term seismicity constraints are combined with long‐term geologic and geodetic constraints. We test the characteristic magnitude distribution hypothesis by comparing the fault‐based magnitude distributions from the 2023 update to the National Seismic Hazard Model (NSHM23) in the Western United States with observed seismicity over the past 93 yr. We find that observed magnitude distributions fall outside the model‐predicted confidence bounds in regions where NSHM23 produces characteristic magnitude distributions: in these regions, the model predicts higher rates of large earthquakes than are observed. An analysis of the earlier California model (Uniform California Earthquake Rupture Forecast, version 3) also reveals discrepancies between the modeled and observed magnitude distributions. In addition, we find that observed magnitude distributions near modeled faults are not significantly different from those in background regions. These results challenge the prevalence of characteristic magnitude distributions in fault‐based seismic hazard models and call for a reassessment of how disparate data sets are integrated in PSHA.

western United States↗